2012 SSANGYONG RODIUS relay

02-298710-01
This vehicle has the windshield heated glass and the tailgate and outside rearview mirror heated
glass. The heater relay in the ICM box controls the tailgate and outside rearview mirror heated
glass and its fuse (15A) is located in the engine compartment fuse box.
Windshield, rear rear glass and outside
rearview mirror heated glass switch

02-36
12) Time Lag Power Window Control
<007b008f008c004700970096009e008c00990047009e00900095008b0096009e00470090009a0047009b009c00990095008c008b00470096008d008d0047009e008f008c00950047009b009c0099009500900095008e0047009b008f008c00470090008e00
950090009b00900096009500470092008c00a00047009b0096> “ON” position.
<007b008f008c004700970096009e008c00990047009e00900095008b0096009e00470099008c0093008800a000470090009a0047009b009c00990095008c008b004702c80076007502c90047008d009600990047006000570047009a008c008a0096009500
8b009a0047004f007b005800500047009e008f008c00950047>turning the ignition key to
“OFF” position.
However, the power window relay stays on for 90 seconds (T2) when the ignition key is turned
to “OFF” position while the door is opened.
The
p<0096009e008c00990047009e00900095008b0096009e00470099008c0093008800a000470090009a0047009b009c00990095008c008b004702c80076007502c900470088008e0088009000950047008d009600990047006000570047009a008c008a009600
95008b009a0047004f007b0059005000470091009c009a009b> for once when opening
the door during its extended operation period of 90 seconds (T1).
<007b008f008c004700970096009e008c00990047009e00900095008b0096009e00470099008c0093008800a000470090009a0047009b009c00990095008c008b004702c80076006d006d02c90047009e008f008c00950047008a00930096009a0090009500
8e0047009b008f008c0047008b0096009600990047008b009c>ring its extended operation
period of 90 seconds (T2). 1.
2.
3.
4.

02-378710-01
13) Theft Deterrent
(1) Description of Burglar Alarm Function
The “LOCK” output is “ON” when receiving the “LOCK” signal from transmitter while the ignition
key is removed and all doors are closed. The armed mode is activated when the door lock
switch is locked (theft deterrent horn output: once, hazard relay output: twice).
<007b008f008c0047009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047008f009600990095004700880095008b0047008f008800a100880099008b00470099008c0093008800a000470096009c009b0097009c009b009a004700
880099008c004702c80076007502c90047009e008f008c0095> receiving the “LOCK” signal
from the remote control key again in armed mode (theft deterrent horn output: once, hazard
relay output: twice).
<007e008f008c009500470099008c008a008c0090009d00900095008e004702c800730076006a007202c90047009a0090008e0095008800930047008d0099009600940047009b008f008c00470099008c00940096009b008c0047008a00960095009b009900
96009300470092008c00a00047009e008f00900093008c0047>any of doors is not closed,
<00960095009300a00047009b008f008c004702c800730076006a007202c900470096009c009b0097009c009b0047008a0088009500470089008c0047008b00960095008c004700880095008b0047009b008f008c009500470088008a009b0090009d008800
9b008c009a0047009b008f008c0047008800990094008c008b> ready mode (without theft
deterrent horn and hazard warning flasher). At this moment, if the ignition key is in the ignition
<009a009e0090009b008a008f00530047009b008f008c0047008b0096009600990047009c009500930096008a00920047009a009e0090009b008a008f00470090009a0047009b009c00990095008c008b004702c80076007502c90047009600990047009b00
8f008c0047008b009600960099004700930096008a00920047>switch is unlocked (after 0.6
seconds), cancels the armed mode and activates the normal mode. However, in these cases, if
closing the door and locking the door lock switch, the theft deterrent horn outputs once and the
hazard warning flasher outputs twice and then activates armed mode.
When the door is not opened or the ignition key is not inserted into ignition switch for 30
seconds after receiving “UNLOCK” signal, outputs “LOCK” and then activates armed mode
(RELOCK operation). Also, at this moment, the system outputs the theft deterrent horn and
hazard warning flasher.
The armed mode will not be activated except above conditions.
Ex) The armed mode will not be activated when the door is locked by the ignition key. 1.
2.
3.
4.
5.
▶Theft deterrent mode ON conditions

06-38510-00
1. SPECIFICATIONS
1) Multifunction Switch
2) Auto Light Sensor
Description Description
Multifunction
switchRated voltage DC 12V
Operating temperature-30℃~+80℃
Rated load Light switch ON: 1A (Relay load)
Dimmer and passing switch High beam/low beam/passing:
0.3A (Relay load)
Turn signal switch6.6±0.5A (Lamp load)
Wiper switch Low: 5A, High: 7A (Motor load)
Auto: 0.22±0.05A (Relay load)
Fixed: max. 28A (Motor load)
Washer switch 4A (Motor load)
Intermittent wiper switch max. 25 mA
Mist switch 5A (Motor load)
Description Description
Auto light sensor unit Operating voltage 9~16V
Load max. 200 mA (Relay load)
Operating temperature-30℃~+85℃
Storage temperature-40℃~+120℃
Location On the left top of instrument panel

08-4
ICM box
The wiper related relays are installed in
ICM box.
Relay5
(Wiper INT-Low)Relay6
(Wiper High)
STICS
The rain sensing unit detects the amount of rain drops and sends
the operating signal to STICS, and STICS drives the wiper directly.
At this moment, STICS determines the wiper operation mode
(washer, MIST, AUTO), then sends the information to the rain
sensor.

08-78610-11
▶ Rain sensing operation point
The wiper relay is turned on and the wiper motor runs one cycle when the ignition key is
<009b009c00990095008c008b0047009b0096004702c80076007502c9004700970096009a0090009b0090009600950047004f009e008f00900093008c0047009b008f008c0047009e00900097008c00990047009a009e0090009b008a008f00470090009a00
4700900095004702c80068007c007b007602c9004700970096>sition).
The wiper relay (LO) is turned on and the wiper motor runs one cycle when changing the
<009e00900097008c00990047009a009e0090009b008a008f0047009b0096004702c80068007c007b007602c9004700970096009a0090009b0090009600950047008d00990096009400470088009500a000470096009b008f008c0099004700970096009a00
90009b009000960095009a0047004f009e008f00900093008c> the ignition key is in “ON”
<00970096009a0090009b009000960095005000550047007e008f008c00950047009b008f008c0047009e00900097008c00990047009a009e0090009b008a008f00470090009a0047009b009c00990095008c008b0047009b0096004702c80068007c007b00
7602c9004700970096009a0090009b00900096009500470088>gain from other positions, the
system drives the wiper relay (LO) to run the wiper motor one cycle only when the rain sensor
detects the “Rain Detected” signal. 1)
2)

08-8
The wiper relay is turned on and the wiper motor runs one cycle when the volume sensitivity is
<00900095008a0099008c0088009a008c008b0047004f008c009f00610047008d009900960094004700570047009b00960047005800500047004f009e008f00900093008c0047009b008f008c00470090008e00950090009b00900096009500470092008c00
a000470090009a004700900095004702c80076007502c90047>position, the wiper switch is in
“AUTO” position, and the wiper motor is in “Parked” position). However, the wiper motor can be
<00960097008c00990088009b008c008b004700960095009300a00047009e008f008c00950047009b008f008c004700990088009000950047009a008c0095009a009600990047008b008c009b008c008a009b009a0047009b008f008c004702c80079008800
9000950047006b008c009b008c008a009b008c008b02c90047>signal.
▶ Rain sensing sensitivity control
If the volume sensitivity is changed more than 2 stages within 2 seconds, the wiper motor runs
only one cycle. *

08-10
The wiper relay (LO) is turned on and the wiper motor runs one cycle when the wiper sensitivity is
changed to 2 from 3 during receiving the malfunction signal (1) from the rain sensor. However,
the wiper motor can be operated only when the rain sensor detects the "Rain Detected" signal. 1)
If the volume sensitivity is changed more than 2 stages within 2 seconds, the wiper motor
runs only one cycle. ▶ Defective rain sensor