03-10
2) Rechargeable Key Function (Charging)
If the communication between ECU (engine control unit), immobilizer & rechargeable unit and
transponder is establisehd successfuly (engine started), the rechargeable Li-ion battery in the
transmitter is charged.
The charging is made by creating the mutual induced electromotive force in the antenna coil and
by supplying the charging current to the battery in the key. This charging is not resulted from the
direct contact but the induced electromotive force of the coil in the transmitter according to the
change of magnetic field. For details, see the below:
Primary magnetic
induction coil Secondary magnetic
induction coil
The single coil has both immobilizer
function and recharge function.
For the immobilizer function, if the
transponder confirms the key as the
startable key by communicating with the
ECU, it induces a magnetic induction in the
primary coil by passing through the current
with a certain frequency to the immobilizer
coil. The induced electromotive force
created in this way, is stored in the
chargeable battery through the commutator
and the circuit. Primary magnetic
induction coil
(for charging
battery)
Chargeable batteryImmobilizer &
rechargeable unit
02-12
4. DEPLOYMENT
According to the collision deceleration rate that each collision G sensor reads, the air bag unit
sends out about 2~4 or higher Amp current. This current generates some heat, which fires the
detonator in the inflator.
The table shows the basic inner resistance of the air bag related module and the basic instant
current necessary for firing.
1) Air Bag System Deployment (Firing Loop)
2) Air Bag Deployment Signal Output (Crash Out)
When the air bag deploys, the signal is sent to STICS to perform the basic security operation
which is the automatic door unlock function that release the automatic door lock mode.
Deployment signal
output (crash out)200ms
Automatic Door Unlock (Crash unlock: unlock when colliding) ▶
The air bag collision signal input cannot be accepted within 7 seconds after turning the ignition
key to "ON" position.
After this period, the door lock system outputs "UNLOCK" for all doors for 5 seconds from 40
ms after receiving the air bag collision signal.
Even though the key is turned to "OFF" position during the output of "UNLOCK", the output
continues on for remaining period.
The function is erased when turning "OFF" the ignition switch. 1.
2.
3.
4.
Air bag module
DAB /PABSeat belt pretensioner(BPA)
Resistance (at -30 ~ 85˚C) 2 ±0.3 Ω 2.15 ±0.35 Ω
Firing current 1.2 Amps 0.8 Amps
Please do not connect a tester to any air bag connector or single item to measure the
supplied power or resistance. The detonator may explode due to a sudden extra power
supplied by the tester.
Before removing or installing any air bag related components, disconnect the negative
battery cable. -
-
