2012 TOYOTA LAND CRUISER low beam

209 2-2. Instrument cluster
2
When driving
L/C200_EE (OM60G38E)
Indicators
The indicators inform the driver of the operating state of the
vehicle’s various systems.
Turn signal indicator
(P. 200)Turn Assist function
indicator (P. 264)
Headlight high beam
indicator (P. 218)Crawl Control indicator
(P. 264)
Tail light indicator
(P. 218) Roll sensing of curtain
shield airbags off indica-
tor (P. 150)
(if equipped)
Front fog light indicator
(P. 222)“PWR” mode indicator
(P. 195)
Rear fog light indicator
(P. 222)Automatic transmission
second start indicator
(P. 195)
Cruise control indicator
(P. 233)Low speed four-wheel
drive indicator light
(P. 259)
Slip indicator (P. 301)Center differential lock
indicator (P. 259)
(diesel engine)
Engine preheating indi-
cator (P. 190)Airbag manual on-off
indicator (P. 174)
“SET” indicator
(P. 233)Multi-terrain Select indi-
cator (P. 270)
Eco Driving Indicator
Light (P. 181)VSC OFF indicator
(P. 302)
*1
*1
*1, 2
*1*1
*1

371 3-2. Using the audio system
3
Interior features
L/C200_EE (OM60G38E)
CAUTION
Certification for the CD player
This product is a class I laser product.
A laser beam leak may result in hazardous radiation exposure.
Do not open the cover of the player or attempt to repair the unit yourself.
Refer servicing to qualified personnel.
Laser power: No hazardous
NOTICE
CDs and adapters that cannot be used
Do not use the following types of CDs or 8 cm (3 in.) CD adapters or Dual
Disc.
Doing so may damage the player and/or the CD insert/eject function.
CDs that have a diameter that is not 12
cm (4.7 in.)
Low-quality and deformed CDs

539 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)
49ETCS*110 A EFI
A/F*315 A A/F heater
50ALT-S5 A IC-ALT
51AMP 130 A Audio system
52 RAD NO.1 10 ANavigation system, audio system,
parking assist system
53 ECU-B1 5 ADouble lock system, smart entry &
start system, overhead module,
yaw rate & G sensor, tilt and tele-
scopic steering, meter, cool box,
gateway ECU, steering sensor,
VGRS
54 DOME1 5 A Illuminated entry system, clock
55 HEAD LH 15 A Headlight high beam (left)
56 HEAD LL 15 AHeadlight low beam (left), headlight
leveling system
57 INJ 10 A Injector, ignition system
58 MET 5 A Meter
59 IGN 10 ACircuit open, SRS airbag system,
gateway ECU, smart entry & push
start system, ABS, VSC, steering
lock system, GBS
60 DRL 5 A Daytime running light
61 HEAD RH 15 A Headlight high beam (right)
62 HEAD RL 15 A Headlight low beams (right)
63 EFI NO.2 7.5 A Air injection system, air flow meter
64 RR A/C NO.2 7.5 A No circuit
FuseAmpereCircuit

546
4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)
Light bulbs
You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perform, contact any authorized
Toyota dealer or repairer, or another duly qualified and equipped
professional.
For more information about replacing other light bulbs, contact any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
Prepare a replacement light bulb
Check the wattage of the light bulb being replaced. (P. 661)
Remove the engine compartment cover
P. 504
Front bulb locations
Front fog light (if equipped)Front turn signal light
Headlight
high beam

559 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)Lights other than the above
If any of the lights listed below has burnt out, have it replaced by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional.
Headlight low beam
Front position lights
Side turn signal lights
High mounted stoplight
Stop/tail lights
Tail lights
Condensation build-up on the inside of the lens
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional, for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water are built up on the inside of the lens.
Water has built up inside the headlight.
LED lights
The stop/tail, tail lights and high mounted stoplight consist of a number of
LEDs. If any of the LEDs burn out, take your vehicle to any authorized
Toyota dealer or repairer, or another duly qualified and equipped
professional to have the light replaced.

560 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)
CAUTION
Replacing light bulbs
Turn off the headlights. Do not attempt to replace the bulb immediately
after turning off the headlights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failing to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
While the low beam headlights are
turned on, and for a short time after
they have been turned off, metal com-
ponents at the rear of the headlight
assembly will be extremely hot.
To prevent burns, do not touch these
metal components until you are certain
they have cooled down.
Metal
components

561 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)
CAUTION
High-intensity discharge (HID) headlights
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional before replacing high-intensity discharge head-
lights (including light bulbs).
Do not touch the high-intensity discharge headlight’s high voltage socket
when the headlights are turned on.
An extremely high voltage of 30000 V will be discharged and could result
in death or serious injury by electric shock.
Do not attempt to take apart or repair the low beam discharge headlight
bulbs, connectors, power supply circuits, or related components.
Doing so could result in electric shock and serious injury or death.
To prevent damage or fire
Make sure bulbs are fully seated and locked.

661 6-1. Specifications
6
Vehicle specifications
L/C200_EE (OM60G38E)
Light bulbs
A: D4S high-intensity discharge
B: HB3 halogen bulbs
C: Wedge base bulbs
D: H16 halogen bulbs
E: Double end bulbs
F: Single end bulbs
Light BulbsWTy p e
ExteriorHeadlights
Low beam
High beam35
60A
B
Front turn signal lights 21 C
Front fog lights 19 D
Rear turn signal lights 16 C
Back-up lights 16 C
Rear fog lights 21 C
License plate lights 5 C
InteriorFront interior light 8 C
Rear interior lights
With rear personal lights
Without rear personal lights8
8C
E
Front personal lights 8 C
Rear personal lights 8 C
Vanity lights 2 F
Door courtesy lights 5 C
Glove box light 1.2 C