2013 Citroen C8 tow

11 8
Changing a wheel

- Unwind the winch cable by
unscrewing the bolt using the
wheelbrace.

- Detach the spare wheel from the
rear of the vehicle and place it near
the wheel to be changed.



4. OPERATING PROCEDURE



- Remove the trim pulling at the
valve passage hole. Use the fl at
end of the towing eye as a lever.

- Loosen the wheel bolts and start
unscrewing them.

122
Changing a bulb


Rear lights



1.
Direction indicators

PY 21 W (amber).

2.
Side lights

5 W.

3.
Brake/side lights

P 21 W/5 W.

4.
Reversing lights

P 21 W.
5 - Direction indicators
PY 21 W (amber).


- Turn the bulb holder a quarter of a
turn to the left and remove it.

- Change the bulb.


The headlamps are fi tted with
polycarbonate glass with a
protective coating. Do not clean
them with a dry or abrasive cloth, nor
with a detergent or solvent product.
Use a sponge and soapy water.
In certain climatic conditions (low
temperature, humidity), condensation
inside the headlamp glass is normal;
it disappears a few minutes after the
lights are switched on.
Direction indicator side repeaters
WY 5 W (amber).


- Push the repeater rearwards and
release it from the mirror.

- Hold the connector and turn the
bulb holder a quarter of a turn to
the left.

- Turn the bulb a quarter of a turn to
the left, remove it and change it.
When refi tting, engage the repeater
towards the rear and move it towards
the front of the mirror.


Amber coloured bulbs (direction
indicators and side repeaters)
must be changed for bulbs of
identical specifi cation and colour.

5.
Fog lamps

P 21 W.
These 5 bulbs are changed from inside
the vehicle:


- open the tailgate,

- remove the air extraction grille on
the side concerned,

131
QUICK HELP
7
Having your vehicle towed

From the rear


- unclip the top of the cover using a
coin,

- screw in the removable towing eye
until it locks.


TOWING YOUR VEHICLE
Special features of the
automatic gearbox
When being towed with four wheels on
the road, it is essential to observe the
following rules:


- selector lever in position N
,

- tow the vehicle at a speed below
30 mph (50 km/h) over a distance
limited to 30 miles (50 km) maximum,

- do not add oil to the gearbox.
When towing with the engine switched
off, there is no braking or steering
assistance.
Without lifting (4 wheels on the
road)
You should always use a towbar.
The removable towing eye is inside the
engine compartment.

From the front


- unclip the cover by pressing the
bottom part,

- screw in the removable towing eye
until it locks.

Lifting (2 wheels on the road only)
It is preferable to raise the vehicle
using professional lifting equipment.

VEHICLES FITTED WITH A MANUAL
GEARBOX (diesel version)
In the case of vehicles fi tted with a
manual gearbox, the gear lever must
be in the neutral position. Failure to
observe this special condition may
result in damage to certain braking
components and the absence of
braking assistance the next time the
engine is started. Put the gear lever in neutral.
Failure to observe this rule may
result in damage to certain
components.

Diesel technical data

132



This table presents the Model Codes



Engine,
__xxx__ Diesel
2.0 HDi PEF
__RHR__


Number of seats,
xx_____


7 seats maximum
EA_____

Base model: 5 individual seats



8 seats maximum
EB_____


Type of gearbox
, _____xx



Manual





(6-speed)
_____H





Automatic





(6-speed)
_____J

Category and type of towing device A 50 X

Part number, instructions concerning
fi tting R 06-0049

Diesel technical data

134

DIESEL DIMENSIONS, WEIGHTS AND TOWING LOADS
(in mm - in kg)

Model codes


EARHRH



EBRHRH



EA___H


EA___J



EB___H


EB___J




7 seats
8 seats
7 seats
8 seats

Engine


2.0 HDi PEF



2.0 HDi PEF


Wheelbase(s) (at full load)
2 823
-
-
on Axle 1
1 570
-
-
on Axle 2
1 548
-
-
Length
4 727
Width
1 850
Height at kerb weight
without roof bars
1 745 to 1 759
with fi xed roof bars
1 854 to 1 863
Kerb weight
1 854 to 1 957
1 818 to 1 983
-
-
on Axle 1
1 121 to 1 157
1 117 to 1 161

-
-
on Axle 2
733 to 800
701 to 822
-
-

135


Diesel technical data

TECHNICAL DATA
8

The GTW and towing load values indicated are valid up to a maximum altitude of 1 000 metres; the towing load mentioned
must be reduced by 10 % for each additional 1 000 metres of altitude.
The speed of a towing vehicle must not exceed 60 mph (100 km/h) (comply with the legislation in force in your
country).
High exterior temperatures may result in a reduction in the performance of the vehicle in order to protect the engine; when
the exterior temperature is above 45 °C, restrict the towed weight.
Model codes


EARHRH



EBRHRH



EA___H


EA___J



EB___H


EB___J




7 seats
8 seats
7 seats
8 seats

Engine


2.0 HDi PEF



2.0 HDi PEF


Gross train weight (GTW)
3 945
-
-
Gross vehicle weight (GVW)
2 530
-
-
on Axle 1
1 256
1 263
-
-
on Axle 2
1 274
1 267
-
-
Gross weight
on Axle 1
1 270
-
-
on Axle 2
1 300
-
-
Gross towed weight
1 850
-
-
Gross weight of unbraked trailer
750
-
-
Gross weight on towing attachment
76
-
-

136
Dimensions

To fi nd out more about dimensions: refer to the "Dimensions, weights and
towing loads" section for diesel engines in chapter 8.

9.9
05
Press NAVto display the"Navigation - guidance " menu.
TOWARDS A NEW DESTINATION
NAVIGATION - GUIDANCE
SELECTING A DESTINATION

Select "Select destination
" and confi rm, then select " Enter an address"and confi rm.

Select the " Country
" function then confi rm.

Select "Town" function then confi rm to enter the destination town.

Select the letters in the name of the
town one at a time, confi rming each one
with the dial.
Selection the town from the list offered, then confi rm.

A pre-set list (by entering the fi rst few letters) of the towns in the country selected can be accessed directly by selecting and confi rming " List" on the screen. t
Turn the dial and select "OK" thenconfi rm.
If possible, enter the "
Road
" and "N°/X"
information in the same way.

Select "Archive
" to save the address entered in a contact fi le.
The s
ystem allows up to 400 contact fi les to be recorded.
Confi rm " OK
" to start guidance.
Select the guidance criteria: "Fastest
route", " Shortest route" or optimised "Distance/Time ", then select thedesired restriction criteria: "With tolls","With Ferry", or "Traffi c info" thenconfi rm "OK".