2012 SSANGYONG KORANDO remote control

03-70
4) Components of REKES Key
Battery cover
Side & main cover Battery: CR2032TransponderKey plate Remote control PCB
How to replace battery ▶
Remove the battery cover using a flat screwdriver to replace the battery.
How to replace transponder ▶
Remove battery cover and battery
Remove rubber cover and screw then remove key plate
Remove side cover and main cover
Replace transponder -
-
-
-
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, please attend on the site.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove, damage
or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer system. -
-
-
-
-

04-4
1. SYSTEM LAYOUT
The vehicles with smart key system are equipped with the SKM (Smart Key Module) unit. The SKM,
which does not use the traditional key or remote controller to access the vehicle, provides 3 functions.
The passive UNLOCK function unlocks the door after confirming the smart key information and the
driver's door conditions when the driver carrying a smart key touches the door handle. The passive
START function starts the engine when the START switch is pressed by the driver sitting on the driver's
seat. The passive LOCK function locks the door when the door handle switch is pressed by the driver
after exiting the vehicle.
Buzzer
Start switch
SKM unit
Outside door handle
switch and antenna

04-178712-03
3) REKES Control Function
(2) REKES UNLOCK
The SKM receives the signal for [REKES UNLOCK] 0.1 sec. after the UNLOCK button on the smart
key is turned ON, and sends this signal through the BCAN. - When the SKM receives the REKES signals by the buttons on the smart key, it transmits the
corresponding signals through the BCAN.
Switch Stage Remark
LOCK 1 step
100 ms: 1 step CMD
1500 ms: 2 step CMD
1000 ms: 3 step CMD unlocked 1 step
Tailgate open 3 step
PANIC 3 step
(3) Remote keyless tailgate open
When the SKM receives the signal for [REKES UNLOCK] by the UNLOCK button on the smart key, it
transmits this signal through the BCAN.
(1) REKES LOCK
The SKM receives the signal for [REKES LOCK] 0.1 sec. after the LOCK button on the smart key is
turned ON, and it transmits this signal through the BCAN.
When the REKES LOCK signal is received with the ACC ON, the ACC is turned OFF and the signal
for [REKES LOCK] is sent. -
- When the SKM receives the signal for [REKES LOCK] by the LOCK button on the smart key, it transmits
this signal through the BCAN.
The SKM receives the tailgate open signal 1 sec. after the tailgate open button on the smart key is
turned ON with the ignition status OFF, ACC or IGN ON, and it transmits the signal for [REKES
tailgate open] through the BCAN. - When the SKM receives the signal for [REKES tailgate open] by the tailgate open button on the smart
key, it transmits this signal through the BCAN.
Remote keyless tailgate open ▶

04-18
(4) Remote keyless panic
When the SKM receives the panic signal with the ignition status OFF, ACC ON or IGN ON, the SKM
transmits the REKES panic signal through the BCAN. The SKM transmits the signals for [REKES panic] by the panic button of the smart key to the BCM.
Panic siren mode by REKES panic control ▶ The SKM receives the REKES panic signal 1 sec. after the panic button on the smart key is turned ON
with the ignition status OFF, ACC or IGN ON, and it transmits this signal through the BCAN.Remote keyless panic ▶

06-4
Audio remote control switch
Previous Current
Bluetooth handsfree function added and button logo design changed

06-6
Steering wheel remote
control switchPassenger door switch
Lower main panel
switch
Start/stop switch
Cruise control switch
Hazard warning switch
bezel assembly
Multifunction switch
FATC switchDrive door main switch
& outside mirror switch
Switch layout ▶

06-98510-00
Door lock/unlock switch
When the door lock/unlock switch
is pressed while all doors
including the tailgate are locked,
all doors will be unlocked. When
the switch is pressed again, all
doors will be locked.Window lock switch
If the window lock switch is
pressed down, only driver window
is operative. Passenger and rear
windows cannot be operated by
their switches.
Rear LH window
switch
The window is up and down
while this switch is operated.
Passenger door
switch
The window is up and down
while this switch is operated.
Rear RH window
switch
The window is up and down
while this switch is operated.
Driver door window switch
The driver's door window switch has Auto down/Auto up function. The
window can be controlled within 30 seconds by activating the power
window relay even after turning off the ignition switch.
However, if any of front doors is opened or the Lock switch on the
remote control key is pressed (theft deterrent mode is activated)
during the delaying period, the delaying time is immediately canceled
(power window relay is deactivated).
There are two variants of this: only auto down and anti-trap (auto
down and auto up).

06-12
Door lock/unlock control by door LOCK switch ▶
When moving the driver or passenger door lock (knob) switch to LOCK from UNLOCK position, BCM
sends the LOCK signal for 0.5 seconds.
When moving the driver or passenger door lock (knob) switch to UNLOCK from LOCK position, BCM
sends the UNLOCK signal for 0.5 seconds.
The LOCK (UNLOCK) operation by the door lock (knob) switch is not available when sending the
LOCK (UNLOCK) signal by any other method such as remote control key.
When reconnecting the battery, the door lock (knob) switch is not operational regardless of the door
lock switch positions.
All doors stay unlocked when receiving the door lock signal in 0.5 seconds after closing the doors. 1.
2.
3.
4.
5.