2013 FORD FLEX parking brake

WARNING:Battery posts, terminals and related accessories contain
lead and lead compounds. Wash hands after handling.
Your vehicle is equipped with a Motorcraftmaintenance-free battery which
normally does not require additional water during its life of service.
Note:If your battery has a cover/shield, make sure it is reinstalled after
the battery has been cleaned or replaced.
For longer, trouble-free operation, keep the top of the battery clean and
dry. Also, make certain the battery cables are always tightly fastened to
the battery terminals.
If you see any corrosion on the battery or terminals, remove the cables
from the terminals and clean with a wire brush. You can neutralize the
acid with a solution of baking soda and water.
It is recommended that the negative battery cable terminal be
disconnected from the battery if you plan to store your vehicle for an
extended period of time.
Battery relearn
Because your vehicle’s engine is electronically controlled by a computer,
some control conditions are maintained by power from the battery. When
the battery is disconnected or a new battery is installed, the engine must
relearn its idle and fuel trim strategy for optimum driveability and
performance. To begin this process:
1. With the vehicle at a complete stop, set the parking brake.
2. Put the gearshift lever in P (Park), turn off all accessories and start
the engine.
3. Run the engine until it reaches normal operating temperature.
4. Allow the engine to idle for at least one minute.
5. Turn the A/C on and allow the engine to idle for at least one minute.
6. Drive the vehicle to complete the relearning process.
•The vehicle may need to be driven to relearn the idle and fuel trim
strategy.
•Note:If you do not allow the engine to relearn its idle trim, the idle
quality of your vehicle may be adversely affected until the idle trim is
eventually relearned.
Maintenance319
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

•Start the engine every 15 days. Run at fast idle until it reaches normal
operating temperature.
•With your foot on the brake, shift through all the gears while the
engine is running.
Fuel system
•Fill the fuel tank with high-quality fuel until the first automatic shutoff
of the fuel pump nozzle.
Note:During extended periods of vehicle storage (30 days or more), fuel
may deteriorate due to oxidation. Add a quality gas stabilizer product to
the vehicle fuel system whenever actual or expected storage periods
exceed 30 days. Follow the instructions on the additive label. The vehicle
should then be operated at idle speed to circulate the additive
throughout the fuel system.
Cooling system
•Protect against freezing temperatures.
•When removing vehicle from storage, check coolant fluid level.
Confirm there are no cooling system leaks, and fluid is at the
recommended level.
Battery
•Check and recharge as necessary. Keep connections clean.
•If storing your vehicle for more than 30 days without recharging the
battery, it may be advisable to disconnect the battery cables to ensure
battery charge is maintained for quick starting.
Note:If battery cables are disconnected, it will be necessary to reset
memory features.
Brakes
•Make sure brakes and parking brake are fully released.
Tires
•Maintain recommended air pressure.
Miscellaneous
•Make sure all linkages, cables, levers and pins under vehicle are
covered with grease to prevent rust.
•Move vehicles at least 25 feet (8 m) every 15 days to lubricate
working parts and prevent corrosion.
Vehicle Care337
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

•All-Wheel driving capability (if applicable)
•Load leveling adjustment (if applicable)
When driving with the full-size dissimilar spare tire/wheel additional
caution should be given to:
•Towing a trailer
•Driving vehicles equipped with a camper body
•Driving vehicles with a load on the cargo rack
Drive cautiously when using a full-size dissimilar spare tire/wheel and
seek service as soon as possible.
Tire Change Procedure
WARNING:When one of the front wheels is off the ground, the
transmission alone will not prevent the vehicle from moving or
slipping off the jack, even if the vehicle is in P (Park).
WARNING:To help prevent the vehicle from moving when you
change a tire, be sure to place the transmission in P (Park), set the
parking brake and block (in both directions) the wheel that is diagonally
opposite (other side and end of the vehicle) to the tire being changed.
WARNING:If the vehicle slips off the jack, you or someone else
could be seriously injured.
WARNING:Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the road to avoid
the danger of being hit when operating the jack or changing the wheel.
WARNING:To lessen the risk of personal injury, do not put any
part of your body under the vehicle while changing a tire. Do not
start the engine when your vehicle is on the jack. The jack is only meant
for changing the tire.
364Wheels and Tires
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

Note:Passengers should not remain in the vehicle when the vehicle is
being jacked.
1.
Park on a level surface, set the parking brake and activate hazard flashers.
2. Place gearshift lever in P (Park) and turn engine off.
If the 3rd row seat is stowed in the floor, you will need to unstow it to
access the spare tire and jack.
3. Remove the carpeted floor panel
located in the rear of the vehicle, then
remove the wing nut that secures the
spare tire by turning it counterclockwise.
4. Lift and remove the spare tire from
the trunk.
5. Remove the second wing nut that
secures the jack retention bracket by
turning it counterclockwise, remove the
jack kit from the vehicle.
6. Remove the jack, L-shaped bolt, and
the wrench from the felt bag. Fold down
the wrench socket to use to loosen the
lug nuts and to operate the jack.
7. Block the diagonally opposite
wheel.
8. Remove wheel cover (if equipped) with the lug wrench tip and loosen
each wheel lug nut one-half turn counterclockwise but do not remove
them until the wheel is raised off the ground.
Wheels and Tires365
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

Additives and Chemicals
Ford Motor Company recommended additives and chemicals are listed in
this book and in theWorkshop Manual.Additional chemicals or additives
not approved by Ford and are not recommended as part of normal
maintenance. Please consult yourWarranty Manualfor complete warranty
information.
Oils, Fluids and Flushing
In many cases, fluid discoloration is a normal operating characteristic and,
by itself, does not necessarily indicate a concern or that the fluid needs to
be changed. However, discolored fluids that also show signs of overheating
and/or foreign material contamination should be inspected immediately by a
qualified expert such as the factory-trained technicians at your dealership.
Your vehicle’s oils and fluids should be changed at the specified intervals or
in conjunction with a repair. Flushing is a viable way to change fluid for
many vehicle sub-systems during scheduled maintenance. It is critical that
systems are flushed only with new fluid that is the same as that required to
fill and operate the system, or using a Ford-approved flushing chemical.
Owner Checks and Services
Certain basic maintenance checks and inspections should be performed
every month or at six months intervals.
Check every month
Engine oil level
Function of all interior and exterior lights
Tires for wear and proper pressure, including spare
Windshield washer fluid level
Check every six months
Battery connections; clean if necessary
Body and door drain holes for obstructions; clean if necessary
Cooling system fluid level and coolant strength
Door weatherstrips for wear; lubricate if necessary
Hinges/latches/outside locks for proper operation; lubricate if necessary
Parking brake for proper operation
Safety belts and seat latches for wear and function
Safety warning lamps (brake, ABS, airbag, safety belt) for operation
Washer spray/wiper operation; clean or replace blades as necessary
386Scheduled Maintenance
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

Normal Scheduled Maintenance - At every oil change interval as
indicated by the message center
Change engine oil and filter
Rotate tires, inspect tire wear and measure tread depth
Perform multi-point inspection (recommended)
Inspect automatic transmission fluid level (if equipped with dipstick);
consult dealer for requirements
Inspect brake pads, shoes, rotors, drums, brake linings, hoses and
parking brake
Inspect cabin air filter (if equipped)
Inspect engine cooling system strength and hoses
Inspect exhaust system and heat shields
Inspect rear axle and U-joints; lubricate if equipped with grease fittings
(AWD vehicles)
Inspect half-shaft boots (if equipped)
Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft
and U-joints; lubricate if equipped with grease fittings
Inspect wheels and related components for abnormal noise, wear,
looseness or drag
Reset your Intelligent Oil Life Monitor™ after each engine oil and filter
change; refer to theInstrument Clusterchapter
Do not exceed one year or 10,000 miles (16,000 km) between
service intervals
390Scheduled Maintenance
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

Brakes ........................................ 223
anti-lock ................................... 224
anti-lock brake system (ABS)
warning light ........................... 224
brake warning light ................ 224
fluid, checking and adding .... 317
fluid, refill capacities .............. 371
fluid, specifications ................. 371
lubricant specifications .......... 371
parking .................................... 224
shift interlock .......................... 214
trailer ....................................... 272
C
Capacities for refilling fluids .... 371
Cargo net ................................... 260
CD .............................. 140, 144, 146
CD player .......................... 138, 482
CD voice commands ................. 482
Cell phone use ............................ 16
Changing a tire ......................... 362
Child safety restraints .......... 29, 31
Child safety seats
attaching with tether straps .... 31
automatic locking mode
(retractor) ................................. 39
LATCH ....................................... 29
Child safety seats - booster
seats ............................................. 22
Cleaning the touchscreen ........ 454
Cleaning your vehicle ............... 330
engine compartment .............. 332
instrument panel .................... 334
interior ..................................... 333
plastic parts ............................ 331
washing .................................... 330
waxing ..................................... 332wheels ...................................... 335
wiper blades ............................ 333
Climate control (see Air
conditioning or Heating) .......... 153
Climate voice commands ......... 520
Clock .................................. 140, 510
Collision Warning System ......... 254
Compass Display ....................... 121
Console ...................................... 192
overhead .................................. 194
rear .......................................... 192
Coolant
checking and adding .............. 308
refill capacities ........................ 371
specifications .......................... 371
Cooler ........................................ 193
Cross Traffic Alert .................... 249
Cruise control ........................... 239
Customer Assistance ................ 281
Ford Extended Service
Plan .................................. 380, 383
Getting assistance outside the
U.S. and Canada ..................... 290
Getting roadside assistance ... 281
Getting the service
you need ................................. 286
Ordering additional owner’s
literature ................................. 292
Utilizing the
Mediation/Arbitration
Program ................................... 290
Customizing your
home screen .............................. 453
D
Defrost ....................... 153, 155, 157
rear window ............................ 161
552Index
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

Dipstick
automatic transmission
fluid .......................................... 313
engine oil ................................. 307
Display settings ......................... 510
Driving under special
conditions .................. 215, 217, 220
sand ......................................... 218
snow and ice ........................... 221
through water ................. 219, 278
Dual automatic temperature
control (DATC) ................. 155, 157
E
Electronic message center ....... 117
Electronic stability control ...... 227
Emergencies, roadside
jump-starting .......................... 283
running out of fuel ................. 203
Emergency brake (see Parking
brake) ........................................ 224
Emission control system .......... 207
End user license agreement .... 533
Engine ........................................ 370
cleaning ................................... 332
fail-safe cooling ....................... 312
idle speed control ................... 318
lubrication specifications ....... 371
refill capacities ........................ 371
service points .......................... 306
Engine block heater ................. 199
Engine oil
checking and adding .............. 307
dipstick .................................... 307
filter, specifications ................ 375
refill capacities ........................ 371
specifications .......................... 371Event data recording .................. 12
Exhaust fumes .......................... 199
F
Fail safe cooling ........................ 312
Fleet MyKey programming ........ 70
Flexible Fuel Vehicle (FFV) .... 201
Floor mats ................................. 279
Fluid capacities ......................... 371
Four-Wheel Drive vehicles
driving off road ....................... 217
Freezer ...................................... 193
Fuel
cap ........................................... 205
capacity ................................... 371
choosing the right fuel ........... 202
filler funnel ............................. 203
filling your vehicle with fuel .. 205
filter, specifications ........ 317, 375
fuel pump shut-off .................. 283
octane rating ................... 202, 370
running out of fuel ................. 203
safety information relating to
automotive fuels ..................... 201
Fuel and distance computer .... 121
outside temperature
indicator .................................. 121
to empty indicator .................. 121
trip distance ............................ 121
trip/reset button ..................... 121
Fuel - flex fuel vehicle
(FFV) ......................................... 201
Fuses .................................. 294–295
G
Gas cap (see Fuel cap) ............ 205
Index553
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)