2013 JEEP GRAND CHEROKEE ignition

CAUTION!
Do not use sling type equipment when towing.
When securing the vehicle to a flat bed truck, do not
attach to front or rear suspension components. Dam-
age to your vehicle may result from improper towing.
Without The Key Fob
Special care must be taken when the vehicle is towed
with the ignition in the LOCK/OFF position. The only
approved method of towing without the key fob is with
a flatbed truck. Proper towing equipment is necessary to
prevent damage to the vehicle.
Two-Wheel Drive Models
The manufacturer recommends towing your vehicle with
all four wheelsOFFthe ground using a flatbed.If flatbed equipment is not available, and the transmis-
sion is operable, the vehicle may be towed (with rear
wheels on the ground) under the following conditions:
•The transmission must be in NEUTRAL.
•The towing speed must not exceed 30 mph (48 km/h).
•The towing distance must not exceed 15 miles (24 km)
for 6-speed transmission, or 30 miles (48 km) for
8-speed transmission.
If the transmission is not operable, or the vehicle must be
towed faster than 30 mph (48 km/h) or farther than
15 miles (24 km), for 6-speed transmission, or 30 miles
(48 km) for 8-speed transmission, tow with the rear wheels
OFFthe ground. Acceptable methods are to tow the vehicle
on a flatbed, or with the front wheels raised and the rear
wheels on a towing dolly, or (when using a suitable
steering wheel stabilizer to hold the front wheels in the
straight position) with the rear wheels raised and the front
wheels on the ground.
6
WHAT TO DO IN EMERGENCIES 603

“Understanding Your Instrument Panel” for further in-
formation. Tighten the fuel filler cap properly and press
the SELECT button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing.Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD II system is ready, you must
do the following:
1. Turn the ignition switch to the ON position, but do not
crank or start the engine.
2. If you crank or start the engine, you will have to start
this test over.
3. As soon as you turn the ignition switch to the ON
position, you will see the MIL symbol come on as part
of a normal bulb check.
610 MAINTAINING YOUR VEHICLE

4. Approximately 15 seconds later, one of two things will
happen:
•The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system isnot readyand you should
notproceed to the I/M station.
•The MIL will not flash at all and will remain fully
illuminated until you turn OFF the ignition or start the
engine. This means that your vehicle’s OBD II system
isreadyand you can proceed to the I/M station.
If your OBD II system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
system to update. A recheck with the above test routine
may then indicate that the system is now ready.Regardless of whether your vehicle’s OBD II system is
ready or not, if the MIL is illuminated during normal
vehicle operation you should have your vehicle serviced
before going to the I/M station. The I/M station can fail
your vehicle because the MIL is on with the engine
running.
REPLACEMENT PARTS
Use of genuine MOPAR® parts for normal/scheduled
maintenance and repairs is highly recommended to en-
sure the designed performance. Damage or failures
caused by the use of non-MOPAR® parts for mainte-
nance and repairs will not be covered by the manufac-
turer’s warranty.
7
MAINTAINING YOUR VEHICLE 611

Under normal operating conditions, the catalytic con-
verter will not require maintenance. However, it is im-
portant to keep the engine properly tuned to assure
proper catalyst operation and prevent possible catalyst
damage.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe
and abnormal catalyst overheating. If this occurs, stop
the vehicle, turn off the engine and allow it to cool.
Service, including a tune-up to manufacturer’s specifica-
tions, should be obtained immediately.To minimize the possibility of catalytic converter dam-
age:
•Do not shut off the engine or interrupt the ignition,
when the transmission is in gear and the vehicle is in
motion.
•Do not try to start the engine by pushing or towing the
vehicle.
•Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idle or malfunctioning operating conditions.
626 MAINTAINING YOUR VEHICLE

Cavity Car-
tridge
FuseMini
FuseDescription
J13 60 Amp
YellowMain Ignition Off
Draw (IOD)
J14 20 Amp
BlueTrailer Tow
Lamps/Park Lamps
J15 40 Amp
GreenFront Cabin Fan/
Blower
J17 40 Amp
GreenStarter Motor
Solenoid
J18 20 Amp
BluePowertrain Control
Module/Powertrain
Control Module/
Transmission RangeCavity Car-
tridge
FuseMini
FuseDescription
J19 60 Amp
YellowRadiator Fan Motor
HI/Radiator Fan
Motor Low
J20 30 Amp
PinkFront Wiper
J21 20 Amp
BlueFront/Rear Washer
Control
J22 25 Amp
NaturalSunroof Module
M1 15 Amp
BlueStop Lamps
M2 20 Amp
YellowElectronic Limit
Slip Differential/
Air Suspension
7
MAINTAINING YOUR VEHICLE 647

Cavity Car-
tridge
FuseMini
FuseDescription
M25 20 Amp
YellowFuel Pump Motor
Output/Diesel Lift
Pump (Export
Only)
M26 10 Amp
RedDriver Door Switch
Bank
M27 10 Amp
RedIgnition Switch/
Wireless Control
Module/Keyless
Entry Module
M28 15 Amp
BluePowertrain
Controller/
Transmission
ControllerCavity Car-
tridge
FuseMini
FuseDescription
M29 10 Amp
RedTire Pressure Moni-
tor – If Equipped
M30 15 Amp
BlueJ1962 Diag
Connector
M31 20 Amp
YellowBackup Lamps
M32 10 Amp
RedOccupant Restraint
Controller
M33 10 Amp
RedPowertrain
Controller/
Transmission
Controller
650 MAINTAINING YOUR VEHICLE

VEHICLE STORAGE
If you are leaving your vehicle dormant for more than 21
days you may want to take steps to protect your battery.
You may:
•Remove fuse #J13 in the Totally Integrated Power
Module (TIPM) labeled Main Ignition-Off Draw (IOD).
•Or, disconnect the negative cable from the battery.
•Anytime you store your vehicle, or keep it out of
service (i.e. vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Glove Box Lamp 194
Grab Handle Lamp L002825W5W
Overhead Console
Reading LampsVT4976
Rear Cargo Lamp 214–2
Visor Vanity Lamp V26377
Underpanel Courtesy
Lamps906
Instrument Cluster
(General Illumination)103
Telltale/Hazard Lamp 74
652 MAINTAINING YOUR VEHICLE

Gear Select Lever Override..................600
General Information........................20
Glass Cleaning...........................644
Gross Axle Weight Rating...................557
Gross Vehicle Weight Rating..................556
GVWR.................................554
Hazard Warning Flasher....................582
Headlights..............................653
Bulb Replacement......................654
Cleaning.............................644
On With Wipers........................198
Passing..............................206
Replacing............................654
Heated Mirrors...........................126
Heater.................................418
Heater, Engine Block.......................445
High Beam Indicator.......................305
Hill Descent Control.......................504Hill Descent Control Indicator................305
Hill Start Assist...........................500
Hitches
Trailer Towing.........................561
Holder, Cup.............................282
HomeLink® (Garage Door Opener)............260
Hood Release............................195
Ignition.................................16
Key .................................14
Ignition Key Removal.......................16
Illuminated Entry..........................23
Immobilizer (Sentry Key)....................19
Infant Restraint...........................83
Information Center, Vehicle..................313
Inside Rearview Mirror.....................122
Instrument Cluster........................303
Instrument Panel and Controls................301
Instrument Panel Lens Cleaning...............644
10
INDEX 689