2012 SSANGYONG RODIUS turn signal

02-358710-01
▶Auto Door Unlock (Crash Unlock)
The air bag collision signal input cannot be accepted within 7 seconds after turning the ignition
key to "ON" position.
After this period, the door lock system outputs "UNLOCK" for all doors for 5 seconds from 40
ms after receiving the air bag collision signal.
Even though the key is turned to "OFF" position during the output of "UNLOCK", the output
continues on for remaining period.
The function is erased when turning "OFF" the ignition switch. 1.
2.
3.
4.
The "Unlock" control by air bag signal prevails over any "LOCK" or "UNLOCK" control by
other functions.
The "LOCK/UNLOCK" request by other functions will be ignored after/during the output of
"UNLOCK" by the air bag. However, the door lock is controlled by other functions when the
ignition switch is "OFF".
"LOCK" (or "UNLOCK") output is ignored if "LOCK" (or "UNLOCK") output is required while
performing the output of "LOCK" (or "UNLOCK"). (However, UNLOCK by air bag signal and
operation by the remote control key are valid.)
If the door lock system outputs "LOCK" and "UNLOCK" simultaneously, only the "LOCK"
output can be activated. 1.
2.
3.
4.

02-38
▶Armed mode cancellation requirements
Unlocking by remote control key or engine starting. 1.
▶Warning operation requirements
When opening the door in armed mode
When unlocking the door lock switch in armed mode
When closing and then opening the door after completion of warning (27 seconds) 1.
2.
3.
▶Warning operation
<007b008f008c0047009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047008f009600990095004700880095008b0047008f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c00
9900470096009c009b0097009c009b00470090009a004702c8>ON” for T3 (27 seconds) with
the interval of T2 (1second). 1.
▶Warning cancellation requirements
Cancels warning by using any signal from the remote control key (LOCK, UNLOCK, START,
STOP, PANIC, CHECK) during warning operation.
<006a00880095008a008c0093009a0047009e00880099009500900095008e00470088008d009b008c009900470059005e0047009a008c008a00960095008b009a0047004f0099008c009400880090009500900095008e00470097008c009900900096008b00
500047009e008f00900093008c0047009b008f008c00470090>gnition key is turned to “ON”
position. 1.
2.
▶Operation when warning is cancelled
<007b008f008c0047009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047008f009600990095004700880095008b0047008f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c00
9900470096009c009b0097009c009b009a004700880099008c> “OFF”. 1.

02-398710-01
The PANIC warning outp<009c009b00470090009a004702c80076007502c90047004f009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047008f00960099009500500047009e008f008c009500470099008c008a008c0090009d00900095008e0047009b00
8f008c00470077006800750070006a0047009a0090008e0095>al from
the remote control key (pressing PANIC button for less than 0.5 ~ 1.0 second).
<007b008f008c00470077006800750070006a0047009e00880099009500900095008e00470096009c009b0097009c009b00470090009a004702c80076006d006d02c90047009e008f008c009500470099008c008a008c0090009d00900095008e0047008800
9500a00047009a0090008e0095008800930047008d00990096>m the remote control key
during PANIC warning.
Followings are theft deterrent warnings:
This function operates only in armed mode.
The system sends the current vehicle conditions (LOCK, engine running) when the PANIC
warning is turned off by the remote control key. 1.
2.
3.
4.
5.The theft deterrent warning is canceled when receiving PANIC signal from the remote control
key during theft deterrent.
<007b008f008c0047009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047009e00880099009500900095008e00470096009c009b0097009c009b00470090009a004702c80076007502c90047009e008f008c00950047009b008f00
8c0047009b008f008c008d009b0047008b008c009b008c0099>rent conditions are
<008c009a009b0088008900930090009a008f008c008b0047008b009c009900900095008e00470077006800750070006a0047009e00880099009500900095008e0047004f0077006800750070006a00470096009c009b0097009c009b00470090009a004702
c80076006d006d02c900500055>
<007b008f008c00470077006800750070006a0047009e00880099009500900095008e00470096009c009b0097009c009b00470090009a004702c80076007502c90047009e008f008c009500470099008c008a008c0090009d00900095008e0047009b008f00
8c00470077006800750070006a0047009a0090008e00950088>l from the remote control
key in Armed Ready / Armed / Warning Completion / Relock Ready mode (maintaining the
theft deterrent mode). 1)
2)
3)
(2) PANIC Warning

03-77010-06
ECU
Immobilizer Indicator and Warning Lamp ▶
This indicator comes on when the ignition
key is communicating with the engine
control unit (during engine starting) and
goes out after starting the engine.
When turning the ignition key to ON
position, the ECU transmits the challenge
message to the immobilizer unit to verify
whether the key is valid. (1)
Only when the two signals are identical, it
recognizes the key as the authorized one and
transmits the positive message to the ECU.
The ECU allows the engine to be started. (6)
(7)
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, let the owner attend on the site.
In any case, the immobilizer system cannot be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed on the vehicle equipped with the immobilizer
system. -
-
-
-
-Lamp ON: in communication
Blinking twice for one second: immobilize
r
system failure
Blinking once for two seconds: immobiliz
e
unit is not coded
The immobilizer indicator does not
come on if the communication time
between immobilizer key and ECU is
too short.
Immobilizer Indicator and Warning Lamp

05-4
(1) Front Lamps
HeadlampHeadlamp
Right fog lamp
(12V-5W)
Left fog lamp
(12V-5W)
Low beam (12V-55W)Tail lamp (12V-5W)
High beam (12V-55W)Turn signal lamp
(12V-28W)
Connector
Tail lamp
Tail lamp/Turn
signal lamp
connector
Turn signal lamp Headlamp
(Low beam) Headlamp
(High beam)
Side repeater (12V-5W)

05-58310-01
(2) Rear Lamps
High mounted stop lamp
(12V-6W)
License plate lamp
(12V-5W, 2)
Tail lamp assembly
Rear lamp
Stop lamp (12V-8W)
Rear turn signal lamp (12V-27W)
Tail lamp (12V-8W)
Stop lamp
Rear turn signal lamp or
rear fog lamp (LH only)
Tail lamp
Tail lamp assembly
connector

06-38510-00
1. SPECIFICATIONS
1) Multifunction Switch
2) Auto Light Sensor
Description Description
Multifunction
switchRated voltage DC 12V
Operating temperature-30℃~+80℃
Rated load Light switch ON: 1A (Relay load)
Dimmer and passing switch High beam/low beam/passing:
0.3A (Relay load)
Turn signal switch6.6±0.5A (Lamp load)
Wiper switch Low: 5A, High: 7A (Motor load)
Auto: 0.22±0.05A (Relay load)
Fixed: max. 28A (Motor load)
Washer switch 4A (Motor load)
Intermittent wiper switch max. 25 mA
Mist switch 5A (Motor load)
Description Description
Auto light sensor unit Operating voltage 9~16V
Load max. 200 mA (Relay load)
Operating temperature-30℃~+85℃
Storage temperature-40℃~+120℃
Location On the left top of instrument panel

08-6
1) Rain Sensor Coupled Wiper
▶ System layout
This vehicle has a different wiper control logic compared to other models. As shown in the
system diagram, the rain sensor unit does not control wiper directly. The rain sensor unit sends
infrared rays signal through LED and then receives it with photo diode and then sends the
returned signal to STICS and the STICS controls the wipers directly.
For more details, refer to rain sensing wiper section in this manual.