Page 145 of 288
10
Checks
143
Checking levels
Oil level
The check is carried out either when
the ignition is switched on using theoil level indicator in the instrument
panel, or using the dipstick.
Engine oil change
Refer to the MAINTENANCE AND WARR ANT Y GUIDE for details of the inter val
for this operation.
In order to maintain the reliabilit
y of the engine and emission control system, the use of additives in the engine oil is prohibited.
It is normal to top up the oil levelbetween two ser vices (or oil changes).CITROËN recommends that you check
the level, and top up if necessary, every3 000 miles (5 000 kms). After topping up the oil, the check when switching on the ignition with the oil level indicator in the instrument panel is not valid during the 30 minutes after topping up. It will onl
y be correct if the vehicle is on level ground and the engine has been off for more
than 30 minutes.
Check all of these levels re
gularly, in line with the MAINTENANCE AND WARR ANT Y GUIDE. Top them up if necessary, unless other wise indicated.
If a level drops significantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.
Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could star t atany time (even with the ignition off).
Oil specifi cation
The oil must be the correct grade for your
engine and conform to the manufacturer'srecommendations.
Th
e brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.
Brake fluid level
Changing the fl uid
Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of the intervalfor this operation.
Fluid specifi cation
The brake fluid must conform to themanufacturer's recommendations and meet
the DOT3 or DOT4 standard.
Page 148 of 288
Checks
146
Manual gearbox
The gearbox does not require anymaintenance (no oil change).
Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for the details
of the level checking inter val for thiscomponent.
Automatic gearbox
The gearbox does not require anymaintenance (no oil change).
R
efer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of
the level checking inter val for thiscomponent.
Parking brake
If excessive travel or a loss of effectiveness of this system isnoticed, the parking brake must bechecked, even between two ser vices.
Electronic gearbox
The gearbox does not require anymaintenance (no oil change).
Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of thechecking inter val for this component.
Brake pads
Brake disc wea
r
Brake wear depends on the style
of driving, par ticularly in the case
of vehicles used in town, over shor t
distances. It may be necessary to have
the condition of the brakes checked,
even between vehicle services.
For in
formation on checking brake
disc wear, contact a CITROËN dealer
or a quali
fied workshop.
Only use products recommended by
CITROËN or products of equivalent quality and specification. In order to optimise the operationof units as impor tant as the braking system, CITROËN selects and offersvery specific products.
Unless there is a leak in the circuit, a drop in
the brake fluid level indicates that the brake
pads are worn.
Checking this system must be done by aCITROËN dealer or a qualified workshop.
After washing the vehicle, dampness,or in wintry conditions, ice, can form on the brake discs and pads: braking efficiency may be reduced. Make lightbrake applications to dry and defrost the brakes.
Page 157 of 288
11
Practical information
155
Removing a wheel
List of operations
)
Remove the bolt cover from each of the bolts using the tool 3(with alloy wheels
only). ) Fit the security bolt socket 4
on thewheelbrace 1to slacken the security bolt(if your vehicle has them). )
Slacken the other bolts using the
wheelbrace 1only.
Parking the vehicle
Immobilise the vehicle where it does not block traffic: the ground must be level,stable and not slippery. Apply the parking brake, switch off theignition and engage first gear *
to lock the wheels. If necessary, place a chock under thewheel diagonally opposite the wheel to be changed. It is imperative that you ensure that the occupants get out of the vehicle andwait where they are safe.Never go underneath a vehicle raisedusing a jack; use an axle stand.
*
position R
for an electronic gearbox; position P
for an automatic gearbox.
Page 161 of 288
11
Practical information
159
Snow chains
In wintry conditions, snow chains improve traction as well as the behaviour of the vehicle when
braking.
The snow chains must be fitted only to the front wheels. They must never be fitted to "space-saver" type sparewheels.
Take account of the legislation in force in your country on the use of snowchains and the maximum running speedauthorised.
Avoid driving on roads that have beencleared of snow, to avoid damaging your vehicle's tyres and the road surface. It is recommended that before you leave, you practise fitting the snowchains on a level and dry surface.If your vehicle is fitted with alloy wheels, check that no par t of the chain or itsfixings is in contact with the wheel rim. Use onl
y the chains designed to be fitted to the
type of wheel fitted to your vehicle:
Original tyre size Maximum link size.
1
85/65 R15 9 mm
195/55 R16
205/45 R17 not chainable
For more information on snow chains
, contact a
CITROËN dealer or a qualified workshop.
Advice on installation
)
If you have to fit the chains during ajourney, stop the vehicle on a flat surface on the side of the road. )
Apply the parking brake and position anywheel chocks to prevent movement of your
vehicle. ) Fit the chains following the instructions provided by the manufacturer. )
Move off gently and drive for a few moments, without exceeding 30 mph(50 km/h). )
Stop your vehicle and check that the snowchains are correctly tightened.
Page 166 of 288
Practical information
164
Rear lamps
1.Brake / sidelamps (P21/5W).2.Direction indicators (PY21W amber)3. Foglamp, right-hand side (PR21W red)Reversing lamp, left-hand side (P21W).
Changing bulbs
These four bulbs are changed from inside the boot: )spread the four tabs and remove the bulbholder,
)turn the bulb a quar ter of a turn and change it.
To r efit, carry out these operations in reverse order.
Take care to engage the lamp unit in its guides,
while keeping it in line with the vehicle.
) open the boot, )
remove the access flap from the
corresponding side trim panel, )
unscrew the butterfly nut securing the lamp unit, )
unclip the lamp unit connector, )
extract the lamp unit carefully pulling in its
middle towards the outside,
Amber or red bulbs, such as thosefor the direction indicators and rear foglamp, must be replaced by bulbs of the same rating and colour. The lamps on the tailgate are dummy units. They are there for aesthetic purposes only.
Page 167 of 288
11
Practical information
165
Changing the number plate lamp
bulbs (W5W)
)Insert a thin screwdriver into one of theouter holes of the lens. )Push it outwards to unclip.
)Remove the lens. )Pull the bulb out and change it.
Third brake lamp (4 W5W bulbs)
) Open the boot. )
Remove the plugs A
on the inner panel. )
Push on the centre of the lamp using
tw
o screwdrivers to lever it outwards. ) Disconnect the connector and if necessary
the screenwash pipe from the lamp. ) Turn the bulb holder for the faulty bulb aquar ter of a turn. )
Pull out the bulb and change it.
To r e f i t , c a r ry out these operations in reverseorder.
Page 181 of 288
11
Practical information
179
Towing the vehicle
Access to the tools
The towing eye is installed in the boot under
the floor.
To gain access to it: )open the boot, )raise the floor, )remove the polystyrene storage box, )remove the towing eye from the holder. Procedure for havin
g your vehicle towed or for towing another vehicle using a removable towing eye.
General recommendations
Obser ve the legislation in force in your country. Ensure that the weight of the towing vehicle is higher than that of the towed vehicle. The person at the wheel of the towed vehicle must have a valid driving licence.When towing a vehicle with all four wheels on the ground, always use an approved towingbar; rope and straps are prohibited. When towing a vehicle with the engine off, there is no longer any power assistance for braking or steering. In the following cases, you must always call on a professional recovery service: - vehicle broken down on a motor way or fast road, - 4 wheel drive vehicle, - when it is not possible to put the gearbox into neutral, unlock the steering, or release theparking brake, - towing with only two wheels on the ground, - where there is no approved towing bar available...
Page 182 of 288
Practical information
180
To w i ng your vehicle
)On the front bumper, unclip the cover by pressing at the bottom. )Screw the towing eye in fully. )Install the towing bar. )Place the gear lever in neutral (position Nfor an electronic or automatic gearbox).
)On the rear bumper, unclip the cover by pressing at the bottom. )Screw the towing eye in fully. )Install the towing bar. )Switch on the hazard warning lamps on both vehicles. )Move off gently and drive for a shor tdistance only.
To w i ng another vehicle
Failure to obser ve this special condition could result in damage to cer tain components (braking, transmission...) and the absence of braking assistance the next time the engine is star ted.
)
Unlock the steering by turning the key one
notch in the ignition switch and release the
parkin
g brake. ) Switch on the hazard warning lamps onboth vehicles. )
Move off gently and drive for a shor t
distance only.
