Page 58 of 288
Comfort
56
With the heating /
ventilation s
ystem
)Put the temperature and air flow controls to
t
he dedicated marked position. )Put the air intake control to the "Exterior air intake" position (manual control to the right or electric control with indicator lamp off). )Put the air distribution control to the"Windscreen" position.
Front demist - defrost
These markings on the control panel indicate the control positions for rapid demisting or
defrosting of the windscreen and side windows.
With the manual air
conditioning system
)
Put the temperature and air flow controls to
t
he dedicated marked position. ) Put the air intake control to the "Exterior air
intake" position
(manual control to the right or electriccontrol with indicator lamp off). ) Put the air distribution control to the "Windscreen" position. )
Switch on the air conditioning by pressingthe "A/C"
button; the associated green
warning lamp comes on.
With Stop & Star t, when the demisting, air conditioning and air flow functionsare activated, STOP mode is not available.
Page 70 of 288
Access
68
Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switched
on, this code must be recognised in order for
startin
g to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
In the event o
f a fault, you are
informed by illumination of this
warning lamp, an audible signal and
a message in the screen.
Ignition switch
- Position 1: Stop
- Position 2: Ignition
- Position 3: Starting
Starting the vehicle
)Inser t the key in the ignition switch.
The system recognises the star ting code. )Turn the key fully towards the dashboard toposition 3 (Starting). )When the engine star ts, release the key.
Locating your vehicle
) Press the closed padlock to locate your locked vehicle in acar park.
This is indicated b
y lighting of the cour tesylamps and flashing of the direction indicators
for a few seconds.
In this case,
your vehicle will not start; contact
a CITROËN dealer as soon as possible.
Keep safely the label attached to the keys given
to you on acquisition of the vehicle.
Page 71 of 288
4
Access
69
Remote control problem
Reinitialisation
) Switch off the ignition. )
Turn the key to position 2 (Ignition on)
. )
Press the closed padlock immediately for a
few seconds. ) Switch off the ignition and remove the key
from the ignition switch.
The remote control is full
y operational again.
Changing the battery
Battery ref.: CR1620 / 3 volts.
If the batter
y is flat, you are informed
by illumination of this warning lamp,an audible signal and a message in
the multifunction screen.
) Unclip the casing using a coin at the notch. )
Slide the flat battery out of its location. )
Slide the new battery into its location
observing the original direction. ) Clip the casing. )
Reinitialise the remote control.
Switching the vehicle off
Key reminder
If the key is left in the ignition switch, anaudible signal sounds when the driver's door is opened.
Do not attach any heavy objects to the key as this could weigh down on it whenin the ignition switch and cause a fault. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
v
ehicle. ) First of all, use the key in the lock to unlock
or lock your vehicle. ) Then, reinitialise the remote control.
If the problem persists, contact a CITROËNdealer as soon as possible.
)Immobilise the vehicle. )Turn the key fully towards you toposition 1 (Stop). )Remove the key from the ignition switch.
Page 77 of 288
4
Access
75
Doors
Opening
From outside
)After unlocking the vehicle using theremote control or the key, pull the door handle.
From inside
)
Pull the front door control to open the door;
this unlocks the vehicle completely. ) Pull the rear door control to open the door;
this unlocks only the door opened.
Closing
- When the engine is running, this
warning lamp comes on, accompanied
by a message in the multifunction
screen for a few seconds,
When a door or the boot is not closed correctly:
- When the vehicle is movin
g
(speed higher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by an
audible signal and a message in the multifunction screen for a few seconds.
Version with deadlocking
The interior door controls do not operate when
the vehicle is deadlocked.
Page 80 of 288
Access
78
Boot
)After unlocking the vehicle using theremote control or the key, pull the handleand raise the tailgate.
)
Lower the tailgate using the interior grab
handle.
-when the engine is running, this
warning lamp comes on, accompanied
by a message on the multifunction
screen for a few seconds,
Tailgate release
Unlocking
)Fold back the rear benchseat to gainaccess to the lock from inside the boot. )Insert a small screwdriver into hole Aof thelock to unlock the tailgate.
I
f the tailgate is not closed correctly:
Opening
Closing
-when the vehicle is moving
(speed above 6 mph (10 km/h)), this warning lamp comeson, accompanied by an audible signal and
a message on the multifunction screen for a few seconds.
System for mechanical unlocking of the boot
in the event of a battery or central lockingmalfunction.
Page 86 of 288
Visibility
84
Manual guide-me-home
li
ghting
The temporary illumination of the dipped beam
headlamps after the vehicle's ignition has been switched off makes the driver's exit easier when
the light is poor.
Switching on
)
With the ignition off, "flash" the headlamps using the lighting stalk. )
A further "headlamp flash" switches thefunction off.
Switching off
The manual guide-me-home lighting switches
off automatically after a set time.
In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.
Lighting on audible warning
When the ignition is switched off, allof the lamps switch off automatically, unless guide-me-home lighting isactivated.
If the lighting is switched on manually after switching off the ignition, there is an audible signal when a front door is opened to warn the driver that theyhave forgotten to switch off the vehicle'slighting, with the ignition off.
Page 87 of 288
5
Visibility
85
Association with the automatic"Guide-me-home" lighting
Association with the automatic illumination of headlamps provides "guide-me-home" lighting with the following additional options:
- selection of the lighting duration to 15, 30 or 60 seconds in the functions that can be set
in the vehicle configuration menu (except in
the case of the monochrome screen A, for
which the duration is set: 60 seconds),
- automatic activation of "guide-me-home"lighting when automatic illumination of headlamps is in operation.
Operating fault
In the event of a fault with the sunshine sensor, the lighting come on, this warning lamp is displayed in theinstrument panel and/or a message appears in
the screen, accompanied by an audible signal.
Contact a CITROËN dealer or a qualifiedworkshop.
In fog or snow, the sunshine sensor may detect sufficient light. Therefore, thelighting will not come on automatically. Do not cover the sunshine sensor, coupled with the rain sensor andlocated in the centre of the windscreen behind the rear view mirror; the associated functions would no longer be controlled.
Automatic illumination of headlamps
Activation
)Turn ring to the "AUTO"
position. Theautomatic illumination of headlamps is accompanied by a message in the screen.
Deactivation
)Turn ring to a position other than "AUTO" .
Deactivation is accompanied by a message
in the screen. The sidelamps and dipped beam headlamps
are switched on automaticall
y, without any
action on the par t of the driver, when a low level
o
f external light is detected or in certain cases
of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.
Page 110 of 288
Safety
108
Direction indicators Selection of the left or right direction indicators
to signal a change of direction of the vehicle.
)Left: lower the lighting stalk beyond thepoint of resistance. )Right: raise the lighting stalk beyond thepoint of resistance.
"Motorway" function
)Press briefly upwards or downwards,
without going beyond the point of resistance; the direction indicators will flash 3 times.
Hazard warning lamps
)
Press this button, the direction indicatorsflash.
They can operate with the ignition off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lamps come on automatically.
They switch off automatically the first time you accelerate. )You can also switch them off by pressingthe button.
A visual warnin
g by means of the direction
indicators to alert other road users to a vehiclebreakdown, towing or accident.
