2013.5 Citroen DS4 RHD lock

47Monitoring




Service


temporarily,
accompanied by a
message. A minor malfunction has occurred for
which there is no specific warning
lamp. Identify the malfunction by reading the message
displayed in the screen, such as, for example:


- the opening of the doors, boot or bonnet,

- the engine oil level,

- the remote control battery,

- the tyre pressures,

- saturation of the particle emission filter on
Diesel vehicles (see "Checks - § Checks/Particle
emissions filter").
For any other malfunctions, contact a CITROËN dealer
or a qualified workshop.

fixed, accompanied
by a message and an
audible signal. A major malfunction has occurred
for which there is no specific warning
lamp. Identify the malfunction by reading the message
displayed in the screen and contact a CITROËN dealer
or a qualified workshop.

Warning lamp



is on



Cause



Action/Observations



Particle
emissions filter
(Diesel)
fixed, accompanied
by an audible signal
message on the risk of
blockage of the particle
emissions filter. This indicates that the particle
emissions filter is starting to become
saturated. As soon as driving conditions allow, regenerate the
filter by driving at a speed of at least 35 mph (60 km/h)
until the warning lamp goes off.
fixed, accompanied by
an audible signal and
and a message that the
particle emissions filter
additive level is too low.

This indicates the low level of the
additive reservoir. Have the reser voir topped up as soon as possible by a
CITROËN dealer or a qualified workshop.

Warning lamp



is on



Cause



Action/Observations






Anti-lock Braking
System (ABS)


fixed. The anti-lock braking system has
a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
CITROËN dealer or a qualified workshop without delay.




Dynamic stability
control (ESP/
ASR)


flashing. The ESP/ASR regulation is active. The system optimises traction and improves the
directional stability of the vehicle.

fixed, associated with
illumination of the indicator
lamp in the " ESP OFF
"
button, accompanied by an
audible signal and a message.
The ESP/ASR or hill start assist
system has a fault. Have it checked by a CITROËN dealer or a qualified
workshop.

Engine
autodiagnosis
system


flashing. The engine management system has
a fault. Risk of destruction of the catalytic converter.
Have it checked by a CITROËN dealer or a qualified
workshop.

fixed. The emission control system has a
fault.
The warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or qualified
workshop without delay.






Low fuel level


fixed, accompanied by
and audible signal and
a message. When it first comes on there remains
approximately 6
litres
of fuel in the
tank.
At this point, you begin to use the fuel
reserve. Refuel as soon as possible to avoid running out of
fuel.
Until sufficient fuel is added, this warning lamp will
come on every time the ignition is switched on,
accompanied by an audible signal and a message.
This audible signal and message are repeated
with increasing frequency as the fuel level drops
towards "0".

Fuel tank capacity: approximately 60 litres
.
Never continue to drive until you run out of fuel,
as this could damage the emission control and
injection systems.

A few seconds after the ignition is switched
on, the distance recorder resumes its normal
operation. The spanner remains on
.
The distance remaining may be
weighted by the time factor, depending
on the type of driving.
Therefore, the spanner may also come
on if you have exceeded the two year
service interval.









Service indicator zero reset

After each ser vice, the ser vice indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:



switch off the ignition,


press and hold the ".../000"
trip distance
recorder zero reset button,


switch on the ignition; the distance recorder
display begins a countdown,


when the screen indicates "=/0"
and the
spanner disappears, release the button. This operation cannot be carried
out while a reminder of the ser vicing
information is being displayed.
Following this operation, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the
zero reset to be registered.


Recalling the service information

You can recall the ser vice information at any
time.



Briefly press the ".../000"
trip distance
recorder zero reset button.
The ser vice information is displayed for a
few seconds, in the total distance recorder
line or in the type 2 instrument panel
central screen.




Service overdue

For a few seconds after the ignition is switched on,
the spanner flashes
to indicate that the ser vice
must be carried out as soon as possible.

Example:
the ser vice is overdue by 180 miles
(300 km).
For a few seconds after the ignition is switched on,
the screen indicates:

The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked.












Distance recorders


Total distance recorder

Trip distance recorder

Measures the distance travelled since it was
last reset to zero by the driver.



With the ignition on, press and hold this
button until zeros appear.
Measures the total distance travelled by the
vehicle since its first registration.

Defi ne the vehicle parameters



- "Driving assistance":


●
"Parking brake automatic" (Automatic
electric parking brake; see the "Driving"
section),

●
"Rear wipe in reverse gear" (Rear
wiper coupled to reverse gear; see the
" Visibility" section),

●
"Speeds memorised" (Memorising
speeds; see the "Driving" section).



- " Vehicle lighting" (see the " Visibility"
section):


●
"Directional headlamps" (Main /
additional directional lighting),

●
"Daytime lights" (Daytime running
lamps).



- "Interior lighting" (see the " Visibility"
section:


●
"Follow-me-home headlamps"
(Automatic operation of headlamps after
switching off the ignition),

●
" Welcome lighting" (Exterior and interior
welcome lighting).
For example: setting of the duration of the
"follow-me-home" lighting



Press the " 
" or " 
" buttons, to select the
"Define the vehicle parameters" menu,
then the " OK
" button.


Press the " 
" or " 
" buttons to select the
"Interior lighting" line, then the "OK"
button;
then follow the same procedure to select the
"Follow-me-home headlamps" line. This menu allows you to activate or deactivate
the following equipment, classified in different
categories:


- "Access to the vehicle" (see the "Access"
section):


●
"Plip action" (Selective unlocking of the
driver's door),

●
"Unlocking boot only" (Selective
unlocking of the boot).



"Personalisation-
configuration" menu
This menu gives access to the following
functions:


- "Define the vehicle parameters",

- "Choice of language",

- "Display configuration",

- "Choice of sounds".

85Comfort

Switching the system off




Turn the air flow control to the
left until all of the indicator
lamps go off.
This switch does not operate the air conditioning, only the air fan.
When the "REST" function is activated, you cannot modify the temperature, air flow
and distribution settings: these are controlled automatically according to the ambient
temperature.
This function is not available in the STOP mode of Stop & Start.
Avoid prolonged operation in interior
air recirculation mode or driving for
long periods with the system off (risk of
misting and deterioration of air quality).
On switching on the engine



- The control screens come on: the function
is available.

- Pressing the REST
button activates the
ventilation for a few minutes. Activation of
the function is confirmed by the display of
two dashes in the control screens and four
air flow level indicator lamps.

- The function can be deactivated and
reactivated if the control screens are on.

- The screens go off at the end of this
period.
On stopping the engine



- While the control screens remain on: the
function is available.

- Pressing the REST
button activates the
ventilation for a few minutes. Activation of
the function is confirmed by the display of
two dashes in the control screens and four
air flow level indicator lamps.
Locking the vehicle has no effect on this
function.

- The control screens go off at the end of this
period.
Pressing again before the end of the period
interrupts off the ventilation definitively: the
control screens go off and the function is
no longer available. This action switches off the air conditioning and
the ventilation.
Temperature related comfort is no longer
assured but a slight flow of air, due to the
movement of the vehicle, can still be felt.



Modify the settings (temperature, air flow
or air distribution) or press the "AUTO "

button to reactivate the system with the
values set before it was switched off.

93Comfort
These have one position for use (up) and a
stowed position (down).
They can also be removed.
To remove a head restraint:



release the backrest using control 1
,


tilt the backrest 2
slightly forwards,


pull the head restraint upwards to the stop,


then, press the lug A
.


Rear head restraints

Never drive with the head restraints
removed; they must be in place and
correctly adjusted.









Steering wheel adjustment





When stationary
, pull the control lever to
release the adjustment mechanism.


Adjust the height and reach to suit your
driving position.


Push the control lever to lock the
adjustment mechanism.
As a safety precaution, these
operations should only be carried out
while the vehicle is stationary.

Mirrors

Each fitted with an adjustable mirror glass
permitting the lateral rear ward vision necessary
for overtaking or parking. They can also be
folded for parking in confined spaces.

Demisting - Defrosting
Adjustment




Move control A
to the right or to the left to
select the corresponding mirror.


Move control B
in all four directions to
adjust.


Return control A
to the central position.


Door mirrors

The objects obser ved are, in reality,
closer than they appear.
Take this into account in order to
correctly judge the distance of vehicles
approaching from behind.




Folding




From outside: lock the vehicle using
the remote control or the key.


From inside: with the ignition on, pull the
control A
in the central position rear wards.


Unfolding




From outside: unlock the vehicle using
the remote control or the key.


From inside: with the ignition on, pull the
control A
in the central position rear wards. If the mirrors are folded using control A
,
they will not unfold when the vehicle is
unlocked. Pull again on control A
.
The folding and unfolding of the door
mirrors using the remote control can be
deactivated by a CITROËN dealer or a
qualified workshop.
Never fold or unfold the electric folding
mirrors manually.

If your vehicle is fitted with heated
mirrors, the demisting-defrosting
operates by switching on the heated
rear screen (refer to the "Rear screen
demist-defrost" page).









The rear screen demist - defrost can only
operate when the engine is running.