2013 CHRYSLER 300 SRT Owners Manual

Trunk Release Remote Control.................42
Turn Signals ............................ .204
UCI Connector .......................... .349
Uniform Tire Quality Grades .................553
Universal Consumer Interface (UCI) Connector . . . .349
Unleaded Gasoline ....................... .440
Untwisting Procedure, Seat Belt ................53
Vanity Mirrors ...........................112
Vehicle Certification Label ...................447
Vehicle Identification Number (VIN) .............6
Vehicle Loading ......................... .417
Vehicle Modifications/Alterations ...............7
Vehicle Storage .......................... .362
Vehicle Theft Alarm (Security Alarm) ............18
Viscosity, Engine Oil ...................... .481Warning Flasher, Hazard
....................452
Warning Lights (Instrument Cluster Description) . . .301
Warnings and Cautions .......................6
Warranty Information ..................... .551
Washer Adding Fluid ......................... .490
Washers, Windshield .......................211
Washing Vehicle ......................... .504
Water Driving Through ....................... .391
Wheel and Wheel Trim .....................506
Wheel and Wheel Trim Care .................506
Wind Buffeting ............................42
Window Fogging ........................ .363
Windows ................................39
Power ................................39
Windshield Defroster .......................97
10
INDEX 575

Windshield Washers...................... .209
Fluid ............................... .490
Windshield Wiper Blades ....................489
Windshield Wipers ....................... .209
Wiper Blade Replacement ...................489
Wipers, Intermittent ...................... .210
Wipers, Rain Sensitive ..................... .212
576 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this vehicle’s
electronic system to provide immunity to radio frequency signals.
Mobile two-way radios and telephone equipment must be installed
properly by trained personnel. The following must be observed
during installation.
The positive power connection should be made directly to the
battery and fused as close to the battery as possible. The negative
power connection should be made to body sheet metal adjacent to
the negative battery connection. This connection should not be
fused.
Antennas for two-way radios should be mounted on the roof or the
rear area of the vehicle. Care should be used in mounting antennas
with magnet bases. Magnets may affect the accuracy or operation
of the compass on vehicles so equipped.The antenna cable should be as short as practical and routed away
from the vehicle wiring when possible. Use only fully shielded
coaxial cable.
Carefully match the antenna and cable to the radio to ensure a low
Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than normal
may require special precautions.
All installations should be checked for possible interference be-
tween the communications equipment and the vehicle’s electronic
systems.

300