2013 Hyundai Genesis Coupe display

4119
Features of your vehicle
The indicator light in the air intake control
button will blink 3 times with 0.5 second
of interval. It indicates that the defogging
logic is canceled or returned to the pro-
grammed status.
If the battery has been discharged or dis-
connected, it resets to the defog logic
status.
Automatic climate control system
1. Turn the ignition switch to the ON posi-tion.
2. Press the defrost button ( ). 3. While holding the air conditioning but-
ton (A/C) pressed, press the air intake
control button at least 5 times within 3
seconds.
The A/C display blinks 3 times with 0.5
second of interval. It indicates that the
defogging logic is canceled or returned to
the programmed status.
If the battery has been discharged or dis-
connected, it resets to the defog logic
status.
OBK042109L
OBK042274L
■
Type A, B
■ Type C, D

Features of your vehicle
126
4
Digital clock
Whenever the battery terminals or relat-
ed fuses are disconnected, you must
reset the time.
Setup the clock
With audio off
1. Press the [SETUP] or [Clock] button(1)
until the clock of the display blinks.
2. Set the clock by turning the knob(2) and press it.
With audio on
1. Press the [SETUP] or [Clock] button (1).
2. Select the clock menu by turning the knob (2).
3. Set the clock by turning the knob(2) and press it.
WARNING
Do not adjust the clock while driv-
ing. You may lose your steering
control and cause an accident that
results in severe personal injury ordeath.
OBK042111
WARNING
Do not put a finger or a foreign ele-
ment (pin, etc.) into a power outlet
and do not touch with a wet hand.
You may get an electric shock.

4127
Features of your vehicle
Outside thermometer
The current outside temperature is dis-
played in 1°C (1°F) increments. The tem-
perature range is between -30°C ~ 60°C(-30°F~140°F).
The outside temperature on the display
may not change immediately like a gen-
eral thermometer to prevent the driver
from being inattentive.Floor mat anchor (if equipped) When using a floor mat on the front floor
carpet, make sure it attaches to the floor
mat anchor in your vehicle. This keeps
the floor mat from sliding forward.
OBK049112OCM039000N
WARNING
The following must be observed when installing ANY floor mat to
the vehicle.
Ensure that the floor mats are securely attached to the vehicle’s
floor mat anchor(s) before driving
the vehicle.
Do not use ANY floor mat that cannot be firmly attached to the
vehicle’s floor mat anchors.
Do not stack floor mats on top of one another (e.g. all-weather rub-ber mat on top of a carpeted floor
mat). Only a single floor mat
should be installed in each posi-tion.
IMPORTANT – Your vehicle was manufactured with driver’s side
floor mat anchors that are
designed to securely hold the
floor mat in place. To avoid any
interference with pedal operation,
HYUNDAI recommends that the
HYUNDAI floor mat designed for
use in your vehicle be installed.

Features of your vehicle
138
4
Using RADIO, SETUP, VOLUME
and AUDIO CONTROL
1. Button
The FM/AM button toggles between FM
and AM. Listed below are the paths as
the system switches from FM to AM and
back to FM.
FM/AM : FM1 ➟FM2 ➟AM ➟FM1...
1. Button
The FM/AM button toggles between FM
and AM. Listed below are the paths as
the system switches from FM to AM and
back to FM. FM1 ➟FM2 ➟FMA ➟AM ➟AMA ➟FM1...
❈ For EUROPE 2. Button
TA(Traffic annoucement) Channels in
FM,CD, MEDIA mode, turns on/off the
reception of TA channels of RDS. ❈
Button for RDS Model
3. Button & Knob
Turns the audio system on/off when the ignition switch is on ACC or ON.
If the knob is turned clockwise/counter- clockwise, the volume will increase
/decrease.
❈ For EUROPE 4. Button
Turns to FM mode and toggles FM1and
FM2 when the button is pressed each
time.
5. Button
Pressing the button selects the
AM band. AM Mode is displayed on the
LCD.
AM
AM
FM
TA
FM/AM
FM/AM

4139
Features of your vehicle
6. Button & Knob
Turns on/off the set when the IGNITION
SWITCH is on ACC or ON. If the button
is turned to the right, it increases the
voume and left,decreases the volume.
Adjusts the volume of the car audio sys-
tem. Rotate clockwise to increase the
volume or counterclockwise to decrease.
7. Button
When the button is pressed,it increases the band frequency to
automatically select channel. Stops at
the previous frequency if no channel is
found.
When the button is press- ed, it reduces the band frequency to
automatically select channel. Stops at
the previous frequency if no channel is
found. 8. Button
Turn ON/OFF the displayed data and
light on LCD. When LCD Display is
turned OFF, Press any button to turn ON
display.
9. Button(AUTO STORE
Button)
When the button is pressed, it automati-
cally selects and saves channels with
high reception rate to PRESET buttons ~ and plays the channel
saved in PRESET1. If no channel is
saved after AST, it will play the previouschannel.
10. Button
Press this button to turn to the SETUP
adjustment mode. ■
AC100DKEE
If no action is taken for 8 seconds after
pressing the button, it will return to the
play mode. (After entering SETUP mode) The setup changes in the order of Scroll ➟ SDVC ➟Media ➟ ➟ Clock ➟
RDS ■ AC110DKEE, AC610DKEE
The setup Change in the order of Scroll ➟ SDVC ➟Media ➟ RDS ➟ ➟
Clock ➟Phone
SETUP
CLOCK
61
AST
DISP
SEEK
TRACK
SEEK
TRACK
SEEK
VOLPWR

Features of your vehicle
140
4
■ AC110DKEG/AC111DKEE/AC110DKMG/
AC110DKMN/AC110DKGE/AC110DKGG/
AC110DKGL/AC610DKEG/AC611DKEE/
AC610DKMG/AC610DKMN/AC610DKGE
AC610DKGG/AC610DKGL
The setup changes in the order of Scroll➟ SDVC ➟Media ➟ ➟ Clock ➟
Phone ■
AC100DKEG/AC101DKEE/AC100DKMG/
AC100DKMN/AC100DKGE,/AC100DKG/
AC100DKGL/AC600DKEG/AC600DKEE/
AC600DKMG/AC600DKMN/AC600DKGE/
AC600DKGG/AC600DKGL
The setup changes in the order of Scroll➟ SDVC ➟Media ➟➟ Clock Select whether long file names are
scrolled continuously (On) or just once(Off).

Control)
Select this item to turn the SDVC feature
On or Off. If it is turned ON, volume levelis adjusted automatically according to
the vehicle speed.
Select default display of MP3 play infor-
mation. “Folder/File” or “Artist/Title” canbe selected.

RDS menu includes News/AF/Region/
TA Vol. menu sequentially.

Features of your vehicle
142
4

Select this item to enter Clock setup
mode. (12/24Hr.,Auto, Time)

Select “12/24 Hr.” button to enter Time
Format menu.

Select “Auto” button to enter Automatic
RDS Time menu.

Select this item to enter SETUP mode.
Refer to “PHONE OPERATION” section
for detailed information. ❈ “PHONE” menu is not available if the
audio does not support
Bluetooth®
Wireless Technology features. 11. PRESET Buttons
Push ~ buttons less than 0.8
second to play the channel saved in each
button. Push Preset button for 0.8 sec-
ond or longer to save current channel to
the respective button with a beep.
12. Button
Moves button
when
searching PTY in RDS Broadcasting
Program Type selection.
Moves button when
searching PTY in RDS Broadcasting
Program Type selection.
❈ Button for RDS Model
13 & Knob
Within the screen displayed after first
pressing the knob, turn the knob to select
the mode. The modes will change inorder of BASS ↔MIDDLE ↔TREBLE
↔ FADER ↔BALANCE.
❈ For EUROPE
PTY
FOLDER
PTY
FOLDERPTY
61

4143
Features of your vehicle
13. & Knob
Turn this control while listening to a radio
channel to manually adjust frequency.
Turn clockwise to increase frequency
and counterclockwise to reduce frequen-
cy.
Pressing the button changes the BASS,
MIDDLE, TREBLE, FADER and BAL-
ANCE TUNE mode. The mode selected
is shown on the display. After selecting
each mode, rotate the Audio control knob
clockwise or counterclocw kwise.
To increase the BASS, rotate the knob
clockwise, while to decrease the BASS,
rotate the knob counterclockwise.
To increase the MIDDLE, rotate the knob
clockwise, while to decrease the MID-
DLE, rotate the knob counterclockwise.
Control
To increase the TREBLE, rotate the knob
clockwise, while to decrease the TRE-
BLE, rotate the knob counterclockwise.
Turn the control knob clockwise to
emphasize rear speaker sound(front
speaker sound will be attenuated).
When the control knob is turned counter-
clockwise, front speaker sound will be
emphasized(rear speaker sound will be
attenuated).
Rotate the knob clockwise to emphasize
right speaker sound(left speaker sound
will be attenuated).
When the control knob is turned counter
clockwise, left speaker sound will be
emphasized(right speaker sound will be
attenuated).ENTERTUNE