2012 TOYOTA HILUX wheel

542 5-1. Essential information
HILUX_EE (OM0K132E)
Emergency towing
If a tow truck is not available in
an emergency, your vehicle may
be temporarily towed using a
cable or chain secured to the
emergency towing eyelet(s).
This should only be attempted
on hard surfaced roads for short
distances at low speeds.
A driver must be in the vehicle to
steer and operate the brakes.
The vehicle’s wheels, drive train,
axles, steering and brakes must
be in good condition.

544 5-1. Essential information
HILUX_EE (OM0K132E)
Towing with a wheel-lift type truck
From the front
Vehicles with automatic trans-
mission: Use a towing dolly
under the rear wheels.
Vehicles with manual transmis-
sion: We recommend using a
towing dolly under the rear
wheels.
When not using a towing dolly,
release the parking brake and
shift the shift lever to N.
From the rear (Pre Runner)
Turn the engine switch to the
“ACC” position so that the steer-
ing wheel is unlocked.
From the rear (4WD models)
Use a towing dolly under the
front wheels.

546 5-1. Essential information
HILUX_EE (OM0K132E)
NOTICE
To prevent causing serious damage to the transmission and transfer
(4WD models) when towing using a wheel-lift type truck (vehicles with
automatic transmission)
Pre Runner: Never tow this vehicle from the front with the rear wheels on the
ground.
4WD models: Never tow this vehicle with any of the wheels in contact with
the ground.
To prevent damage to the vehicle when towing using a wheel-lift type
truck (vehicles with manual transmission)
Do not tow the vehicle from the rear when the engine switch is in the
“LOCK” position or the key is removed. The steering lock mechanism is
not strong enough to hold the front wheels straight.
When raising the vehicle, ensure adequate ground clearance for towing at
the opposite end of the raised vehicle. Without adequate clearance, the
vehicle could be damaged while being towed.
To prevent body damage when towing with a sling-type truck
Do not tow with a sling-type truck, either from the front or rear.

5
551 5-2. Steps to take in an emergency
When trouble arises
HILUX_EE (OM0K132E)
Warning lightWarning light/Details
SRS warning light
Indicates a malfunction in:
• The SRS airbag system; or
• The seat belt pretensioner system
ABS warning light
Indicates a malfunction in:
• The ABS; or
• The brake assist system (vehicles with VSC system)
(flashes)
and
VSC OFF and slip indicator lights (if equipped)
Indicates a malfunction in:
• Vehicle stability control; or
• Traction control
(flashes rapidly)
Four-wheel drive indicator light
Indicates a malfunction in the four-wheel drive system
(P. 211)
(flashes)
Cruise control indicator light (if equipped)
Indicates a malfunction in the cruise control system
(P. 202)
Automatic transmission fluid temperature warning
light (if equipped)
Indicates that the automatic transmission fluid tempera-
ture is too high.
Timing belt replacement warning light
Indicates that the timing belt should be replaced

562 5-2. Steps to take in an emergency
HILUX_EE (OM0K132E)
Taking out the spare tire
Assembling the jack handle.
Remove the jack handle end, jack handle extensions and
wheel nut wrench from the tool bag and assemble by follow-
ing these steps.
Loosen the bolts using a
screwdriver.
Assemble the jack handle
end, jack handle extensions
and wheel nut wrench and
tighten the bolts.
Check that the bolts are firmly
tightened.
Insert the jack handle extension
into the lowering screw.
Lower
Raise
Place a rag under the jack handle
extension to protect the bumper.
STEP1
STEP2

564 5-2. Steps to take in an emergency
HILUX_EE (OM0K132E)
Replacing a flat tire
Chock the tires.
STEP1
Flat tireWheel chock positions
FrontLeft-hand side Behind the rear right-hand side tire
Right-hand side Behind the rear left-hand side tire
RearLeft-hand side In front of the front right-hand side tire
Right-hand side In front of the front left-hand side tire

5
565 5-2. Steps to take in an emergency
When trouble arises
HILUX_EE (OM0K132E)Remove the wheel ornament.
Ty p e A
Pry off the wheel ornament,
using the beveled end of the
wheel nut wrench as shown.
To protect the wheel ornament,
place a rag between the wheel
nut wrench and the wheel orna-
ment.
Ty p e B
Pry off the wheel ornament,
using the beveled end of the
wheel nut wrench as shown.
To protect the wheel ornament,
place a rag between the wheel
nut wrench and the wheel orna-
ment.
Slightly loosen the wheel nuts
(one turn).
STEP2
STEP3

5
567 5-2. Steps to take in an emergency
When trouble arises
HILUX_EE (OM0K132E)Raise the vehicle until the tire is
slightly raised off the ground.
When positioning the jack under
the rear axle housing, make sure
the groove on the top of the jack
fits with the rear axle housing.
If the tire is still underneath the
vehicle, leave the vehicle jacked
up and use a tool to pull the tire
out.
Remove all the wheel nuts and
the tire.
When resting the tire on the
ground, place the tire so that the
wheel design faces up to avoid
scratching the wheel surface.
STEP6
STEP7
CAUTION
When take out the spare tire
Be careful not to touch the exhaust, as you may burn yourself.
Be careful not to injure yourself by trapping your hands in or becoming
caught in the rear under protection.