2012 TOYOTA IQ maintenance

324
4-3. Do-it-yourself maintenance
iQ_WE_74014E
Replacing the tire
When raising your vehicle with a jack, position the jack correctly.
Improper placement may damage your vehicle or cause injury.
Before jacking up the vehicle
Stop the vehicle on a hard, flat surface.
Set the parking brake.
Shift the shift lever to P (Multidrive) or R (manual transmis-
sion).
Stop the engine.
Location of the jack and tools
Towing eyelet
Jack
Wheel nut wrench
Wheel chock
Wheel chock
Jack handle

325 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014E
Taking out the jack
Vehicles with rear seat
Pull the strap horizontally as
shown. The latch under the seat
cushion will release, allowing the
seat cushion to be raised.
Take off the button and open the
strap.
Anchor the strap to the head
restraint.
When returning the rear seat, put
the strap back to the original
place.

326 4-3. Do-it-yourself maintenance
iQ_WE_74014ERemove the auxiliary box.
Loosen and remove the jack.
Loosen
Tighten
Vehicles without rear seat
Open the lid.
Remove the auxiliary box.

327 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014ELoosen and remove the jack.
Loosen
Tighten
Replacing a tire
Chock the tires.
Tire positionWheel chock
positions
Front
Left-
hand
side
Behind and
in front of
the rear
right-hand
side tire
Right-
hand
side
Behind and
in front of
the rear
left-hand
side tire
Rear
Left-
hand
side
Behind and
in front of
the front
right-hand
side tire
Right-
hand
side
Behind and
in front of
the front
left-hand
side tire

328 4-3. Do-it-yourself maintenance
iQ_WE_74014ESlightly loosen the wheel nuts
(one turn).
Check the jack point.
Turn the jack portion “A” by hand
until the notch of the jack is in
contact with the jack point.
Outer

329 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014ERaise the vehicle until the tire is
slightly raised off the ground.
Remove all the wheel nuts and
the tire.
When resting the tire on the
ground, place the tire so that the
wheel design faces up to avoid
scratching the wheel surface.
Installing the tire
Remove any dirt or foreign mat-
ter from the wheel contact sur-
face.
If foreign matter is on the wheel
contact surface, the wheel nuts
may loosen while the vehicle is in
motion, and the tire may come off
the vehicle.

330 4-3. Do-it-yourself maintenance
iQ_WE_74014EInstall the tire and loosely tighten each wheel nut by hand by
approximately the same amount.
Tighten the nuts until the wash-
ers comes into loose contact with
the disc wheel sheet.
Lower the vehicle.
Firmly tighten each nut two or
three times in the order shown in
the illustration.
Tightening torque:
103 N·m (10.5 kgf·m, 76 ft·lbf)
Stow the jack and all tools.
Disc wheel
Washer

331 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014E
Certification for the jack