2013 FORD FOCUS window

Rear Window Washers
Note:Do not operate the washers when the washer reservoir is empty.
This may cause the washer pump to overheat.
The washer will spray for as long
as you push the lever away from
you. When you release the lever,
the wiper will operate for a short
time.
88Wipers and Washers
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)

POWER WINDOWS
WARNING:Do not leave children unattended in the vehicle and
do not let them play with the power windows. They may
seriously injure themselves.
WARNING:When closing the power windows, you should verify
they are free of obstructions and make sure that children and
pets are not in the proximity of the window openings.
Note:You may hear a rumbling noise when one or both of the rear
windows are open. Lower a front window slightly to reduce this noise.
Press the switch to open the window.
Lift the switch to close the window.
One-Touch Down (If Equipped)
Press the switch fully and release it. Press or lift it again to stop the
window.
One-Touch Up (If Equipped)
Lift the switch fully and release it. Press or lift it again to stop the
window.
Windows and Mirrors95
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)

Window Lock
Press the control to lock or unlock the rear
window controls. It will illuminate when the
rear window controls are locked.
Bounce-Back (If Equipped)
The window will stop automatically while closing. It will reverse some
distance if there is an obstacle in the way.
Overriding the Bounce-Back Feature
Proceed as follows to override this protection function when there is a
resistance, e.g. in the winter:
1. Close the window twice until it reaches the resistance and let it
reverse.
2. Close the window a third time to the resistance. The bounce-back
function is disabled and you can close the window manually. The window
will override the resistance and you can close it fully.
Contact your authorized dealer as soon as possible if the window does
not close after the third attempt.
Resetting the Bounce-Back Feature
WARNING:The bounce-back function remains deactivated until
you have reset the memory.
You must reset the bounce-back memory separately for each window
after the battery has been disconnected.
1. Lift and hold the switch until the window is fully closed.
2. Release the switch.
3. Lift the switch again for one more second.
4. Press and hold the switch until the window is fully open.
5. Release the switch
96Windows and Mirrors
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)

6. Lift and hold the switch until the window is fully closed.
7. Open the window and then try to close it automatically.
8. Reset and repeat the procedure if the window does not close
automatically.
Accessory Delay (If Equipped)
You can use the window switches for several minutes after the you
switch the ignition off, or until either front door is opened.
EXTERIOR MIRRORS
Power Exterior Mirrors
WARNING:Do not adjust the mirror while the vehicle is in
motion.
A. Left-hand mirror
B. Off
C. Right-hand mirror
Press the arrows to adjust the mirror.
Fold-Away Exterior Mirrors
Push the mirror toward the door window glass. Make sure that you fully
engage the mirror in its support when returning it to its original position.
Windows and Mirrors97
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)

Signal Indicator Mirrors (If Equipped)
The outer portion of the appropriate mirror housing will blink when the
turn signal is activated.
Integrated Blind Spot Mirrors
WARNING:Objects in the blind spot mirror are closer than they
appear.
Blind spot mirrors have an integrated convex mirror built into the upper
outboard corner of the exterior mirrors. They are designed to assist you
by increasing visibility along the side of your vehicle.
Check the main mirror first before a lane change, then check the blind
spot mirror. If no vehicles are present in the blind spot mirror and the
traffic in the adjacent lane is at a safe distance, signal that you are going
to change lanes. Glance over your shoulder to verify traffic is clear, and
carefully change lanes.
The image of the approaching
vehicle is small and near the inboard
edge of the main mirror when it is at
a distance. The image becomes
larger and begins to move outboard
across the main mirror as the vehicle
approaches (A). The image will
transition from the main mirror and
begin to appear in the blind spot
mirror as the vehicle approaches
(B). The vehicle will transition to
your peripheral field of view as it
leaves the blind spot mirror (C).
A
B
C
98Windows and Mirrors
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)

INTERIOR MIRROR
WARNING:Do not adjust the mirror when your vehicle is
moving.
Note:Do not clean the housing or glass of any mirror with harsh
abrasives, fuel or other petroleum or ammonia based cleaning products.
You can adjust the interior mirror to your preference. Some mirrors also
have a second pivot point. This lets you move the mirror head up or
down and from side to side.
Pull the tab below the mirror toward you to reduce glare at night.
SUN VISORS
Illuminated Visor Vanity Mirror (If Equipped)
Lift the cover to switch on the
lamp.
MOONROOF (IF EQUIPPED)
WARNING:Do not let children play with the moonroof or leave
them unattended in the vehicle. They may seriously hurt
themselves.
WARNING:When closing the moonroof, you should verify that it
is free of obstructions and ensure that children and/or pets are
not in the proximity of the moon roof opening.
The sunscreen can be manually opened or closed when the glass panel is
closed.
The moonroof has a one-touch open and close feature. To stop motion
during one-touch operation, press the control a second time.
Windows and Mirrors99
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)

The moonroof control is located on the
overhead console.
Opening and Closing the Moonroof
Press and release the rear of the control to open the moonroof. If the
sliding shade is closed, it will open along with the moonroof. The
moonroof will stop short of the fully opened position.
Note:This position helps to reduce rumbling wind noise which may
happen with the moonroof fully open. Press and release the control again
to fully open the moonroof.
Press and release the front of the control to close the moonroof.
Bounce-Back
The moonroof will stop automatically while closing and reverse some
distance if there is an obstacle detected while closing.
Press and hold the front of the control within two seconds of a
bounce-back event to override the function. While bounce-back is active,
the closing force increases for each of the next three time the moonroof
is closed.
Venting the Moonroof
Press and release the front of the control while the moonroof is closed.
Press and hold the rear of the control to close the moonroof.
Relearning Function
In case the moonroof does not close properly, follow this procedure:
1. Tilt the moonroof into the vent position as far as possible. Release the
switch.
2. Press and hold the same switch again for 30 seconds until you see the
moonroof move.
3. Release the switch and immediately press and hold it again. The
moonroof will close, open fully and then close again. Do not release the
switch before the moonroof has reached the closed position for the
second time.
100Windows and Mirrors
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)

Safety Mode
The system enters a safety mode when it detects a malfunction. The
moonroof will move about 0.5 seconds at a time and then stop again.
Press the switch repeatedly until the moonroof is closed. Have the
system checked by your authorized dealer immediately.
Windows and Mirrors101
2013 Focus(foc)
Owners Guide gf, 1st Printing
USA(fus)