2013 JEEP WRANGLER high beam

WARNING!(Continued)
•Check mounting of mats on a regular basis. Always
properly reinstall and secure floor mats that have
been removed for cleaning.
• Always make sure that objects cannot fall into the
driver footwell while the vehicle is moving. Ob-
jects can become trapped under the brake pedal
and accelerator pedal causing a loss of vehicle
control.
• If required, mounting posts must be properly in-
stalled, if not equipped from the factory.
Failure to properly follow floor mat installation or
mounting can cause interference with the brake
pedal and accelerator pedal operation causing loss of
control of the vehicle.
Periodic Safety Checks You Should Make Outside
The Vehicle
Tires
Examine tires for excessive tread wear and uneven wear
patterns. Check for stones, nails, glass, or other objects
lodged in the tread or sidewall. Inspect the tread for cuts
and cracks. Inspect sidewalls for cuts, cracks and bulges.
Check the wheel nuts for tightness. Check the tires
(including spare) for proper cold inflation pressure.
Lights
Have someone observe the operation of brake lights and
exterior lights while you work the controls. Check turn
signal and high beam indicator lights on the instrument
panel.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 103

▫Replacing The Rear Seat — Two-Door
Models ........................... .165
▫ 60/40 Split Folding Rear Seat — Four-Door
Models ........................... .165
 TO OPEN AND CLOSE THE HOOD .........167
 LIGHTS ............................ .168
▫ Multifunction Lever ....................168
▫ Headlights And Parking Lights ............169
▫ Automatic Headlights — If Equipped .......170
▫ Turn Signals ........................ .171
▫ Lane Change Assist ...................171
▫ Lights-On Reminder ...................171
▫ High/Low Beam Switch .................172
▫ Flash-To-Pass ....................... .172▫
Front Fog Lights ..................... .172
▫ Instrument Panel Dimmer ...............172
▫ Daytime Running Lights — If Equipped .....173
▫ Interior Lights ...................... .173
 WINDSHIELD WIPERS AND WASHERS ......176
▫ Windshield Wiper Operation .............177
▫ Intermittent Wiper System ...............177
▫ Windshield Washers ....................178
▫ Mist Feature ........................ .179
 TILT STEERING COLUMN ...............179
 ELECTRONIC SPEED CONTROL — IF
EQUIPPED .......................... .180
▫ To Activate ......................... .181
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 107

High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the lever toward you, to
switch the headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will turn on the high beams headlights until the lever is
released.
Front Fog Lights
The front fog light switch is located on the multi-
function lever. To activate the front fog lights, turn
on the parking or low beam headlights and pull out the
end of the lever. NOTE:
The fog lights will only operate with the parking
lights or the headlights on low beam. Selecting high
beam headlights will turn off the fog lights.
Instrument Panel Dimmer
Rotate the center portion of the lever to the extreme
bottom position to fully dim the instrument panel lights
and prevent the interior lights from illuminating when a
door is opened.
Rotate the center portion of the lever up to increase the
brightness of the instrument panel lights when the park-
ing lights or headlights are on.
Rotate the center portion of the lever upward to the next
detent position to brighten the odometer and radio when
the parking lights or headlights are on.
172 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

7. Seat Belt Reminder LightWhen the ignition switch is first turned to ON/
RUN, this light will turn on for four to eight
seconds as a bulb check. During the bulb check, if
the driver’s seat belt is unbuckled, a chime will sound.
After the bulb check or when driving, if the driver seat
belt remains unbuckled, the Seat Belt Reminder Light
will flash or remain on continuously. Refer to “Occupant
Restraints” in “Things To Know Before Starting Your
Vehicle” for further information.
8. Turn Signal Indicators
The left or right arrow will flash with the corre-
sponding exterior turn signal lights when the turn
signal lever is operated. A chime will sound if the vehicle is
driven more than 1 mile (1.6 km) with either turn signal on.
NOTE: If either indicator flashes at a rapid rate, check
for a defective outside light bulb. 9. Oil Pressure Warning Light
This light indicates low engine oil pressure. The
light should turn on momentarily when the engine is
started; if the bulb does not come on, have the system
checked by an authorized dealer. If the light turns on
while driving, stop the vehicle and shut off the engine as
soon as possible. A chime will sound when this light
turns on.
Do not operate the vehicle until the cause is corrected.
This light does not indicate how much oil is in the engine.
The engine oil level must be checked under the hood.
10. High Beam Indicator
This indicator shows that the high beam head-
lights are on. Push the multifunction control lever
away from you to switch the headlights to high beam.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 305

Pull the lever toward you to switch the headlights back to
low beam. If the driver’s door is open, and the headlights
or park lights are left on, the high beam indicator light
will remain illuminated and a chime will sound.
11. Brake Warning LightThis light monitors various brake functions,
including brake fluid level and parking brake
application. If the brake light turns on it may
indicate that the parking brake is applied, that
the brake fluid level is low, or that there is a problem with
the anti-lock brake system reservoir.
If the light remains on when the parking brake has been
disengaged, and the fluid level is at the full mark on the
master cylinder reservoir, it indicates a possible brake
hydraulic system malfunction or that a problem with the
Brake Booster has been detected by the Anti-Lock Brake
System (ABS) / Electronic Stability Control (ESC) system. In this case, the light will remain on until the condition
has been corrected. If the problem is related to the brake
booster, the ABS pump will run when applying the brake
and a brake pedal pulsation may be felt during each stop.
The dual brake system provides a reserve braking capac-
ity in the event of a failure to a portion of the hydraulic
system. A leak in either half of the dual brake system is
indicated by the Brake Warning Light, which will turn on
when the brake fluid level in the master cylinder has
dropped below a specified level.
The light will remain on until the cause is corrected.
NOTE:
The light may flash momentarily during sharp
cornering maneuvers, which change fluid level condi-
tions. The vehicle should have service performed, and
the brake fluid level checked.
If brake failure is indicated, immediate repair is necessary.
306 UNDERSTANDING YOUR INSTRUMENT PANEL

Gasoline............................. .513
Gauge .............................. .304
Materials Added ....................... .515
Methanol ............................ .514
Octane Rating ......................... .513
Requirements ......................... .513
Tank Capacity ......................... .618
Fueling ............................... .517
Fuses ................................. .607
Gas Cap (Fuel Filler Cap) ...................517
Gasoline, Clean Air ....................... .513
Gasoline (Fuel) .......................... .513
Gasoline, Reformulated .....................513
Gauges Coolant Temperature .....................309
Fuel ................................ .304
Odometer ............................ .312
Speedometer ......................... .304Tachometer
........................... .308
Gear Ranges ............................ .419
Gear Select Lever Override ..................562
General Information ........................21
Glass Cleaning .......................... .603
Gross Axle Weight Rating ...................523
Gross Vehicle Weight Rating ..................522
GVWR ................................ .520
Hands-Free Phone (Uconnect®) ...............115
HardTop.............................. .206
Hard Top, Modular ....................... .206
Hard Top Removal ....................... .214
Hazard Warning Flasher ....................546
Headlights Automatic ........................... .170
Bulb Replacement ...................... .615
High Beam ........................... .172
High Beam/Low Beam Select Switch .........172
650 INDEX

Passing............................. .172
Replacing ............................ .615
Switch .............................. .169
Head Restraints ......................... .162
Heated Mirrors ...........................114
Heated Seats ............................ .160
Heater ................................ .395
Heater, Engine Block ...................... .418
High Beam Indicator ...................... .305
Hill Descent Control ...................... .474
Hill Descent Control Indicator ................474
Hill Start Assist .......................... .463
Hitches Trailer Towing ........................ .525
Hood Release ........................... .167
Ignition .................................15
Key..................................15
Ignition Key Removal .......................15 Illuminated Entry
..........................23
Immobilizer (Sentry Key) ....................18
Infant Restraint ...........................75
Inflation Pressure Tires .....................489
Information Center, Vehicle ..................325
Inside Rearview Mirror .....................111
Instrument Cluster ....................... .303
Instrument Panel and Controls ................302
Instrument Panel Lens Cleaning ...............604
Integrated Power Module (Fuses) ..............607
Interior Appearance Care ....................603
Interior Lights .......................... .173
Intermittent Wipers (Delay Wipers) .............177
Introduction ..............................4
Inverter, Power .......................... .188
Jacking Instructions ....................... .550
Jack Location ........................... .548
10
INDEX 651

Hazard Warning Flasher..................546
Headlights ........................... .169
Headlight Switch ...................... .169
High Beam ........................... .305
High Beam Indicator .....................305
Hill Descent Control Indicator ..............474
Illuminated Entry ........................23
Instrument Cluster ..................... .169
Interior ............................. .173
Lights On Reminder .....................171
Low Fuel ............................ .304
Oil Pressure .......................... .305
Passing ............................. .172
Rear Servicing ........................ .617
Rear Tail ............................ .617
Seat Belt Reminder ..................... .305
Security Alarm (Theft Alarm) ...............309
Service .............................. .615
Side Marker .......................... .617Theft Alarm (Security Alarm)
...............309
Tire Pressure Monitoring (TPMS) ............310
Traction Control ....................... .472
Turn Signal .......................... .103
Voltage ............................. .304
Warning (Instrument Cluster Description) ......304
Loading Vehicle ......................... .519
Tires ............................... .482
Locking Axle ........................... .438
Locks ..................................38
Automatic Door .........................41
Child Protection .........................42
Door .................................38
Power Door ............................40
Steering Wheel ..........................17
Lubrication, Body ........................ .582
Maintenance Free Battery ....................577
Maintenance Procedures ....................573
10
INDEX 653