2012 RENAULT TWINGO lights

5.4
ENG_UD28665_3
Kit de gonflage des pneumatiques (X77 - X85 - B85 - C85 - S85 - X77 ph2\
- K85 - X95 - E95 - X67 - X92 - X10 - X98 - X52 - Renault)
ENG_NU_952-4_X44_Renault_5
Jaune NoirNoir texte
tYre PreSSure KIt (2/3)
Depending on the vehicle, in the event
of a puncture, use the kit located in the
boot or underneath the luggage com -
partment carpet.
With the engine running and the
parking brake applied,
– unroll the hose from the container;
– connect the compressor hose 3 to
the container’s inlet 8;
– depending on the vehicle, connect
the container 8 to the compressor
from the container recess 7;
– unscrew the valve cap on the rel -
evant wheel and screw on the con -
tainer’s inflation adapter 1;
– adapter 2 must be connected to the
vehicle accessories socket;
– press switch 4 to inflate the tyre to
the recommended pressure (please
refer to the information in the section
on “Tyre pressure”);
45
1
Before using this kit, park
the vehicle at a sufficient
distance from traffic, switch
on the hazard warning
lights, apply the handbrake, ask all
passengers to leave the vehicle and
keep them away from traffic.
8
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation apply-
ing to the country you are in.
– after a maximum of 15 minutes, stop
inflating and read the pressure (on
pressure gauge 5).
n ote: while the container is empty -
ing (approximately 30 seconds), the
pressure gauge 5 will briefly indicate
a pressure of up to 6 bar. The pres-
sure will then drop.
– adjust the pressure: to increase
it, continue inflation with the kit; to
reduce it, press button 6.
If a minimum pressure of 1.8 bar is
not reached after 15 minutes, repair
is not possible; do not drive the ve-
hicle but contact an approved dealer.
2
3
7
6

changing a wheel.................................. (up to the end of the DU)
puncture ................................................ (up to the end of the DU)
5.8
ENG_UD24734_6
Changement de roue (X44 - Renault)
ENG_NU_952-4_X44_Renault_5
Jaune NoirNoir texte
Changing a wheel
Start extending jack 2 by hand, turning
the handle. Position the head correctly
under vertical sill seam 3 nearest to the
wheel concerned and marked by an
oblong hole.
Continue turning the handle to position
the baseplate of the jack on the ground
correctly.
Turn a few times to lift the wheel off the
ground, remove the bolts and take off
the wheel.
Vehicles equipped with a jack
and wheelbrace
If necessary, remove the wheel trim.
Use the wheelbrace to slacken off the
wheel bolts 1 . Fit it so that you press
downwards rather than pulling up -
wards.
cHAngIng A WHeeL (1/2)
Switch on the hazard warn-
ing lights.
Keep the vehicle away from
traffic and on a level sur -
face where it will not slip (if neces -
sary, place a solid support under the
jack base).
Apply the handbrake and engage a
gear (first or reverse).
Ask all the passengers to leave the
vehicle and keep them away from
traffic.
To prevent any risk of injury
or damage to the vehicle,
only crank the jack until the
wheel you are replacing is
a maximum of 3 centimetres off the
ground.
If the vehicle is not equipped with a
jack or wheelbrace, you can obtain
these from your approved dealer.
1
3
2

lights:main beam headlights ...................................... (current page)
lights: dipped beam headlights ................................... (current page)
front lights changing bulbs ................................ (up to the end of the DU)
lights changing bulbs ................................ (up to the end of the DU)
lights front ................................................. (up to the end of the DU)
bulbs changing ......................................... (up to the end of the DU)
5.14
ENG_UD26876_6
Projecteurs avant avec lampes halogènes : remplacement des lampes (X\
44 - Renault)
ENG_NU_952-4_X44_Renault_5
Jaune NoirNoir texte
Main beam headlights,
dipped beam headlights
– remove bulb holder 1 from its hous-
ing without pulling on the cable;
– remove cover 2;
– release the spring 3;
– change the bulb 4.
Bulb type: H4 60/55 W
Do not touch the bulb glass. Hold it
by its base.
The following bulbs can be replaced.
However, we would advise you to have
them replaced by an authorised dealer
if it proves difficult.
To return it, proceed in the reverse
order to removal.
It is recommended that the headlights
be adjusted after this operation.
FrOnt HeADLIgHtS:
changing bulbs (1/2)
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
The engine may be hot
during operations in close
proximity. In addition, the
engine cooling fan may
start at any moment.
Risk of injury.
4
1
2
3

feux :indicateurs de direction ................................. (page courante)
JauneNoirNoir texte
5.15
ENG_UD26876_6
Projecteurs avant avec lampes halogènes : remplacement des lampes (X\
44 - Renault)
ENG_NU_952-4_X44_Renault_5
Direction indicator lights
changing a bulb
– unclip cover 3 and remove it;
– turn bulb holder 4 anticlockwise;
– change the bulb 5.
Bulb type: PY21W.
FrOnt HeADLIgHtS: changing bulbs (2/2)
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
Any operation on (or modi -
fication to) the electrical
system must be performed
by an approved dealer
since incorrect connections could
damage the electrical equipment
(wiring, components, in particu -
lar the alternator). In addition, your
dealer has available all the parts
necessary for fitting electrical com -
ponents.
3
To return it, proceed in the reverse
order to removal.
When the bulb has been changed,
make sure you refit the cover 3 cor -
rectly.
4
5

lights:fog lights ......................................... (up to the end of the DU)
bulbs changing ......................................... (up to the end of the DU)
lights: side lights ........................................ (up to the end of the DU)
changing a bulb .................................... (up to the end of the DU)
5.16
ENG_UD26880_1
Feux de brouillard, feux de position avant: remplacement des lampes (X4\
4 - Renault)
ENG_NU_952-4_X44_Renault_5
Fog lights, front side lights
Front fog lights 1 and front
side lights 2Turn light trim 3 anticlockwise and
remove it.
Unscrew the two screws 4 (using a flat-
blade screwdriver or similar) as shown.Release the light 5.
Turn one of the bulb holders 7 anti -
clockwise and change the bulbs 6 or 8.
To reassemble, proceed in the reverse
order to removal.
Make sure the two screws are tight -
ened and replace the light trim.
Front fog lights 1
Bulb type: H11 or H11 LL.
Front side lights 2
Bulb type: W5W or W5W LL .
FOg LIgHtS, FrOnt SIDe LIgHtS: changing bulbs
Any operation on (or modi-
fication to) the electrical
system must be performed
by an approved Dealer
since an incorrect connection might
damage the electrical equipment
(harness, components and in partic-
ular the alternator). In addition, your
Dealer has all the parts required for
fitting these units.
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
1
23
47
8
5
6

rear lightschanging bulbs ................................................. (current page)
lights: brake lights ...................................................... (current page)
lights: direction indicator lights ................................... (current page)
lights: fog lights .......................................................... (current page)
lights: reversing lights ................................................. (current page)
changing a bulb .................................... (up to the end of the DU)
5.17
ENG_UD29236_5
Feux arrière : remplacement des lampes (X44 - Renault)
ENG_NU_952-4_X44_Renault_5
Rear lights
reAr LIgHtS: changing bulbs (1/4)
rear side lights and stop
light, indicator lights and fog
lights
Note the correct positioning of the
wiring 1 before removal in order to po-
sition correctly when refitting.
Remove screw 2 and detach the rear
light cluster from the outside. Unclip the bulb holder using tabs
2.
3 Side lights and brake lights
Pear shaped, bayonet type P 21/5 V
bulb with two filaments.
4 Indicator
Orange pear-shaped, bayonet type
PY 21 W bulb.
5 Fog light
Pear-shaped, bayonet type P 21W
bulb
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
212
3
4
5
In accordance with local legislation
or as a precautionary measure:
Obtain an emergency kit containing
a set of spare bulbs and fuses from
an approved Dealer.

5.18
ENG_UD29236_5
Feux arrière : remplacement des lampes (X44 - Renault)
ENG_NU_952-4_X44_Renault_5
Jaune NoirNoir texte
reAr LIgHtS: changing bulbs (2/4)
reversing lights 6
Lift the boot lid. Unclip covers
7 and remove them. Turn bulb holder 8 fully anticlockwise
and change the bulb 9.
To reassemble, proceed in the reverse
order to removal.
When the bulb has been changed,
make sure you refit the cover 7 cor -
rectly.
6 reversing lights
Bulb type: W16W.
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
6
7
9
8

brake lightschanging bulbs ................................................. (current page)
JauneNoirNoir texte
5.19
ENG_UD29236_5
Feux arrière : remplacement des lampes (X44 - Renault)
ENG_NU_952-4_X44_Renault_5
reAr LIgHtS: changing bulbs (3/4)
High-level brake light
– Remove the blanking covers 10
inside the tailgate.
– Press the tabs (using a flat-blade
screwdriver or similar) as shown.
– Remove the brake light from its
housing, remove connector 11 and
replace bulb 12. To return it, proceed in the reverse
order to removal.
Check the tabs are correctly locked in
position.
Bulb type: W16W.
10
11
12
The bulbs are under pres
-
sure and can break when
replaced.
Risk of injury.