2013 AUDI A4 SEDAN wheel bolts

256 What do I do now?
-Do not raise the vehicle unti l yo u are
sure the jack is securely engaged.
- Passengers must not remain in the ve­
h icle when it is jacked up.
- Make sure that passengers wait in a
safe p lace away from the vehicle and
well away from the road and traffic.
- Make sure jack position is correct, ad­
just as necessary and then continue to ra ise the jack.
CD Note
Do not lift the vehicle by the sill. Position
the vehicle jack only at the designated lift­
ing points on the sill. Otherwise, your vehi­
cle will be damaged.
Taking the wheel off/installing the spare
tire
Follow these instructions step-by-step for
changing the wheel .
Fig. 187 Changing a w hee l: usi ng the screwdriver han ·
dle (with the blade r~mo ved) to turn th e bo lts
Fig. 188 C hangin g a w hee l: alig nmen t pin inside the
to p hole
After you have loosened a ll wheel bolts and
ra ised the veh icle off the ground, remove and
replace the wheel as follows:
Removing the wheel
.,. Remove the topmost whee l bolt completely
with the
hexagonal socket in the screwdriv­
er handle (vehicle tool kit)¢
fig. 187 and
set it aside on a
clean surface .
.,. Screw the threaded end of the
alignment
pin
from the tool kit hand-t ight into the
empty bolt hole ¢
fig. 188.
.,. Then remove the other wheel bolts as de ­
scribed above.
.,. Ta ke off the wheel leaving the alignment
pin in the bolt hole
c::>(D .
Putting on the inflatable spare tire
.,. Push the spare tire over the alignment p in.
.,. Screw on the wheel bolts and tighten them
slightly using the hexagonal socket .
.,. Remove the alignment pin and insert and
tighten the remain ing wheel bolt slightly
like the rest.
.,. Turn the jack hand le counter -clockwise to
lower the veh icle until the jack is fully re­
leased .
.,. Use the wheel bolt wrench to tighten all
wheel bolts firmly
c::> page 254 . Tighten
them
in a crisscross pattern, from one bolt
to the (approximately) opposite one, to keep
the wheel centered .
.,. Perform the steps required after changing
the wheel
c::> page 253, After changing a
wheel.
T he hexagonal socket ma kes it easier to re­
move the wheel bolts from the rim. Care
should be tak en when removing the reversible
blade .
CD Note
When removing or installing the wheel,
the rim could hit the brake rotor and dam­
age the rotor. Work carefu lly and have a
second person to help you.
(D Tips
-When mounting tires with unidirectional
tread design
make sure the tread pat ­
tern is pointed the right way
c::>page257. ..,.

-The wheel bol ts should be clean and easy
to tu rn. Check for d irt and corrosion on
t h e mat ing s urfaces of both the whee l
and t he hu b. Remove a ll dirt from these
su rfaces before remo unt ing t he wheel.
- Do n ot use the hexagonal socket in the
screwdriver ha ndle to loosen or tig hten
t h e wheel bo lts .
Tires with unidirectional tread design
Tires with unidirectional tread design must be
mounted with their tread pattern pointed in the right direction.
Using a spare tire with a tread pattern
intended for use in a specific direction
When using a spare tire w ith a t read patte rn
i ntended for use in a specific direction, please
n ot e th e follow ing:
- The direction of rotation is ma rked by an
ar­
row on the s ide of the t ire .
-If the spare t i re has to be installed in the in­
correct di rection, use the spare tire only
temporar ily since the t ire will not be able to
achieve its optimum perfo rma nce character­
ist ics with r ega rd to aquaplani ng, noise and
wea r.
- We recommend that you pay particular at ­
tent io n t o this fact du ring wet weathe r and
t h at you adjus t your spee d to matc h road
cond itio ns.
- Replace th e flat tire w ith a n ew one and
have it ins talled o n your ve hicle as soon as
poss ible to re st ore the hand ling advant ages
of a uni direct io na l t ire .
Notes on wheel changing
Please rea d the information ¢ page 241, New
tires and replacing tires and wheels
if you are
going to use a spare t ire which is different
from the tires on your ve hicle.
Afte r you change a tire :
-Check the tire pressure on the spare imme­
diately after installation . What do I do now? 257
- Have the wheel bolt tightening torque
checked with a torque wrench as soon a s
possible by your authorized Audi dealer or
a qualified workshop .
- With steel and alloy wheel rims , the wheel
bolts are cor rectly tightened at a torque of
90 ft lbs. (120 Nm ).
- If you notice that the wheel bolts are cor·
roded and difficult to turn while changing
a tire, they should be replaced before you
check the tightening torque .
- Replace the flat tire with a new one and
have it installed on your veh icle as soon as
possible. Remount the wheel cover.
Until then , drive with extra care and at re·
duced speeds.
A WARNING
-
- If you are going to equ ip your ve hicle
w it h tires o r rims which differ from those
which w ere fac to ry installed, t hen be
s ure to re ad the information ¢
page 241 ,
N ew tire s and re pla cing tires and
whee ls.
- Always make s ure th e da maged wheel o r
eve n a flat t ire and t he j ack and to ol ki t
a re p roperly secu red in the lugg age com­
pa rtment an d are no t loose in the pas ­
sen ger compartment.
- In an accident or sud den maneuver they
co uld f ly forwa rd, in ju ring a nyo ne in the
ve hicle .
-A lways s to re damage d wheel, jack and
too ls sec urely in the luggage compa rt­
ment . Othe rwise, in a n accident o r su d­
den maneuver they co uld f ly forwa rd,
causing inju ry to passengers in the ve hi·
cle.
~ Note
Do not use comme rcially ava ilab le tire
sea lants. Ot herwise, t he e lectr ica l comp o­
n ents of t he tire pressu re monitoring sys­
t em * w ill no longe r work pr operly and the
senso r fo r th e tire pressure moni tor ing
syst em* will have to be replac ed by a
qu alified wor kshop . •
•

288 Index
Tires and wheels
Checking tire pressure .............. 236
Cold t ire inflation pressure ... .. .... . 234
Dimensions .............. .. .. .... . 241
General notes . ............. .. .... . 230
Glossary of tire and loading terminolo -
gy .. .. .. .. ... .... ...... .. .. .. .. . 231
New tires and wheels .......... .. .. . 241
Replacing . . . . . . . . . . . . . . . . . . . . . . . . 242
Snow chains .. ........... .. .. .... . 246
Tires and vehicle load limits . ... .. .. . 238
Wheel bolts .............. ... .... . 247
Winter tires .............. ... .... . 245
Tire service life . ........... .... .... . 240
Tool kit . .. ................. .. .... . 251
Torn or frayed safety belts ............ 139
Touch-up paint . .. ...... .... ... .. .. . 202
Towing Front eyelet ............. .. .. ..... 265
Rear eyelet ... ........... .... .... . 265
Tow truck procedures .......... .. ... 264
TPM5 Tire pressure monitoring system .. ... 249
Trailer towing ... .......... .. .. .. .. . 196
Operating instructions ......... .. .. . 196
Technical requirements . . . . . . . . 196, 197
Tips ..... .. ................ ..... . 198
Transmission ............ .. .. .. .. .. .. 83
6-speed manual transmission . . . . . . . . . 83
multitronic . . . . . . . . . . . . . . . . . . . . . . . . 83
S tronic .... ................ ..... .. 89
tiptronic . . . . . . . . . . . . . . . . . . . . . . . . . . 83
Transmission malfunction (ind icator lamp) 95
Transmission malfunction (indicator light) 88
Transport Canada ................... 134
Travel mode ... .. ...... .... ... .. .. .. 46
Tread Wear Indicator (TWI) ... ... .. .. . 240
Trip computer
Fu el consumption . . . . . . . . . . . . . . . . . . 25
Mileage .................... ..... .. 25
Sing le-trip memory ........ ..... .. .. 25
Total-trip memory . . . . . . . . . . . . . . . . . . 25
Trip odometer ............. .... .... .. 12
Trunk
refer to Luggage compartment . . . 64, 132
Trunk escape handle ................ .. 40 Trunk
lid
refer to Rear lid . ................. .. 39
Turn signals . .... .. ............. ..... 45
Warning/indicator lights .......... .. . 23
u
Undercoating ..... ................ . 204
Unfastening safety belts ......... .. ..
141
Unidirectional tires .............. .... 230
Uniform tire quality grading .......... 244
Unlocking Rear lid ... .... .. ................. . 39
Unlocking/locking at the lock cylinder . . . . . . . . . . . . . . . . . . 3 7
by remote control ................ .. 35
with the centra l locking switch ..... .. . 36
with the convenience key ...... .. .. .. . 36
Use of jumper cables ............ .... 263
V
Valet parking ...... ................ .. 43
Vanity mirrors ..... ............. ..... 49
Vehicle-care products . . . . . . . . . . . . . . . . 199
Vehicle electrical system . . . . . . . . . . . . . . 17
Vehicle Identification Number (VIN) .. .. 268
Vehicle jack . .. .. .. ... .......... .... 255
Vehicle key . . . . . . . . . . . . . . . . . . . . . . . . . 33
Vehicle literature .. ............. ...... 5
Vehicle tool kit . ... ....... ...... .. .. 251
Ventilation . .. .. .. ............. .. .. . 68
w
Warning/indicator lights . . . . . . . . . . 10 , 13
Airbag system ... ................ .. 20
Anti-lock braking system (ABS) . .. .. .. . 19
Brake system .. .. ... .......... .. .. . 15
Electromechanical parking brake . .. .. . 16
Electronic power control . . . . . . . . . . . . . 20
Electronic Stabilization Control (ESC) .. . 19
Generator . . . . . . . . . . . . . . . . . . . . . . . . . 17
Malfunction Ind icator Lamp (MIL) .... . 20
Safety belt . . . . . . . . . . . . . . . . . . . . . . . . 17
Safety systems . . . . . . . . . . . . . . . . . . . . . 20
Turn signals ..... ................ .. 23
Warranty coverages ................. 272

Washer reservoir ................... 229
Washing .................... ... ... 199
Automatic car wash ....... .. .. .. .. . 200
by hand .. .. ............. .. .. .. ... 200
General information 199
with a power washer ......... ... .. . 201
Waxing . ...... ................ .... 201
Wear indicator ............ .... .. ... 240
Weights . .. .. .... ............. .. .. . 268
What happens if you wear your safety belt
too loose? ... ... .. .. ...... .. .. .. .. . 140
What happens to unbelted occupants? .. 137
What impairs driving safety? . .. .. .. .. . 127
What should I do after changing a
wheel? .. .. ... ...... ............. .. 237
What should I do after replacing wheels? 237
Wheel bolts Torque ... .. ................. .. ... 247
Wheels . .. ... ...... ............. .. 230
Cast alloy .. ... .. .. ...... .. .. .. .. . 204
Checking tire pressure .......... .... 236
Cold tire inflation pressure . .. .. .. .. . 234
General notes ............ .. .. .. ... 230
Glossary of tire and loading termino lo-
gy ... ..... .. ................ .... 231
New tires and wheels ......... ... .. . 241
T ires and vehicle load limits .. .. .. .. . 238
When must a safety belt be rep laced? . . 139
When must the airbag system be inspect-
ed? .... ... ... ...... ............. .. 155
When should I adjust the tire pressures? 237
When should I check the tire pressures? . 237
Where are lower anchorages located? . . . 180
Where can I find the tire pressures for my
car? ... ..... .................. .... 236
Why safety belts? . . . . . . . . . . . . . . 136, 137
Window regulators Power locks .... .... ... .. .. .. .. .. .. 41
Windows Cleaning ... ................ ... ... 203
defrosting .. .. ........... .. .. .. .... 70
W indshield
C leaning ... ................ ... .... 50
defrosting .. ................ ... .... 70
Windshield washer fluid Low level . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Index 289
Windshield washer system . . . . . . . . . . . . 50
Windshield wipers Folding up .. .. .. ................. . 51
Indicator light . .. .... ........... .. . 21
Replacing windsh ield wiper b lades .. .. . 51
Switching on/off ... .............. . .
Washer reservoir
Winter operation
so
229
Battery ....... ...... ............. 22S
Coolant system .. .. . .......... .... 222
Defrosting windows ............... .. 70
Seat heating . . . . . . . . . . . . . . . . . . . . . . . 70
Tires ............................ 189
Windows . .. .. .. ............... .. 203
Winter tires ... .. .. ................. 24S
All wheel drive ..... ............... 245
X
Xenon headlights . . . . . . . . . . . . 44, 46, 261
•
•