Page 300 of 492
8-9
TIP
Some maintenance items need more frequent service if you are riding in unusually wet, dusty, sandy or
muddy areas, or at full throttle.
Hydraulic brake service
Regularly check and, if necessary, correct the brake fluid level.
Every two years replace the internal components of the brake master cylinder and calipers, and
change the brake fluid.
Replace the brake hoses every four years and if cracked or damaged.
Drive shaft universal joint*Lubricate with lithium-soap-based grease.Engine mount*Check for cracks or damage.
Check bolt tightness.Front and rear axle boots*Check operation.
Replace if damaged.Stabilizer bushings*Check for cracks or damage.Fittings and fasteners*Check all chassis fittings and fasteners.
Correct if necessary.
ITEM ROUTINEWhichever
comes firstINITIAL EVERY
month136612
km
(mi)320
(200)1200
(750)2400
(1500)2400
(1500)4800
(3000)
hours 20 75 150 150 300
1RB60-EE.book Page 9 Thursday, April 7, 2011 10:43 AM
Page 316 of 492
8-25 1. Engine oil dipstick
1. Jauge d’huile moteur
1. Varilla de medición del aceite del motor
1
5B410012
Engine oil and oil filter cartridge
Check engine oil level before each operation. In
addition, change the oil and the oil filter cartridge at
the intervals specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1. Park the vehicle on a level surface.
2. Remove the console. (See pages 8-21–8-23
for console removal and installation proce-
dures.)
3. Check the engine oil level on a cold engine. TIPIf the engine was started before checking the oil
level, be sure to warm up the engine sufficiently,
and then wait at least 10 minutes until the oil set-
tles for an accurate reading.4. Remove the engine oil dipstick, and then
wipe it off with a clean rag.
1RB60-EE.book Page 25 Thursday, April 7, 2011 10:43 AM
Page 386 of 492
8-95
WARNING
Improper maintenance can result in loss of
braking ability. Observe these precautions:
Insufficient brake fluid may allow air to en-
ter the brake system, reducing braking per-
formance.
Clean the filler cap before removing. Use
only DOT 4 brake fluid from a sealed con-
tainer.
Use only the specified brake fluid; other-
wise, the rubber seals may deteriorate,
causing leakage.
Refill with the same type of brake fluid.
Adding a brake fluid other than DOT 4 may
result in a harmful chemical reaction.
Be careful that water does not enter the
brake fluid reservoir when refilling. Water
will significantly lower the boiling point of
the fluid and may result in vapor lock.
1RB60-EE.book Page 95 Thursday, April 7, 2011 10:43 AM
Page 390 of 492
8-99 1. Brake pedal a. No brake pedal free play
1. Pédale de frein a. Absence de garde à la pédale de frein
1. Pedal de freno a. Ningún juego en el pedal de freno
1
a
EVU00860
Brake fluid replacement
Complete fluid replacement should be done only
by trained Yamaha service personnel. Have a
Yamaha dealer replace the following components
during periodic maintenance or when they are
damaged or leaking.
Replace the oil seals every two years.
Replace the brake hoses every four years.
EVU01220
Checking the brake pedal
Have a Yamaha dealer check the brakes at the in-
tervals specified in the periodic maintenance and
lubrication chart. There should be no free play in
the brake pedal. The brakes should operate
smoothly and there should be no brake drag. If the
brakes feel soft or spongy, this could indicate air in
the brake system. Have a Yamaha dealer check
the brake system if necessary.
1RB60-EE.book Page 99 Thursday, April 7, 2011 10:43 AM