2013 Abarth 500 engine

92
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
WARNING
LIGHTS AND
MESSAGES
Go to a Abarth Dealership as
soon as possible if warning
light
Udoes not light up
when the key is turned to
MAR or if, while travelling, the warn-
ing light comes on either steady or
blinking (along with a message on the
display). The operation of warning light
Umay be checked by the traffic po-
lice using specific devices. Follow the
laws in force in the country where you
are driving.
K
FUEL RESERVE
(amber)
Turning the ignition key to
MARthe warning light turns on, but it
should go off after a few seconds.
The warning light turns on when about 5
litres of fuel are left in the tank.
IMPORTANT The warning light will blink
to indicate a system failure. Go to a Abarth
Dealership to have the system checked.
CAR PROTECTION
SYSTEM FAILURE -
FIAT CODE (amber)
If with the ignition key at MAR, the warn-
ing light stays on, this indicates a possible
failure (see “Fiat Code system” in section
“Your car”).
IMPORTANT Warning lights
Uand Ywill come on at the same time to indicate
a Fiat CODE system failure.
If with the engine running the warning light
Yflashes, this means that the car is not
protected by the engine inhibitor device
(see “Fiat Code system” in section “Your
car”).
Contact Abarth Dealership to have all the
key stored.
Y
REAR FOG LIGHTS
(amber)
The warning light comes on
when the rear fog lights are turned on.
4
GENERIC FAILURE
INDICATION
(amber)
The warning light turns on in the follow-
ing circumstances.
Engine oil pressure
sensor failure
The warning light turns on when failure
is detected in parking sensors. Go to a
Abarth Dealership to have the fault fixed
as soon as possible.
Parking sensor failure
The warning light turns on and the mes-
sage is shown on the display when a park-
ing sensor fault is detected. Contact a
Abarth Dealership.
è
If the light flashes, release the accelerator
pedal to lower the speed of the engine un-
til the warning light stops flashing; contin-
ue the journey at moderate speed, trying
to avoid driving conditions that may cause
further flashing and contact Abarth Deal-
ership as soon as possible.
087-094 ABARTH 500 1ed GB:087-094 ABARTH 500 GB 24-05-2012 9:53 Pagina 92

95
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
ENGINE STARTING ........................................................... 96
QUICK TYRE REPAIR KIT FIX&GO automatic ........... 98
WHEN NEEDING TO CHANGE A BULB ................... 107
IF AN EXTERIOR LIGHT BURNS OUT.......................... 111
IF AN INTERIOR LIGHT BURNS OUT.......................... 114
IF A FUSE BLOWS................................................................ 116
IF THE BATTERY IS FLAT.................................................. 121
LIFTING THE CAR............................................................... 122
TOWING THE CAR ........................................................... 122
I I
N N

A A
N N

E E
M M
E E
R R
G G
E E
N N
C C
Y Y
In an emergency we recommend that you call the toll-free number found on the
Warranty Booklet. You can also connect to the site www.fiat500.com
to search for the nearest Abarth Dealership point
095-122 ABARTH 500 1ed GB:095-122 ABARTH 500 GB 24-05-2012 9:56 Pagina 95

96
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
JUMP STARTING fig. 1
If the battery is flat, the engine may be
started using an auxiliary battery with the
same capacity or a little higher than the
flat one.
fig. 1
ENGINE STARTING
If the instrument panel warning light Yturns on glowing steadily, contact im-
mediately Abarth Dealership.
Never use a quick battery
charger for the emergency
start: this might damage the
electronic system and the en-
gine start/supply control units.
This procedure must be per-
formed by expert personnel
because incorrect actions may cause
electrical discharge of considerable
intensity. Furthermore, battery fluid
is poisonous and corrosive: avoid con-
tact with your skin and eyes. Keep
naked flames away from the battery.
No smoking. Do not cause sparks.
WARNINGF0S078Ab
095-122 ABARTH 500 1ed GB:095-122 ABARTH 500 GB 24-05-2012 9:56 Pagina 96

97
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
Proceed as follows:
❒Connect positive terminals (+ sign near
the terminal) of the two batteries with
a jump lead;
❒With a second lead, connect the nega-
tive terminal (–) of the auxiliary battery
to an earthing point
Eon the engine or
the gearbox of the car to be started;
❒Start the engine;
❒When the engine has been started, re-
move the leads reversing the order
above.If after a few attempts the engine does not
start, do not insist any further but contact
the nearest Abarth Dealership.
IMPORTANT Never connect the negative
terminals of the two batteries directly:
sparks could ignite explosive gas released
from the battery. If the auxiliary battery is
installed on another car, prevent acciden-
tal contact between metallic parts of the
two cars.BUMP STARTING
Never jump start the engine by pushing,
towing or driving downhill.
This could cause a flow of fuel into the cat-
alytic converter and damage it beyond re-
pair.
IMPORTANT Remember that the brake
booster and the power steering system
are not operating until the engine is start-
ed, a greater effort will therefore be re-
quired to press the brake pedal or turn
the steering wheel.
095-122 ABARTH 500 1ed GB:095-122 ABARTH 500 GB 24-05-2012 9:56 Pagina 97

102
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
IINDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
fig. 14F0S087Abfig. 13F0S086Ab
INFLATION PROCEDURE
❒Ensure that the handbrake is up.
Remove the tyre valve cap, extract the
flexible filler tube A-fig. 13and fasten
the ring Bonto the tyre valve;
Put on the protection gloves
provided together with quick
tyre repair kit.
WARNING
❒make sure that switch D-fig. 14of the
compressor is in position 0 (off), start
the engine, plug into the socket E-fig.
15and operate the compressor turn-
ing switch D-fig. 14to position I(on).
Inflate the tyre to the pressure speci-
fied in the “Cold inflation pressure”
paragraph, “Technical Specifications”
chapter.
For a more accurate reading, check
pressure gauge F-fig. 14with the com-
pressor off;
095-122 ABARTH 500 1ed GB:095-122 ABARTH 500 GB 24-05-2012 9:56 Pagina 102

105
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
❒if at least 1.8 bar pressure is read, re-
store proper pressure (with engine
running and handbrake on) and restart;
❒drive with the utmost care to the near-
est Abarth Dealership.
Remember to inform the
workshop that the tyre has
been treated with a quick repair kit.
Give the instruction booklet to the
tyre repair workshop personnel.
WARNING
FOR CHECKING AND
RESTORING PRESSURE ONLY
The compressor may also be used for
restoring pressure only. Release the quick
coupling and connect directly to the tyre
valve fig. 17; in this way, the cylinder will
not be connected to the compressor and
no sealant will be injected.
fig. 17F0S090Ab
095-122 ABARTH 500 1ed GB:095-122 ABARTH 500 GB 24-05-2012 9:56 Pagina 105

111
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒remove the protecting rubber cap men-
tioned above;
❒turn the bulb holder clockwise A-fig.
22and withdraw it;
❒remove the snap-fitted bulb and replace
it;
❒refit the bulb holder Aby turning it
clockwise and locking it properly;
❒reinstall the rubber cap;
IF AN EXTERIOR LIGHT
BURNS OUT
For the type of bulb and power rating, see
“When needing to change a bulb”.
FRONT LIGHT CLUSTERS
The front light clusters contain sidelights,
dipped beam, main beam and direction in-
dicator bulbs.
Operating from the engine compartment
remove the rubber cap A-fig. 20to ac-
cess the direction indicators; remove the
rubber cap B-fig. 20 to access the bulbs
of the dipped beam headlights.
To access the bulbs of the side-
lights/daylights and of the main beams, af-
ter fully steering the wheels open the
guard door C-fig. 21on the wheelhouse
at the level of the lights, then remove the
rubber cap D-fig. 21.
fig. 20F0S093Ab
fig. 21F0S094Ab
fig. 22F0S095Ab
095-122 ABARTH 500 1ed GB:095-122 ABARTH 500 GB 24-05-2012 9:56 Pagina 111

117
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
YOUR CAR
SAFETY
DEVICES
CORRECT USE
OF THE
CAR
IN AN
EMERGENCY
FUSE LOCATION
Dashboard fuses
To access the fuses you must remove the
snap-fitted cover E.
The 5A fuse for door mirror demisting is
located in the diagnostic socket area, as
shown in fig. 38.
In the bottom area, near the pedals, you
can find the control unit shown in fig. 39.
fig. 38F0S111Ab
fig. 39F0S112Ab
If a general protection fuse
for safety systems (air bag
system, braking system), power unit
systems (engine system, transmission
system) or steering system is triggered,
contact a Abarth Dealership.
WARNING
095-122 ABARTH 500 1ed GB:095-122 ABARTH 500 GB 24-05-2012 9:56 Pagina 117