2013 FORD C MAX HYBRID remote control

instrument
panel
78
6
4
32
2
3 right Vehicle
inF o display
Access information about
Entertainment, Phone,
Navigation* or the animated
EcoGuide with efficiency leaves
by using the right, 5-way controls.
Scroll through the menu,
highlight selections and make
adjustments. Press oK to confirm
your choices.
4 s teering Wheel
Media c ontrols
Volume: Press + to increase or – to decrease volume levels.
Press to access the next/
previous radio station, CD track or
preset satellite radio channel*.
Pull to access voice recognition.
Press to access phone mode
or to answer a call.
Press to end a phone call.
oK Press to confirm your selection.
5 tilt/telescope
s teering c oluMn
Unlock the steering wheel by
pulling the lever down. Adjust the
steering wheel to your desired
position. Push the lever up to lock
the steering wheel in place.
6 push-Button
silent s tart
*
Allows you to go into “Ready
to Drive” mode by pressing the
Power ST arT/ST oP button
while fully pressing down on the
brake pedal. A green
“Ready
to Drive” indicator light will
appear in the instrument cluster
after you start the vehicle. This
lets you know that the vehicle is
on and ready for driving. Press the
P ower ST arT/ST oP button
again to turn the vehicle off.
Note Your intelligent access
key must be inside the vehicle to
put the vehicle in accessory mode
or “Ready to Drive”.
7 hazard c ontrol
8 door locK indicator light
Illuminates when all of the doors
are locked, and will not light
when a door remains open or
unlocked. The central door locks
can be found on both driver and
front-passenger doors, or on a
keyless remote*.
1 cruise c ontrol
To Set a Cruise Control Speed
1. Press the on button and release.
2. Accelerate to the desired speed.
3. Press the SeT + and release, then
take your foot off the accelerator.
After your speed has been set, you can press
SeT + or SeT - to adjust cruise speed. To
disable, press the off button, tap the brake
pedal or pull the can control toward you.
2 leFt Vehicle inF o displayProvides specific information about various
systems on your vehicle. Use the left, 5-way
controls to use SmartGauge
®, customize views,
and choose and confirm settings and messages.
Refer to the Information Displays chapter of
your Owner’s Manual for more information.
*if equipped *
if equipped
1
5
3
7
6

14
hands-Free poWer liFtgate*
Open Your Liftgate Hands-free While You Are at the Liftgate
Move your leg toward and under, then away from the rear bumper
(similar to a kicking motion). The liftgate will power open or close.
Note Your intelligent access key must be within 3 feet
(1 meter) of the liftgate for the “hands-free” open feature
to work. The liftgate will not power open or close under specific
conditions. Refer to the Locks chapter in your Owner’s Manual
for more information.
setting the liFtgate open height*
To Change Your Liftgate Opening Height
1. Open the liftgate.
2. Manually move the liftgate to the desired height.
3. Press and hold the control button on the liftgate until you
hear a tone, indicating the new height has been programmed.
The new open liftgate height will now be recalled when the
power liftgate is opened.
4. To change the programmed height, repeat the above
procedure. Once the power liftgate is opened, it can be
manually moved to a different height.
Manual liFtgate
To open the liftgate manually from outside of your vehicle, press
the button located in the top of the liftgate pull cup handle to
unlatch the liftgate, and then pull on the outside handle.
You can also use the remote control to open your liftgate. Press
the
button twice within three seconds.
Use the molded handle inside the liftgate to help with closing.
p o Wer liFtgate*
You can open the power liftgate from the instrument panel by
pressing the button, or with the remote control by pressing
the button.
If the vehicle is running, the liftgate will only operate with the
transmission in P (Park). Three warning tones will sound once as
the liftgate begins to power close. Five short tones indicate a problem
with the open or close request,
caused when:
» the ignition is on and the
transmission is not in P (Park)
» the battery voltage is below the
minimum operating voltage
» or the vehicle speed is at or
above 3 mph (5 km/h).
convenience
*if equipped15
function
intelligent a ccess*
Note Your intelligent access key must
be within 3 feet (1 meter) of the vehicle for
intelligent access to function properly.
To unlock the driver’s door: Pull the front
exterior door handle. Touch the raised sensor on
the driver’s door handle to lock your vehicle.
To unlock and open the liftgate: Press the
exterior liftgate release button near the license
plate. The intelligent
access key also contains
a mechanical key blade,
which can be used to
unlock the driver’s door
if necessary. For complete
information, refer to
the Keys and Remote
Control chapter in your
Owner’s Manual.
reMote start
To Remote Start Your Vehicle
1. Press the lock button to lock all the doors.
2. Press the remote start button twice. The exterior lamps will flash twice.
Note If you remote start your vehicle with an integrated keyhead transmitter, you
must switch the ignition on before driving your vehicle. If you remote start your vehicle
with an intelligent access transmitter, you must press the ST arT/ST oP button on the
instrument panel once while applying the brake pedal before driving your vehicle. For
complete information, refer to the Remote Control chapter in your Owner’s Manual.
MyKey®
MyKey allows you to program certain driving restrictions in order to promote good
driving habits. You can program things like: speed restrictions, limited volume levels
and safety belt reminders. For complete information, refer to the MyKey chapter in
your Owner’s Manual.
110- Volt ac po Wer point*
The power point is located on the rear of the center
console and can be used to power your smaller electrical
devices that do not exceed 150 watts. This feature is
available to use when your ignition is turned on and the
battery voltage is above 11 volts. When the indicator light
is on, the power point is working and ready to use.
c argo s torage
Your vehicle is equipped with two under-floor storage
compartments that are located behind the front seats. You
can use these compartments to store smaller items discretely.
With the lids secured, your items will stay in place while
you drive.
*if equipped

Folding the rear
seatB acK
To Fold the Rear Seat Back
1. Fold the outboard head restraints and
lower the center head restraint.
2. Pull the lever up to fold the
seatback forward.
3. To unfold the seatback, simply pull
up on the seatback to raise it to the
upright position.
comfort
dual cliMate controls
With the dual climate controls, you have the flexibility
to operate the temperature with one control, called
mono mode, or two, where both driver and front
passenger can select independent temperatures
using their own rotary dials.
To operate the dual temperature control: Use the
rotary control on the passenger’s side. Mono mode
automatically shuts off.
To return back to mono mode: Press and hold the
aUTo button. The passenger’s side temperature
automatically adjusts to the driver’s side temperature
setting, and both sides will then remain linked to the
driver’s control.
2
1
panel rooF With sunshade*
The sun shade controls are located on the overhead console. The sun shade has
a one-touch open and close feature. To stop motion during one-touch operation,
press the control a second time.
Opening and Closing the Sun Shade
Fully press and release the front of the control to open the sun shade. Fully press
and release the rear of the control to close the sun shade. For more complete
information, see the Windows and Mirrors chapter of your Owner’s Manual.
tilting Front-ro W head restraints*
The front head restraints may have a tilting feature for extra comfort.
To Tilt the Head Restraint, Do the Following
1. Adjust the seatback to an upright
driving or riding position.
2. Pivot the head restraint forward
toward your head to the desired
position. After the head restraint
reaches the forward-most position,
pivot it forward again to release it
to the rearward, un-tilted position.
aMBient lighting*
Illuminate the interior with a choice of several colors by using
the ambient lighting feature. The ambient lighting controls are
located in the overhead console.
Color Palette: Press to cycle through the various color choices.
Control Knob: Turn the knob past the first detent to switch
ambient lighting on and adjust the brightness.
Search Mode: Press to switch on all interior lamps and ambient
lighting. Press again to turn the interior lamps off.
The ambient lighting switches on when you switch the ignition
and the headlamps on.
The ambient lighting will remain on until you switch the ignition
off and either lock your vehicle, or allow the accessory delay
timer to expire.
17
16
*if equipped
*if equipped
interior laMps
The lamps will switch on when you open any door, press a remote
control button or press on the overhead control.
Press
to disable the interior lamps when you open any door. The
door function indicator “lamp will illuminate yellow.
Press
again to turn the
interior lamps back on.
The indicator lamp will
illuminate blue.
Press
to switch all
lamps on and off.