Page 229 of 298

09 Maintenance and servicing
Replacing bulbs09
229
5. Disconnect the wiring connector by press-
ing down the clip with your thumb while at
the same time pulling the connector with
your other hand.
6. Lift out the headlight housing and place it
on a soft surface to avoid scratching the
lens.
CAUTION
When disconnecting the connector, pull on
the connector itself and not on the wiring.
After the defective bulb has been replaced,
reinsert the housing in the reverse order. Check
that the retaining pin is correctly inserted.
Low beam bulb
Cover with retaining clamps
1. Open the hood and remove the headlight
housing (see page 228 for instructions).
2. Release the retaining clamps on the cover
and remove it.
3. Release the bulb's retaining spring holding
the bulb in place by pressing it first to the
left to release it and then moving it outward
and downward.
4. Pull out the bulb.
Low beam bulb
Installing a new bulb1. Insert the new bulb. It can only be installed
in one position.
2. Press the retaining spring inward and
upward and slightly to the right until it
snaps into place.
3. Press the wiring connector onto the bulb.
4. Put the plastic cover in place.
5. Press the retaining clamps back into place.
6. Reinstall the headlight housing (see
page 228).
Page 234 of 298

09 Maintenance and servicing
Replacing bulbs 09
234* Option/accessory, for more information, see Introduction.
Cabin lighting in the cargo area
G010326
The rear cabin lighting consists of a light on the
driver’s side of the cargo area
1. Insert a screwdriver and turn it carefully to
release the lens.
2. Remove the connector from the bulb
holder.
3. Replace the defective bulb.
4. Press the lens back into place.
Vanity mirror lighting
G020253
1. Insert a screwdriver under the center of the
lower edge of the mirror, turn it, and care-
fully pry up the lugs at the edge.
2. Move the screwdriver under the edge on
the left and right-hand sides (near the black
rubber sections) and pry carefully to
release the lower edge of the mirror.
3. Pry carefully and lift out the entire mirror
and the cover.
4. Remove the defective bulb and replace it
with a new one.5. To reinstall the mirror, begin by pressing
the three lugs at the upper edge of the mir-
ror back into place.
6. Press the three lower lugs back into place.
NOTE
For information regarding any other bulbs
not mentioned in this section, please con-
tact your Volvo retailer or a trained and
authorized Volvo service technician.
Bulb specifications
Lighting
functionWattageBulb
Low beam
headlights
(halogen)55H11 LL
High beam
headlights
(halogen)60HB3
High beam
headlights
(models
with Active
Bending
Lights*)55H7 LL
Page 291 of 298

12 Index
12
291
H
Hand brake (parking brake)..................... 161
Hazard warning flashers............................ 76
HD digital radio........................................ 254
Headlights.................................................. 64
Active Bending Lights........................... 64
changing bulbs................................... 228
high and low beams............................. 67
high beam flash.................................... 67
Headlight washers..................................... 73
Head restraints, rear seat........................118
High beam flash......................................... 67
High beams................................................ 67
Hoisting the vehicle.................................217
HomeLink
® Wireless Control System........ 86
Home safe lighting............................... 67, 84
Hood, opening......................................... 219
I
Ignition switch.......................................... 149
Immobilizer.............................................. 150
Immobilizer (start inhibitor)...................... 126Important information................................ 10
Indicator and warning symbols............ 54, 56
Inflatable Curtain........................................ 33
Inflation pressure..................................... 181
Inflation pressure, checking..................... 181
Inflation pressure table............................183
Information and warning symbols, table
of.............................................................. 284
Information display..............................54, 61
messages in.......................................... 61
Information symbol.................................... 56
Inspection, preparing for......................... 217
Inspection readiness................................ 217
Instrument overview.................................. 52
Instrument panel.................................. 52, 54
Instrument panel lighting........................... 66
Interior Air Quality System......................... 99
Interior lighting......................................... 114
iPod Ÿ connector (audio system)............. 248
ISOFIX/LATCH anchors............................. 47
J
Jack
location of........................................... 197
Jump starting........................................... 167
K
Key (ignition switch) positions................. 149
Key blade.........................................128, 132
Keyless drive
location of antennas (pacemaker warn-
ing)...................................................... 133
locking and unlocking the vehicle...... 131
power seat memory............................ 132
starting the engine.............................. 152
Keylock.............................................. 13, 150
Kickdown.................................................156
L
Label information..................................... 272
LATCH (ISOFIX) anchors........................... 47
Liftgate wiper........................................... 225