Page 409 of 828
01-4
3. CAPACITY AND NAME OF FUSE AND RELAY IN ENGINE
COMPARTMENT
The label attached on each fuse
box indicates only major fuses and
relays. Therefore, there are more
fuses and relays than indicated.
For details about the connection
of fuses and relays, refer to the
power distribution circuit diagram
on the following pages. *
Page 472 of 828
02-58
Circuit Diagram for Wiper ▶
4. CIRCUIT DIAGRAM
Page 473 of 828
02-598710-01
Circuit Diagram for Door Lock Control ▶
The door ajar warning lamp in the instrument cluster does not come on even though the
tailgate is opened.
Page 482 of 828
03-4
2) System Diagram
The certification for the immobilizer is performed when turning the ignition switch to the "ON" position
after the CAN communication between the ECU and immobilizer is established.
Page 490 of 828
Page 504 of 828
04-138210-01
3) Fuel Level Gauge
The fuel level gauge displays the resistance value of the float on the fuel sender in the fuel tank
through a pointer. Note that this vehicle doesn't have a service hole for checking the fuel sender
connector in the fuel tank.
The fuel sender and its connector can be checked and replaced only when the fuel tank is
removed. The power supply and resistance value should be measured at the connector in front of
the fuel sender (refer to wiring diagram).
When the power supply and output resistance are normal, the float operation by fuel level may be
defective; if so, replace the fuel sender.
Low fuel warning lamp comes on when:
The fuel level drops to 9 L or less. The lamp goes off if the fuel level reaches 9.5 L or more.This table shows the tolerance and resistance value changes by fuel level in normal
conditions. Therefore, the differences that can be occurred by the road conditions and fuel
fluctuations are ignored.
Page 514 of 828
04-238210-01
5. CIRCUIT DIAGRAM
Page 526 of 828
07-97810-01
4. CIRCUIT DIAGRAM