.
.
Contents
Direction indicators 105
Hazard warning lamps 105
Horn 106
Emergency or assistance call 106
Braking assistance systems 107
Tr ajectory control systems 108
Front seat belts 109
Airbags 111
Safety
Parking brake 115
6-speed manual gearbox 115
Gear effi ciency indicator 116
Electronic gearbox 117
Automatic gearbox 121
Stop & Start 124
Hill start assist 127
Speed limiter 128
Cruise control 130
Rear parking sensors 132
Reversing camera 134
Driving
Emergency or assistance 195
eMyWay 197
Audio system 251
Audio and telematics
Alphabetical index
Bonnet 136
Running out of fuel (Diesel) 137
Petrol engines 138
Diesel engines 139
Checking levels 140
Checks 142
Checks
Te m p o r a ry puncture repair kit 144
Changing a wheel 149
Snow chains 156
Changing a bulb 157
Changing a fuse 164
Battery 171
Energy economy mode 174
Changing a wiper blade 175
To w i ng the vehicle 176
To w i ng a trailer 178
Audio pre-equipment 180
Accessories 182
Practical informationTechnical data
Petrol engines 184
Petrol wei
ghts 185
LPG engines 187
LPG weights 188
Diesel engines 189
Diesel weights 191
Dimensions 193
Identifi cation markings 194
Visual search
Driving
124
The Stop & Star t system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine restar ts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
-with a manual gearbox , at speeds below
12 mph (20 km/h), when you put the gear lever into neutral, and you release theclutch pedal. - with a 5 or 6-speed electronic gearbox
, at speeds below 5 mph (8 km/h), when you press the brake pedal or put the gear lever in position N.
Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the engine goes into standby:
A time counter calculates the sumof the periods in STOP mode
during a journey. It rests itself
to zero every time the ignition is switched on with the key.
Special cases: STOP mode not available
STOP mode is not invoked when:
- the driver's door is open,
- the driver's seat belt is not fastened,
- the vehicle has not exceeded 6 mph
(10 km/h)since the last engine star t using the key,
- the engine is needed to maintain acomfor table temperature in the passenger compartment,
- demisting is active,
- some special conditions (battery charge, engine temperature, braking assistance,
ambient temperature...) where the engine isneeded to assure control of a system.
The "ECO"warning lamp flashes for
a few seconds then goes off.
This operation is per fectly normal.
Stop & Start
Never refuel with the engine in STOPmode; you must switch off the ignition with the key.
For your comfor t, during parkingmanoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear.STOP mode does not affect the functionality of the vehicle, such as for example, braking, power steering...
9
Driving
127
Hill start assist
System which holds your vehicle temporarily (approximately 2 seconds) when star ting on a slope, the time it takes to move your foot from
the brake pedal to the accelerator pedal.
This
function is only active when:
- the vehicle is completely stationary, with your foot on the brake pedal,
- cer tain conditions on a slope are met,
- with the driver’s door closed.
The hill start assist function cannot bedeactivated.
On an ascendin
g slope, with the vehicle
stationary, the vehicle is held momentarilywhen you release the brake pedal:- provided you are in automated mode(position A) or in manual mode (position AM )
on an electronic gearbox.
Operating fault
If a malfunction of the system occurs, these
warning lamps come on. Contact a CITROËN
dealer or a
qualified workshop to have the system checked. On a descendin
g slope, with the vehicle
stationary and reverse gear engaged, thevehicle is held momentarily when you
release the brake pedal.
Do not leave the vehicle while it is being held in the hill star t assist phase. If you need to leave the vehicle withthe engine running, manually applythe parking brake then ensure that the parking brake warning lamp is on (not
flashing) in the instrument panel.
Operation