2013 JAGUAR XJ brake

JAGUAR XJ JAGUAR XJ JAGUAR XJ
2
Driver controls
Headlamps, direction indicators and trip computer1.
Manual gear change paddle (-) down2.
Instrument panel, warning lamps, message center 3. and turn by turn navigation
Manual gear change paddle (+) up4.
Wiper and Washers5.
STOP/START6.
Sunroof control 7.
Parking aid8.
Rear screen sun blind9.
Sunroof blinds10.
Interior lamps11.
Audio system12.
Climate control13.
Windshield heater14.
Rear screen heater15.
Gear selector 16.
Dynamic Stability Control (DSC) switch17.
Automatic speed limiter (ASL) switch18.
Electronic Parking Brake (EPB)19.
Dynamic mode switch20.
Winter mode switch21.
Instrument panel menu control22.
Adaptive cruise control gap setting and cruise control 23. cancel
Cruise control24.
Steering column adjustment25.
Telephone controls26.
Heated steering wheel27.
Audio/video menu control28.
Instruments dimmer control29.
Rear Fog lamps30.
Trunk release31.
Central locking switches32.
Hazard warning33.
Touch screen Home menu34.
Telephone menu 35.
Navigation menu36.
Intellient stop/start37.
Heated front seats menu38.
Audio settings menu39.
Audio/video menu40.
CD/DVD eject41.
Audio/video sources42.
Rear window isolator43.
Window controls44.
Power folding mirror selectors and adjuster45.
Driving position memory store controls46.
22/05/2012 14:13:2622/05/2012 14:13:2622/05/2012 14:13:26

JAGUAR XJ JAGUAR XJ JAGUAR XJ
Engine start/stop Engine start/stop See page 2, item See page 2, item 6
Starting and driving
5
Operating note
The engine will continue to run even if the Smart Key is removed from the vehicle by more than 3 ft (1 m). However, if the engine is stopped, it cannot be restarted until the Smart Key is returned to the vehicle.
Ignition only on:
With the Smart Key inside the vehicle, press the • START/STOP button to switch on ignition.
A second press will switch off the ignition.•
Engine start
The selector lever must be in • Park or Neutral position to enable engine starting.
With the foot brake depressed, press and release the • START/STOP button to start the engine.
Press again to stop the engine and switch off the • ignition.

Rolling start
If the engine is switched off while the vehicle is moving, it can be restarted by selecting N position then pressing the START/STOP button.
Virtual instrument panel Virtual instrument panel
Main Menu
Display settings Trip computer
Ve
hicle set-up
Show warnings
Service MenuDriver information is displayed on a TFT Virtual Instrument Panel.
Many features of the display can be changed to suit personal preferences. Other features, such as the speedometer, can be altered to suit the driving situation. The speedometer can be configured for KPH or MPH via the Vehicle Settings menu.
To access the main menu in the instrument panel, press any button on the right side steering wheel control. Use the direction controls to move through the menu and subsequent options. Press OK to confirm your selections.
The stop/start system is automatically activated when the ignition is turned on. If the vehicle is stopped, the engine will turn off (unless it is required to support other vehicle systems). When the brake is released and a drive gear is selected the engine will restart automatically.
A warning lamp on the instrument panel will illuminate when the engine has been switched off by the stop/start system.
Intelligent stop/start Intelligent stop/start See page 2, item See page 2, item 37
To switch the system off, • press the Eco switch.
Note: The engine will restart Note: The engine will restart Note:automatically if the switch is pressed whilst an automatic engine stop is in progress.
JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 5JJM189634131.indd 522/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:2822/05/2012 14:13:28

JAGUAR XJ JAGUAR XJ JAGUAR XJ
Warning lamps Warning lamps Displayed on the instrument panelDisplayed on the instrument panel
Transmission See page 2, item See page 2, item 2, 4 2, 4 and 16and 16and
Electronic parking brake Electronic parking brake See page 2, item See page 2, item 19
Starting and driving
6
Select P before switching off the engine. However, if the engine is switched off with Reverse, Drive or Sport selected, the selector will automatically return to P while retracting.
Low tire pressure
Braking system fault or brake fluid low
Braking system fault or brake fluid low. USA onlyElectric parking brake is applied. Flashing - EPB fault. USA only Electric parking brake is applied. Flashing - EPB fault.
Seat belt reminder
Forward alert active
Automatic speed limiter active
Adaptive cruise control active in follow mode
Dynamic stability control fault. Flashes when DSC is operatingAnti-lock braking system fault.
Anti-lock braking system fault. USA only
Engine/transmission malfunction
DSC switched off, Trac DSC on
Air bag fault
Gearshift interlock
Apply the foot brake then move the selector from the Park position. Maintain brake pressure until a gear is selected.
Automatic gear selection
Select D for fully automatic gear changes.
Sport mode
This is an automatic gear change mode, however, change points are modified to make full use of engine power.
Press the selector down and rotate from D to Sport.
Manual gear changes
Manual gear change mode is effective when rapid acceleration and engine braking are required.
To shift down, briefly pull the left (-) paddle.•
To shift up, briefly pull the right (+) paddle.•
When the paddles are used in D, gear selection will revert to automatic if use of the paddles is not maintained. With S selected, continuous manual operation is initiated if the paddles are used.
To return to automatic operation pull and hold the right hand paddle for 2 seconds.
Operating note
If the engine is switched off with Neutral selected, automatic selection of P is delayed for 10 minutes. DONOTuse this feature to enable towing of the vehicle. Refer to Vehicle recovery in the Owner’s Handbook.
Releasing
With the ignition on, apply the foot brake and press • down on the parking brake lever.
If the vehicle is stationary with the parking brake • applied and either Drive or Reverse selected, pressing the accelerator will automatically release the parking brake.
Applying
With the vehicle stationary, lift up the parking brake • lever and then release it. The red warning lamp in the instrument panel will illuminate.
22/05/2012 14:13:2922/05/2012 14:13:2922/05/2012 14:13:29

JAGUAR XJ JAGUAR XJ JAGUAR XJ
Setting cruise control speed
Press to set cruise control 1. at the current speed.
Resumes the set speed 2. after a cancellation.
Press to decrease set 3. speed until the desired new speed is reached.
Press to cancel.4.
Auto headlamps and wipers Auto headlamps and wipers See page 2, items See page 2, items 1 and 5and 5and
Cruise control and forward alert See page 2, items See page 2, items 23 and 24and 24and
Starting and driving
7
For automatic wipe activated by the rain sensor, move the wiper control up to the first position. Sensitivity can be adjusted.
5. First stop for auto position.
6. Rain sensor maximum sensitivity.
7. Rain sensor minimum sensitivity.
Care point
Before entering an automatic car wash, turn the wipers off to deactivate the rain sensor. Otherwise, the wipers will operate during the washing process and may be damaged.
ACC gap setting
5, 6. Press to increase or decrease the set gap to the vehicle ahead.
4. Press to cancel ACC and the set speed.
When ACC is active an amber warning lamp will illuminate in the instrument panel. Set speeds are cleared at ignition off.
Forward alert
An additional feature of ACC, forward alert provides limited detection of objects in the road ahead. When necessary it will give an audible warning plus the visual warning ‘FORWARDALERT’ in the message center. The driver must take appropriate action.
See the Owner’s Handbook for full details.
1
432
MA X
MIN
MAX
MIN
6
5
7
When lighting control 1. AUTO is selected, side lamps and headlamps will turn on automatically as ambient light fades.
With the control in the low beam position, high beam will activate automatically when ambient light falls below a pre set level. Vehicle speed must be above 25 mph (40 km/h).
2, 3, 4. The headlamps can temporarily illuminate ahead when exiting the car at night. Rotate the control for delay periods of 30, 60 or 120 seconds.
1
2
34
5
4
6
Cruise control override
Cruise control will disengage if the brake pedal is pressed or when vehicle speed falls below 30 km/h (18 mph).
Adaptive cruise control (ACC)
This enhancement uses a front mounted radar to monitor traffic ahead. ACC can be programmed to maintain a set gap to the vehicle ahead. If the vehicle ahead is travelling slower than the set cruise control speed, your vehicle will automatically slow down and then maintain the set gap until the road ahead clears. At that point your vehicle will accelerate to the set cruise control speed.