2013 FORD SUPER DUTY lock

[x] Cancel search: lock

Page 94 of 563

FORD SUPER DUTY 2013 3.G Owners Manual Auto-Dimming Mirror (If Equipped)
Note:Do not block the sensors on the front and back of the mirror.
Mirror performance may be affected. A rear center passenger or raised
rear center head restraint ma

Page 97 of 563

FORD SUPER DUTY 2013 3.G Owners Manual Engine Coolant Temperature Gauge
Indicates engine coolant temperature. At normal operating temperature,
the level indicator will be in the normal range. If the engine coolant
temperature exceeds the n

Page 98 of 563

FORD SUPER DUTY 2013 3.G Owners Manual WARNING LAMPS AND INDICATORS
The following warning lamps and indicators will alert you to a vehicle
condition that may become serious. Some lamps will illuminate when you
start your vehicle to make su

Page 99 of 563

FORD SUPER DUTY 2013 3.G Owners Manual Charging System
It will illuminate when the 12–volt battery is not charging properly.
Contact your authorized dealer as soon as possible. This indicates
a problem with the electrical system or a rel

Page 106 of 563

FORD SUPER DUTY 2013 3.G Owners Manual SETUP
UNITS press the
RESET buttonDistance English
Metric
Temperature Fahrenheit
Celsius
AUTOLAMP
(SEC)0 to 180 seconds
AUTOLOCK On or Off
AUTOUNLOCK On or Off
COURTESY
WIPEOn or Off
CREATE MYKEY / MY

Page 107 of 563

FORD SUPER DUTY 2013 3.G Owners Manual To reset the oil monitoring system to 100% after each oil change,
perform the following:
1. Press and release the SETUP button to display OIL LIFE XXX% HOLD
RESET = NEW.
2. Press and hold the RESET bu

Page 112 of 563

FORD SUPER DUTY 2013 3.G Owners Manual •Average MPG: shows the average fuel usage based on time. See Fuel
Hist. to change the time interval. Press and hold OK to reset this
value.
Truck Apps
In this mode, off-road information depicted wi

Page 116 of 563

FORD SUPER DUTY 2013 3.G Owners Manual Settings (cont’d)
Vehicle Autolamp
DelayOff or XXX seconds
Compass Zone Setting (1–15) See the diagram
below to determine your magnetic zone.
Calibration (When choosing Calibration,
follow the on-