Tread Wear Indicators....................523
Tire Safety Information .....................504
Tongue Weight/Trailer Weight ................558
Torque Converter Clutch ....................484
Towing ............................... .552
24-Hour Towing Assistance ................163
Disabled Vehicle ....................... .598
Guide .............................. .557
Recreational .......................... .566
Weight .............................. .557
Towing Assistance ........................ .163
Traction ............................... .485
Traction Control ......................... .495
Traction Control Switch .....................495
Trailer Sway Control (TSC) ..................500
Trailer Towing .......................... .552
Cooling System Tips .....................565
Hitches ............................. .556
Minimum Requirements ..................559 Tips................................
.564
Trailer and Tongue Weight .................558
Wiring .............................. .563
Trailer Towing Guide ...................... .557
Trailer Weight ........................... .557
Transmission ........................... .629
Automatic ........................... .472
Fluid ............................... .629
Transmitter Battery Service (Remote Keyless Entry). . .27
Transmitter, Garage Door Opener (HomeLink®). . . .260
Transmitter, Remote Keyless Entry (RKE) .........20
Transporting Pets .........................116
Tread Wear Indicators ..................... .523
Trip Odometer .......................... .315
Turn Signals ............................ .315
UCI Connector .......................... .381
Uconnect® (Hands-Free Phone) ...............149
Umbrella Holder ......................... .284
694 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this vehicle’s
electronic system to provide immunity to radio frequency signals.
Mobile two-way radios and telephone equipment must be installed
properly by trained personnel. The following must be observed
during installation.
The positive power connection should be made directly to the
battery and fused as close to the battery as possible. The negative
power connection should be made to body sheet metal adjacent to
the negative battery connection. This connection should not be
fused.
Antennas for two-way radios should be mounted on the roof or the
rear area of the vehicle. Care should be used in mounting antennas
with magnet bases. Magnets may affect the accuracy or operation
of the compass on vehicles so equipped.The antenna cable should be as short as practical and routed away
from the vehicle wiring when possible. Use only fully shielded
coaxial cable.
Carefully match the antenna and cable to the radio to ensure a low
Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than normal
may require special precautions.
All installations should be checked for possible interference be-
tween the communications equipment and the vehicle’s electronic
systems.
