2012 YAMAHA XT660Z headlight bulb

Checking and lubricating the cables ..................\7...............7\f25
Checking and lubricating the throttle gri\b and cable ........7\f26
Checking and lubricating the brake and clutch levers ..................\7....7\f26
Lubricating the brake \bedal ............7\f27
Checking and lubricating the sidestand ..................\7..........7\f27
Lubricating the rear sus\bension......7\f27
Lubricating the swingarm \bivots .....7\f28
Checking the front fork..................\7..7\f28
Checking the steering ..................\7...7\f29
Checking the wheel bearings..........7\f29
Battery ..................\7..................\7.........7\f30
Re\blacing the fuses ..................\7......7\f31
Re\blacing a headlight bulb .............7\f33
Re\blacing a turn signal light bulb....7\f34
Re\blacing the license \blate light bulb ..................\7.................7\f\735
Re\blacing an auxiliary light bulb .....7\f35
Su\b\borting the motorcycle ..............7\f36
Front wheel ..................\7..................\7.7\f36
Rear wheel ..................\7..................\7..7\f38
Troubleshooting ..................\7............7\f39
Troubleshooting charts..................\7..7\f40 MOTORCYCLE CARE
AND STORAGE
..................\7.................8\7\f1
Care ..................\7..................\7..............8\f1
Storage ..................\7..................\7.........8\f3
SPECIFICATIONS ..................\7.............9\f1
CONSUMER INFORMATION ............10\f1
Identification numbers ..................\7...10\f1
Motorcycle noise regulation (for Australia) ..................\7..........10\f2
TABLE OF CONTENTS
03 ingles -austral\:ia 26/2/10 10:\f5 \: Página \b

1
2
3
4
5
6
7
8
9
10
PERIODIC M\fINTEN\fNCE \fND \fDJ\bSTMENT
7-33
EAUB1580
Replacing a headlight bulb
1. Headli\fht b\blb cover
1. Headli\fht co\bpler
2. Headli\fht b\blb holder
3. Headli\fht b\blb
EWA10790
W\fRNING0
Headlight bulbs get very hot. There-
fore, keep flammable products
away from a lit headlight bulb, and
do not touch the bulb until it has
cooled down.3. Place a new headli\fht b\blb into position, and then sec\bre it with
the b\blb holder.
1. Do not to\bch this area
1. Headli\fht b\blb holder
2. Headli\fht b\blb
This model is eq\bipped with q\bartz
b\blb headli\fhts. If a headli\fht b\blb
b\brns o\bt, replace it a\is follows.1. Remove the headli\fht b\blb cover, and then disconnect the headli\fht
co\bpler.
2. Unhook the headli\fht b\blb holder, and then remove the defective
b\blb.
XT660Z 05-07 ING-AUS:MY03 04-06 ING 11-05-2009 10:10 Pagina 7-33

PERIODIC MAINTENANCE AND ADJUSTMENT
7-34
1
2
3
4
\f
6
7
8
\b
10
ECA10650
NOTICE
Take care not to damage the fol-
lowing parts:
●Headlight bulb  Do not touch the glass part
of the headlight bulb to keep
it free from oil, otherwise the
transparency of the glass,
the luminosity of the bulb,
and the bulb life will be ad-
versely affected. Thoroughly
clean off any dirt and finger-
prints on the headlight bulb
using a cloth moistened with
alcohol or thinner.
●Headlight lens
 Do not affix any type of tinted
film or stickers to the head-
light lens.
 Do not use a headlight bulb
of a wattage higher than
specified. 4. Connect t\fe couple\b, and t\fen in-
stall t\fe \feadlig\ft bulb cove\b.
5. Have a Yama\fa deale\b adjust t\fe \feadlig\ft beam if nec\ essa\by.
EAU24204
Replacing a turn signal
light bulb
1. Sc\bew
2. Tu\bn signal lig\ft lens
3. Tu\bn signal lig\ft bulb
1. Remove t\fe tu\bn signal lig\ft lensby \bemoving t\fe sc\bew.
2. Remove t\fe bu\bnt-out bulb by pus\fing it in and tu\bning it coun-
te\bclockwise.
3. Inse\bt a new bulb into t\fe socket, pus\f it in, and t\fen tu\bn it clock-
wise until it stops.
XT660Z 05-07 ING-AUS:MY03 04-06 ING 11-05-2009 10:10 Pagina 7-34

SPECIFICATIONS
9-3
1
2
3
4
5
6
7
8
9
1\f
Rea\b suspension:
Type: Swingarm (lin\f suspension\b
Spring/damper type: Coil spring/gas-oil damper, spring
preload adjustable
Wheel travel: 200 mm (7.87 in\b
Elect\bical system:
Ignition system:Transistorized coil ignition (digital\b
Charging system: A.C. magneto
Batte\by:
Model:GT9B-4
Voltage, capacity: 12 V, 8 Ah
Headlight:
Bulb type:Halogen bulb
Bulb voltage, wattage x quantity:Headlight:12 V, 55 W x 2
Auxiliary light: 12 V, 5 W x 2
Tail/bra\fe light: LED
Front turn signal light: 12 V, 10 W x 2
Rear turn signal light: 12 V, 10 W x 2
Meter lighting: LED (bac\flight\b Neutral indicator light:
LED
Turn signal indicator light: LED
High beam indicator light: LED
Coolant temperature warning light: LED
Engine trouble warning light: LED
Immobilizer system indicator light: LED
Fuses:Main fuse:
30 A
Headlight fuse: 20 A
Signaling system fuse: 10 A
Ignition fuse: 10 A
Par\fing lighting fuse: 10 A
Radiator fan fuse: 7.5 A
Fuel injection system fuse: 10 A
Bac\fup fuse (for odometer, cloc\f and immobilizer\b:
10 A
XT660Z 08-10 ING-AUS:MY03 07-10 ING 11-05-2009 10:10 Pagina 8