2012 SSANGYONG KORANDO warning

03-218710-01
2) Ignition Key Reminder
Key reminder warning
(This function has priority over the "Tail lamp on warning".) ▶
When opening the driver door while the ignition key is inserted into the key cylinder, the buzzer sound
for 10 seconds with the interval of 0.02 s ON and 1.38 s OFF.
When removing the ignition key or closing the driver door during the buzzer output (within 10
seconds), the buzzer stops its operation.
This function is not available when the ignition switch (IGN1) is in "ON" position. 1.
2.
3.

03-24
3) Tail Lamp
Tail lamp left ON warning (sunroof and ignition key reminder functions have priority) ▶
The buzzer sounds for 10 seconds with the interval of 0.02 s ON and 1.38 s OFF when opening the
driver door with the key removed (without SKM)/with IGN OFF or ACC (with SKM) and tail lamp ON.
The buzzer stops its operation when turning off the tail lamp or closing the driver door during buzzer
operation. The buzzer stays ON when turning the tail lamp on again after turning it off during buzzer
operation.
This function is not available when the ignition switch (IGN1) is in ON position. 1.
2.
3.

03-258710-01
Tail lamp auto OFF ▶
When opening and closing the driver door after turning off the ignition with the tail lamp ON, the tail
lamps go off automatically.
The tail lamps come on again when inserting the ignition key (without SKM) and turning on the
ignition (with SKM) after tail lamp auto OFF.
The tail lamp should not go off when turning on the tail lamp switch with the ignition key removed
(without SKM) and with power off or ACC ON (with SKM). 1.
2.
3.
Tail lamp ON warning (with SKM) ▶
The tail lamp ON warning signal is sent via the BCAN communication when the tail lamp remains ON
with the ignition key OFF or ACC. 1.

03-26
4) Door Ajar Warning
While the BCM without SKM controls the warning lamp, the BCM with SKM controls the warning lamp
and sends the signal via the BCAN communication. But, this control is available only when any of doors
or tailgate, except engine hood, is open.
The instrument cluster controls the door ajar warning lamp according to the signal from the BCM.
(However, the BCM controls the door ajar warning lamp with the electric wire together with the BCAN
communication.)
Also, the instrument cluster controls the blinking function according to the vehicle speed.
(However, the BCM controls the door ajar warning lamp blinking with the electric wire together with
the BCAN communication.) 1.
2.
(*1) : Ajar: Driver, passenger, rear door or tailgate is open
Close: Driver, passenger, rear door and tailgate are closed

03-278710-01
5) Seat Belt
Seat belt warning ▶
When turning the ignition switch (IGN1) to ON from OFF position, the BCM sends the driver and front
passenger seat belt warning signals to the instrument cluster module through the CAN
communication, and the buzzer sounds for 0.6 seconds with the interval of 0.02 s ON and 1.38 s
OFF. If the driver/passenger seat belts are fastened, the buzzer does not sound but the warning lamp
blinks during the period. (the buzzer is controlled by BCM and the warning lamp is controlled by ICM)
For the passenger seat, however, the system detects if the passenger seat is empty or occupied and
operates the warning lamp only for the first time.
After that, the only seat belt reminder detects if the passenger seat is occupied.
For the driver seat, the seat belt reminder operates only when the seat belt is not fastened at the
vehicle speed of 25 km/h or higher.
The instrument cluster module controls the driver/passenger seat belt warning lamps by receiving the
driver/passenger seat belt warning lamp signals.
When turning the ignition switch (IGN1) to OFF position during the warning operation, the buzzer
stops and the warning lamp goes off.
If the driver/passenger seat belt is fastened during the warning operation, the buzzer stops but the
warning lamp blinks for the remaining time of the period.
If the driver/passenger seat belt signal changes to "unfastened" from "fastened" with IGN1 ON, the
driver/passenger seat belt warning lamp comes on and the buzzer sounds again for 0.6 seconds.
But, if the condition for seat belt reminder operation is met during the warning operation, the warning
operation stops and the seat belt reminder function is activated. 1.
2.
3.
4.
5.

03-28
Seat belt reminder ▶
Operating conditions for seat belt reminder are as follows: IGN ON, engine running (over 300 rpm),
vehicle speed of 25 km/h or higher, driver seat belt unfastened, passenger seat belt unfastened and
passenger seat occupied. In addition, if the seat belt reminder is activated at the speed of 25 km/h or
higher and the speed reduces to below 25 km/h within 5 minutes, the interior buzzer sound stops. The
buzzer sounds for 5 minutes again when the speed is 25 km/h or higher.
The seat belt reminder stops its operation when fastening the seat belt, but starts the operation again if
unfastening the seat belt.
If the seat belt reminder is initially operated due to unfastened driver seat belt, the buzzer sounds with
the interval of 0.02s ON/1.18s OFF, the instrument cluster sends the driver seat belt warning signal
(SBR) and the seat belt warning lamp stays on.
At this time, the buzzer sounds for 5 minutes.
If the seat belt reminder is operated due to unfastened passenger seat belt when the passenger seat
belt reminder sensor detects that the passenger seat is occupied, the instrument cluster sends the
driver seat belt warning signal and the seat belt warning lamp stays on.
For this case, the indicator shows each status of the driver and passenger seats but the indoor buzzer
is common to both seats.
If the simultaneous operating condition for the indoor buzzer is met, the driver seat has the priority.
If the driver seat belt is fastened, the same operation is also carried out in the passenger seat
automatically.
The buzzer and the warning lamp are operated according to the vehicle speed as below table during
the seat belt reminder operation. 1.
2.
3.
4.
5.
Seat belt reminder operation
<007700990090009600990090009b00a000470096008d00470089009c00a100a1008c0099004700960097008c00990088009b00900096009500610047007a0069007900470d7d00470072008c00a000470099008c009400900095008b008c00990047009e00
880099009500900095008e00470d7d0047007a009c00950099>oof warning ⇒ Tail lamp ON
<009e00880099009500900095008e00470d7d0047006f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c009900470d7d0047007b009c009900950047009a0090008e009500880093004700930088009400
970055> 6.
Buzzer Warning lamp
25 Km/h ~ 49 Km/h 0.02s ON / 1.18s OFF Keep ON
50 Km/h ~ 99 Km/h 0.02s ON / 0.98s OFF Keep ON
10 Km/h ~ 49 Km/h 0.02s ON / 0.78s OFF Keep ONFunction
Vehicle speed
Seat belt remind warning lamp (EU only)
This lamp comes on for 6 seconds after turning on the ignition switch. If the vehicle speed goes
over 10 km/h without fastened the seat belt, the inside buzzer sounds. -