2013.5 Citroen DS4 RHD warning light

9Familiarisation
Exterior


Welcome lighting

This additional exterior and interior lighting,
controlled remotely, makes your approach to
the vehicle easier when the light is poor.

Temporary puncture repair kit

This kit is a complete system, consisting of a
compressor and a sealant cartridge, for the
temporary repair of a tyre.

129


248




Under-infl ation detection

This system continuously monitors the tyre
pressures and alerts you in the event of under-
inflation.

214




Blind spot sensors

In certain conditions, this system
detects the presence of a vehicle in
the blind spot. It informs you by means
of a warning lamp in the corresponding
door mirror.

219




Exterior customising
stickers
When cleaning your car with a high
pressure jet wash, keep the end of the
lance at least 30 cm away from the
stickers.

Customisable colour instrument panel - Type 1



1.
Rev counter (x 1 000 rpm or tr/min).

2.
Gear efficiency indicator or gear lever
position and gear engaged (electronic or
automatic gearbox).

3.
Analogue speedometer (mph or km/h).

4.
Cruise control or speed limiter setting.

5.
Digital speedometer (mph or km/h).

6.
Engine oil level indicator.


Dials and screens
Control buttons


7.
Ser vice indicator
(miles or km) then,
total mileage recorder.
These two functions are displayed
successively on switching on the ignition.
Lighting dimmer setting (when making an
adjustment).

8.
Trip mileage recorder (miles or km).

9.
Fuel gauge and associated low fuel
warning lamp.

10.
Range (miles or km).


A.
Dial COLOUR: customisation of the
background colour of the dials.

B.
Screen COLOUR: customisation of the
background colour of the screens.

C.
Lighting dimmer (available in night mode).

D.
Reminder of the servicing information
Reset the service indicator or the trip
mileage recorder.

39Monitoring


1.
Rev counter (x 1 000 rpm or tr/min).

2.
Gear efficiency indicator or gear lever
position and gear for an electronic or
automatic gearbox.

3.
Speedometer (mph or km/h).

4.
Central screen.

5.
Fuel gauge and associated low fuel level
warning lamp.

Dials and screens


6.
Trip mileage recorder (miles or km).

7.
Ser vice spanner (if a ser vice is due or
missed),
total mileage recorder.
(miles or km)



Control buttons




















Customisable colour instrument panel - Type 2



A.
Dial COLOUR: customisation of the
background colour of the dials.

B.
Screen COLOUR: customisation of the
background colour of the screens.

C.
Dashboard lighting dimmer (in night mode).

D.
Start a manual test (procedure for checking
the status of systems and display of vehicle
alerts).
Reset service indicator or trip mileage
recorder.

Warning lamp



is on



Cause



Action/Observations






Left-hand
direction indicato

r


flashing with buzzer. The lighting stalk is pushed down.




Right-hand
direction indicator


flashing with buzzer. The lighting stalk is pushed up.






Sidelamps


fixed. The lighting control is in the
"Sidelamps" position. On vehicle where the daytime running lamps are deactivated,
if the lighting control is in the "AUTO" position, the sidelamps
come on as a luminous signature of the vehicle.





Dipped beam
headlamps


fixed. The lighting stalk is in the "Dipped beam
headlamps" position or in the "AUTO"
position in conditions of low light.






Main beam
headlamps


fixed. The lighting stalk is pulled towards
you. Pull the stalk again to return to dipped beam
headlamps.




Front foglamps


fixed. The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.




Rear foglamps


fixed. The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.



Hazard warning
lamps


flashing with audible
signal. The hazard warning lamps switch,
located on the dashboard, has been
operated. The left-hand and right-hand direction indicators and
their associated indicator lamps flash simultaneously.










Operation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.
It may be accompanied by an audible signal and a message in the screen.

Lighting dimmer


fixed. The lighting dimmer is making an
adjustment. You can adjust the level of illumination of the
instruments between 1 and 16.



Passenger's
airbag system
fixed in the seat belt
and passenger's front
airbag warning lamps
display.
The control switch, located in the glove
box, has been placed in the "ON"
position.
The passenger's front airbag is activated.
In this case, do not install a "rear facing"
child seat. Move the control switch to the "OFF"
position
to deactivate the passenger's front airbag.
In this case, you can install a "rear facing" child seat.





Automatic wiping


fixed. The wiper control is pushed
downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the control
stalk downwards or put the stalk into another position.

Warning lamp



is on



Cause



Action/Observations




Stop & Start


fixed. When the vehicle stops (red lights,
traffic jams,...) the Stop & Start
system has put the engine into STOP
mode. The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to
move off.

flashes for a few
seconds, then goes
off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. For more information on special cases with STOP
mode and START mode, refer to the "Stop & Start"
section.


Parking space
sensors


fixed. The parking space sensors function
is selected. To start measurement, operate the direction indicator
on the side of the space to be measured, and do not
exceed 12 mph (20 km/h). A message is displayed
once the measurement has been completed.


Press the closed padlock on the remote
control.
This will switch on the courtesy lamps and the
direction indicators will flash for around ten
seconds.







Locating your vehicle

This function allows you to identify
your vehicle from a distance,
particularly in poor light. Your vehicle
must be locked.












Anti-theft protection


Electronic engine immobiliser

The key contains an electronic chip which has
a special code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible.
This electronic engine immobiliser locks the
engine management system a few minutes
after the ignition is switched off and prevents
starting of the engine by anyone who does not
have the key.


In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal
and a message in the screen.
In this case, your vehicle will not start; contact
a CITROËN dealer as soon as possible.



Folding the key




First press this button to fold the key.
If you do not press the button when
folding the key, there is a risk of
damage to the mechanism.


Keep safely, away from your vehicle,
the label attached to the keys given to
you on acquisition of the vehicle.

127Visibility

Switching off the lighting
when switching off the ignition
When the ignition is switched off, all
of the lamps switch off immediately,
except for the dipped beam headlamps
if automatic guide-me-home lighting is
activated.
The temporary illumination of the dipped beam
headlamps after the vehicle's ignition has been
switched off makes the driver's exit easier
when the light is poor.

Switching on




With the ignition off, "flash" the headlamps
using the lighting stalk.


A further "headlamp flash" switches the
function off.



Switching off

The manual guide-me-home lighting switches
off automatically after a set time.








Manual guide-me-home
lighting

Switching on the lighting when
switching on the ignition
To reactivate the lighting control stalk, turn
the ring A
to position "0"
- lighting off, then
to the position of your choice.
If the lighting is switched on manually after
switching off the ignition, there is an audible
signal when a front door is opened to warn
the driver that they have forgotten to switch
off the vehicle's lighting, with the ignition off.
They switch off automatically after a period
which depends on the state of charge of the
battery (entry to energy economy mode).




















Parking lamps

Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.



Within one minute of switching off the
ignition, operate the lighting control stalk
up or down depending on the traffic side
(for example: when parking on the left;
lighting control stalk upwards; the right
hand sidelamps are on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the central position.

When a low level of ambient light is detected
by a sunshine sensor, the number plate
lamps, sidelamps and dipped beam headlamps
are switched on automatically, without any
action on the part of the driver. They can also
come on if rain is detected, at the same time as
automatic operation of the windscreen wipers.
As soon as the brightness returns to a
sufficient level or after the windscreen wipers
are switched off, the lamps are switched off
automatically.












Automatic illumination of
headlamps

Activation




Turn the ring to the "AUTO "
position. The
activation of the function is accompanied
by the display of a message in the screen.



Deactivation




Turn the ring to another position.
Deactivation of the function is accompanied
by the display of a message in the screen.



Automatic "guide- me-
home" lighting

Operating fault

In the event of a malfunction of
the sunshine sensor, the lighting
comes on, this warning lamp is
displayed in the instrument panel and/or a
message appears in the screen, accompanied
by an audible signal.
Contact a CITROËN dealer or a qualified
workshop. In fog or snow, the sunshine sensor
may detect sufficient light. In this
case, the lighting will not come on
automatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind the rear view mirror; the
associated functions would no longer
be controlled.

When the automatic illumination of headlamps
function is activated, under low ambient
light the dipped beams headlamps come on
automatically when the ignition is switched off.


Programming

Activation or deactivation, as well
as the duration of the guide-me-
home lighting, is set in the vehicle
configuration menu.