2012 TOYOTA LAND CRUISER sensor

229 2-3. Operating the lights and wipers
2
When driving
L/C200_EE (OM60G38E)
CAUTION
Caution regarding the use of windshield wipers in “AUTO” mode (vehi-
cles with rain-sensing windshield wipers)
The windshield wipers may operate unexpectedly if the sensor is touched or
the windshield is subject to vibration in “AUTO” mode. Take care that your
fingers or anything else do not become caught in the windshield wipers.
Caution regarding the use of washer fluid
When it is cold, do not use the washer fluid until the windshield becomes
warm. The fluid may freeze on the windshield and cause low visibility. This
may lead to an accident, resulting in death or serious injury.

237
2-4. Using other driving systems
2
When driving
L/C200_EE (OM60G38E)
Toyota parking assist-sensor
: If equipped
The distance from your vehicle to nearby obstacles when parallel
parking or maneuvering into a garage is measured by the sensors
and communicated via the multi-information display, touch screen
and a buzzer. Always check the surrounding area when using this
system.
Sensor types
Front corner sensors
Rear corner sensors
Rear center sensors
Toyota parking assist-sensor switch
On/off
To turn the system on, press
the switch. The indicator light
comes on to inform the driver
that the system is operational.
To turn the system off, press
the switch again.

238 2-4. Using other driving systems
L/C200_EE (OM60G38E)
Multi-information display
Front corner sensor detec-
tion
Rear corner sensor detec-
tion
Rear center sensor detec-
tion
Touch screen (vehicles with a navigation system)
When the Toyota parking
assist monitor or Multi-ter-
rain Monitor is not displayed
The graphic is automatically
displayed when an obstacle is
detected. The screen can be
set so that the graphic is not
displayed. (
P. 243)
When the Toyota parking
assist monitor or Multi-ter-
rain Monitor is displayed
(insert display)
A simplified image is dis-
played on the touch screen
when an obstacle is detected.

239 2-4. Using other driving systems
2
When driving
L/C200_EE (OM60G38E)
Sensor detection display, obstacle distance
Corner sensors
Approximate
distance to obstacleMulti-
information
displayTouch screen
Insert display
Front:
50 cm (1.6 ft.) to
37.5 cm (1.2 ft.)
Rear:
60 cm (2.0 ft.) to
45 cm (1.5 ft.)(continuous)(continuous) (blinking)
Front:
37.5 cm (1.2 ft.) to
25 cm (0.8 ft.)
Rear:
45 cm (1.5 ft.) to
30 cm (1.0 ft.)(continuous)(continuous)
(blinking rapidly)
Front:
Less than 25 cm
(0.8 ft.)
Rear:
Less than 30 cm
(1.0 ft.)(blinking)(continuous) (continuous)

240 2-4. Using other driving systems
L/C200_EE (OM60G38E)Rear center sensors
Approximate distance
to obstacleMulti-information
displayTouch screen
(insert display)
150 cm (4.9 ft.) to
80 cm (2.6 ft.)
(continuous)(blinking slowly)
80 cm (2.6 ft.) to
65 cm (2.1 ft.)
(continuous)(blinking)
65 cm (2.1 ft.) to
50 cm (1.6 ft.)
(continuous)(blinking rapidly)
Less than
50 cm (1.6 ft.)
(blinking)(continuous)

241 2-4. Using other driving systems
2
When driving
L/C200_EE (OM60G38E)Buzzer operation and distance to an obstacle
A beep sounds when the corner sensors and rear center sensors
are operating.
The buzzer beeps faster as the vehicle approaches an obstacle.
When the vehicle comes within the following distance of the obsta-
cle, the buzzer sounds continuously:
• Front corner sensors: Approximately 25 cm (0.8 ft.)
• Rear corner sensors: Approximately 30 cm (1.0 ft.)
• Rear center sensors: Approximately 50 cm (1.6 ft.)
When 2 or more obstacles are detected simultaneously, the beep
system responds to the nearest obstacle. If one or both come
within the above distances, the beep will repeat a long tone, fol-
lowed by fast beeps.
You can change the volume of the warning beeps. (P. 243)

242 2-4. Using other driving systems
L/C200_EE (OM60G38E)
Detection range of the sensors
Approximately 60 cm (2.0 ft.)
Approximately 150 cm (4.9 ft.)
Approximately 50 cm (1.6 ft.)
The diagram shows the detection
range of the sensors. Note that
the sensors cannot detect obsta-
cles that are extremely close to
the vehicle.
The range of the sensors may
change depending on the shape
of the object etc.

243 2-4. Using other driving systems
2
When driving
L/C200_EE (OM60G38E)
Setting up Toyota parking assist-sensor (vehicles with naviga-
tion system)
You can change the warning beep volume and touch screen operat-
ing conditions.
Press the “SETUP” button.
Touch “Vehicle” on the “Setup” screen.
Touch “Toyota park assist” on the “Vehicle Settings” screen.
Alert volume setting
Display on/off
Alert distance setting
 Alert volume setting
The alert volume can be adjusted.
Touch “1” to “5” on the “TOYOTA park assist settings”.
Touch “OK”.
STEP1
STEP2
STEP3
STEP1
STEP2