After refitting the battery, theStop & Start system will only be active after several hours depending on the climatic conditions and the state of charge of the battery (up to about 8 hours). When
your vehicle's battery is discharged, theengine can be star ted using a slave battery(external or on another vehicle) and jump lead cables.
Starting using another
battery
First check that the slave battery has a nominal voltage of 12 V and a capacityat least equal to that of the discharged battery. Do not try to star t the engine by connecting a battery charger.
Do not disconnect the (+) terminal when the engine is running.
)Connect the red cable to the positive
terminal (+) of the flat battery A , then to the positive terminal (+) of the slave battery B. )Connect one end of the green or blackcable to the negative terminal (-) of the
slave battery B(or ear th point on the other
vehicle). )Connect the other end of the green or black cable to the ear th point Con the broken
down vehicle (or on the engine mounting). )Star t the engine of the vehicle with the good battery and leave it running for a fewminutes.
) Operate the star ter on the broken down
vehicle and let the engine run
If the engine does not star t straight away, switch off the ignition and wait a few
moments before trying again. ) Wait until the engine returns to idle then
disconnect the jump lead cables in the
reverse order.
)Disconnect the battery from the vehicle. )Follow the instructions for use provided by
the manufacturer of the charger. )Connect the battery starting with thenegative terminal (-). )Check that the terminals and connectorsare clean. If they are covered with sulphate (whitish or greenish deposit), remove themand clean them.
Charging the battery using
a battery charger
