2013 FORD FLEX bulb

Replacing front parking lamp/turn signal bulbs
1. Make sure headlamp switch is in the off position, then open the hood.
2. Reach behind the headlamp assembly to access the bulb sockets .
3. Remove the bulb socket by
turning it counterclockwise and
pulling it straight out.
4. To remove the bulb, pull it
straight out of the bulb socket.
Install the new bulb(s) in reverse
order.
Replacing fog lamp bulbs
1. Make sure the fog lamp switch is in the off position.
2. From underneath the vehicle,
partially remove the tire splash
shield by removing four drive screws
from the lower flap.
The splash shield flap can now be
repositioned to allow access to the
front fog lamp bulb and electrical
wire harness.
3. Carefully disconnect the wire
harness connector from the bulb by
releasing the two snap clips.
4. Rotate the bulb counterclockwise
to remove from the fog lamp.
Install the new bulb in reverse order.
Maintenance327
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

Replacing rear stop/tail/turn/backup and side marker lamp bulbs
The stop/tail/turn/backup and side marker lamp bulbs are located in the
tail lamp assembly.
Note:Your vehicle may be equipped with a stop/tail/turn and side
marker lamp assemblies containing integral multiple light emitting diodes
(LED). If replacement is required, see your authorized dealer.
A.Backup lamp
B.Stop/tail/turn signal lamp
C.Side marker lamp
D.Supplemental taillamp
1. Make sure the headlamp switch is
in the off position and open the
liftgate.
2. Remove the hex screws in the liftgate opening, then pull the lamp
assembly away from the vehicle. This will disengage two snap
attachments along the side of the vehicle.
3. Remove the bulb socket by rotating it counterclockwise, then pulling it
out of the lamp assembly.
4. Pull the bulb straight from the socket.
Install new bulb(s) in reverse order.
Replacing high-mount brake lamp bulbs
Your vehicle is equipped with an LED high-mount brake lamp. It is
designed to last the life of the vehicle. If replacement is required, it is
recommended that you see your authorized dealer.
Replacing license plate lamp bulbs
1. Make sure the headlamp switch is in the off position.
2. Remove the two screws and the
license plate lamp assembly from the
liftgate.
328Maintenance
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

3. Carefully pull the bulb straight out
from the lamp assembly.
Install new bulb(s) in reverse order.
BULB SPECIFICATION CHART
Replacement bulbs are specified in the chart below. Headlamp bulbs must
be marked with an authorized “D.O.T.” for North America and an “E” for
Europe to ensure lamp performance, light brightness and pattern and safe
visibility. The correct bulbs will not damage the lamp assembly or void the
lamp assembly warranty and will provide quality bulb burn time.
Function Number of bulbsTrade
number
Headlamp2 9008 H13
2D3 HID
(optional)
Front park/turn lamp 4 3157NA
*Front sidemarker lamp N/A LED
Fog lamp 2 H11
Map lamp 2 12V6W
Dome/reading lamps 6 578
Tail/brake/turn signal lamp2 3157K
N/A*LED
(optional)
Supplemental taillamp 2 194
Rear sidemarker2 194
N/A*LED
(optional)
Backup lamp 2 921
License plate lamp 2 C5WL
*High-mount brake lamp N/A LED
To replace all instrument panel lights - see your authorized dealer.
*To replace these lamps - see your authorized dealer.
Maintenance329
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)

Gauges ............................... 110–111
odometer ................................. 121
trip odometer .......................... 121
H
Hazard flashers ......................... 282
HD Radio™ ............................... 469
Headlamps
aiming ...................................... 324
bulb specifications .................. 329
flash to pass .............................. 98
high beam ................................. 98
replacing bulbs ....................... 326
Head restraints ......................... 164
Heating ...................... 153, 155, 157
Help ............................................ 518
Homelink wireless control
system ........................................ 184
Home screen ............................. 453
Hood .......................................... 304
How to use voice commands ... 459
I
Ignition ............................... 196, 370
Illuminated visor mirror ... 107–108
Information displays ................. 117
Infotainment display ................. 457
Inspection/maintenance (I/M)
testing ........................................ 209
Instrument panel
cleaning ................................... 334
cluster ...................................... 111
Intelligent Access Key ................ 63
J
Jack ............................................ 362positioning ............................... 362
storage ..................................... 362
Joining two calls
(multiparty/conference call) .... 412
Jump-starting your vehicle ...... 283
K
Keyless entry system
autolock ..................................... 78
keypad ....................................... 84
locking and unlocking doors .... 85
programming entry code ......... 84
Keys ....................................... 63, 86
positions of the ignition ......... 196
L
Lamps
bulb replacement
specifications chart ................ 329
headlamps, flash to pass .......... 98
interior lamps ......................... 102
replacing bulbs ....................... 326
LATCH anchors ........................... 29
Liftgate .................................. 80–81
Lights, warning and indicator .. 111
Listening to music .................... 465
Loading pictures ....................... 510
Load limits ................................. 261
Locks
autolock ..................................... 78
childproof .................................. 35
doors .......................................... 76
Lubricant specifications ........... 371
Lug nuts .................................... 368
M
Making and receiving calls ....... 492
554Index
2013 Flex(471)
Owners Guide gf, 1st Printing
USA(fus)