2013 FIAT SCUDO technical specifications

98
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
HOW TO MAINTAIN THE SEAT
BELTS IN EFFICIENT
CONDITIONS
For keeping the seat belts in efficient con-
ditions, carefully observe the following:
❒always use the seat belt with the strap
well stretched and not twisted; make
sure that it is free to run without ob-
structions;
❒check seat belt operation as follows: at-
tach the seat belt and pull it hard
❒replace the belt after an accident of a cer-
tain severity even if it does not appear to
be damaged. Always replace the seat belt
if the pretensioners were deployed;
❒to clean the seat belts, wash by hand with
water and neutral soap, rinse and leave to
dry in the shade. Do not use strong de-
tergents, bleach, colouring agents or any
other substance which could damage the
belt fibres;
❒prevent the retractors from getting wet:
their correct operation is only guaranteed
if water does not get inside;
❒replace the seat belt when it shows wear
or cuts.
For maximum safety, keep
the back of your seat upright,
lean back into it and make sure the
seat belt fits closely across your chest
and pelvis. Always fasten the seat belts
on both the front and the rear seats!
Travelling without wearing the seat
belts will increase the risk of serious in-
jury and even death in the event of an
accident.
WARNING
Removing or otherwise tam-
pering with seat belt and
pretensioner components is strictly
prohibited. Any operations on these
components must be performed by
qualified and authorised technicians.
Always contact a Fiat Dealership.
WARNING
If the belt has been subject-
ed to a high level of stress,
for example after an accident, it must
be completely replaced together with
the attachments, attachment fixing
screws and the pretensioner. In fact,
even if the belt has no visible defects,
it could have lost its resilience.
WARNING
Each seat belt must be used
by only one person. Never
travel with a child sitting on the pas-
senger’s lap and a single belt to pro-
tect them both. In general, do not
place any objects between the person
and the belt.
WARNING
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 98

99
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
For optimal protection in the event of an
impact, all occupants must be seated and
wearing adequate restraint systems, in-
cluding infants and other children. This pre-
scription is compulsory in all EC countries
according to EC Directive 2003/20/EC.
Compared with an adult, a child’s head is
larger and heavier in proportion to his/her
body and the child’s muscular and bone
structures are not fully developed. There-
fore, correct restraint systems other than
adult seat belts are necessary to reduce as
much as possible the risk of injuries in case
of accident, braking or sudden manoeu-
vre.
Children must be seated safely and com-
fortably. As far as the characteristics of the
child restraint systems used, you are ad-
vised to keep children in rearward facing
restraint systems for as long as possible;
this is the most protected position in the
event of an impact.
The choice of the most suitable child re-
straint system depends on the weight of
the child; there are various types of child
restraint systems and you are advised al-
ways to choose the one that is most suit-
able for the child. When over 1.50 m in height, from the
point of view of restraint systems, children
are considered as adults and wear seat
belts normally.
In Europe the characteristics of child re-
straint systems are ruled by regulation
ECE-R44, making them compulsory and
dividing them into five weight groups:
Group 0 up to 10 kg
Group 0+ up to 13 kg
Group 1 9-18 kg
Group 2 15-25 kg
Group 3 22-36 kg
All child restraint systems must bear the
type-approval data along with the control
mark on a label firmly secured to the child
restraint system which must never be re-
moved. Lineaccessori Fiat offers child re-
straint systems for each weight group.
These devices are recommended having
been specifically designed and tested for
Fiat cars.
CARRYING CHILDREN SAFELY
A label with the dedicated
symbol indicating that it is
mandatory to deactivate the airbag
for rearward facing child restraint sys-
tems is applied on the sun visor. Al-
ways comply with the instructions on
the sun visor (see the “Airbag” section
in this paragraph).
WARNING
EXTREME HAZARD! Do
NOT place rearward facing
child restraint systems in the
front seats, before an active
airbag. Deployment of the
airbag in the event of an ac-
cident could cause fatal injuries to the
baby regardless of the severity of the
impact. It is therefore advisable to al-
ways carry children in a child restraint
system on one of the rear seats, which
is the most protected position in the
event of an impact.
WARNING
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 99

100
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
GROUP 0 and 0+
Babies up to 13 kg must be carried with
a rearward facing child restraint system of
a type as shown in figure 5 which, sup-
porting the head, does not induce stress
on the neck in the event of sudden decel-
erations.
The child restraint system is restrained by
the car seat belts - fig. 5and it must re-
strain the child with its own belts.
fig. 5F0P0310m
The figures are indicative
and for assembly purposes
only. Secure the child restraint sys-
tem according to the instructions,
which must be included with this type
of restraint system.
WARNING
fig. 6F0P0617m
GROUP 1
Children of weight from 9 to 18 kg may
be carried in forward facing child restraint
- fig. 6.
FITTING THE “UNIVERSAL” CHILD RESTRAINT SYSTEM (with seat belts)
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 100

101
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
fig. 7F0P0312m
GROUP 2
Children from 15 to 25 kg may use the ve-
hicle seat belts directly - fig. 7. In this case,
the child restraint system is used to posi-
tion the child correctly with respect to the
seat belts so that the diagonal belt section
crosses the child’s chest and not the neck,
and the lower part is snug on the pelvis
not the abdomen.
The figures are indicative
and for assembly purposes
only. Secure the child restraint sys-
tem according to the instructions,
which must be included with this type
of restraint system
WARNING
GROUP 3
For children between 22 kg and 36 kg,
there are dedicated restraint systems that
allow the seat belt to be worn correctly.
Fig. 8shows an example of correct child
restraint system positioning on the rear
seat.
Children over 1.50 m in height wear
seat belts like adults.
fig. 8F0P0313m
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 101

102
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
SUITABILITY OF PASSENGER SEATS FOR THE USE OF THE CHILD RESTRAINT SYSTEMS
Fiat Scudo conforms to the European Directive 2000/3/EC which regulates the suitability of each passenger seat position for the
fixing of universal child restraint systems as shown in the following table:
Key
U: : suitable for child restraint systems in the “Universal” category, according to European Regulation ECE R44 for the specified “Groups”.
X: no restraint system
L: suitable for specific child restraint systems available at Lineaccessori Fiat for the prescribed group.
NOTE
- In Group 0: from birth up to 13 kg, cradles cannot be located on the front passenger seat
U
U
L
U
UU
U
X
U
UU
U
L
U
UU
U
L
U
U
FIRST SEAT ROW
Side seats
Central seat
WEIGHT AND INDICATIVE AGE OF THE CHILDREN
Lower than 13 kg From 9 up to 18 kg From 15 up to From 22 up to (groups 0 and 0+) (group 1) 25 kg (group 2) 36 kg (group 3)
WEIGHT AND INDICATIVE AGE OF THE CHILDREN
Lower than 13 kg From 9 up to 18 kg From 15 up to From 22 up to (groups 0 and 0+) (group 1) 25 kg (group 2) 36 kg (group 3)
Passenger side
single seat
Bench-shaped front
seat for passenger side
Bench-shaped central
seat
SECOND/THIRD ROW SEATS
PASSENGER
SIDE AIRBAG
DEACTIVATED
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 102

103
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
FITTING THE
“UNIVERSAL ISOFIX”
CHILD RESTRAINT
SYSTEM
The vehicle can be equipped with a Uni-
versal Isofix child restraint system, a new
European standardised system for carrying
children safely. The ISOFIX fixing system
guarantees reliable, firm and quick fitting of
the child restraint system inside the vehi-
cle. Isofix child restraint systems can be fit-
ted alongside standard restraint systems.
An example of a Universal Isofix child re-
straint system for weight group 1
is shown. Due to its different fixing system,
the child restraint system must be secured
using the dedicated lower metal rings A -
fig. 10, located between the backrest and
the seat frame of the vehicle, then secure
the upper belt, called top tether, (provid-
ed along with the child restraint system) to
the dedicated ring B - fig. 11located in the
rear part of the backrest. To fix the upper
belt (top tether), raise the seat head re-
straint of the vehicle and pass the hook be-
tween its two rods. Then secure the hook
to the rear ring and tension the upper belt.
Remember that when using a Universal
Isofix child restraint system, you can only
use approved child restraint systems with
marking ECE R44 (release R44/03 or su-
perior) “Universal Isofix”. The other weight
groups are covered by specific Isofix child
restraint systems, which can be used only
if specifically approved for this car (see the
list of cars provided with the child restraint
system).
fig. 9F0P0314m
fig. 10F0P0315m
fig. 11
A
F0P0316m
If a Universal ISOFIX child
restraint system is not fixed
to all of the three fixings, the child re-
straint system will not be able to pro-
tect the child correctly. In a crash, the
child could be seriously injured or
killed.
WARNING
Fit the child restraint system
when the car is stationary.
The child restraint system is correct-
ly fixed to the brackets when you
hear the clicks. Follow the instructions
for assembly, disassembly and posi-
tioning that the manufacturer must
provide with the child restraint sys-
tem.
WARNING
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 103

104
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
SUITABILITY OF THE PASSENGER SEATS FOR THE USE OF THE ISOFIX CHILD RESTRAINT SYSTEMS
The table below shows the various installation possibilities for Isofix child restraint systems on seats fitted with Isofix anchorages
in accordance with European standard ECE 16.
Weight group Direction Child restraint Isofix position class system Isofix size side rear
Group 0 - up to 10 kg Rearward facing E IL
Group 0 - up to 13 kg Rearward facing E IL
Rearward facing D IL
Rearward facing C X (*)
Group 1 Rearward facing C X (*)
from 9 up to 18 kg Rearward facing D IL
Forward facing A IUF, IL
Forward facing B IUF, IL
Forward facing B1 IUF, IL
(*) an IL-type child restraint system can be fitted on the second row rear seats only when the passenger front seatis single.
IL: suitable for ISOFIX child restraint systems of the categories for “specific vehicles”, “restricted”, or “semiuniversal”, approved
for this type of vehicle.
IUF: suitable for forward facing Isofix child restraint systems in the Universal category and type-approved for the use in the weight
group.
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 104

105
CORRECT USE
OF THE
VEHICLE
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
VEHICLE
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CHILD RESTRAINT SYSTEMS RECOMMENDED BY FIAT
Lineaccessori Fiat recommends a complete range of child restraint systems to be fixed with the three point seat belt or the Isofix
anchorages.
GROUP 0+:
from birth to 13 kgBritax Baby Safe plus
Approval number:
E1 04301146
Britax Baby Safe plus
Approval number:
E1 04301146
+
Britax Baby Safe ISOFIX baseIt must be fitted rearward facing
with the three-point seat belt only.
If it is installed on the front pas-
senger seat, first remember to de-
activate the airbag.
It must be fitted rearward facing us-
ing the car’s Isofix anchorages and
the Isofix base.
It must be fitted in the rear outer
seats.
+
093-112 SCUDO LUM GB 9-10-2012 15:48 Pagina 105