2012 RENAULT TWINGO instrument panel

display .................................................. (up to the end of the DU)
indicators .............................................. (up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
warning buzzer ...................................................... (current page)
fuel level ................................................................ (current page)
1.48
ENG_UD24752_3
Tableau de bord : afficheurs et indicateurs (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
INsTRUMENT p ANEL: displays and indicators
Rev counter 1 (graduations x100)
(depending on vehicle)
speedometer 2
To change from miles to km/h, refer to
the information on the “Trip computer
and warning system” in Section 1.
Overspeed buzzer
Depending on the vehicle, a buzzer
sounds for approximately 10 seconds
every 30 seconds, as long as the ve -
hicle is travelling in excess of 72 mph
(120 km/h). sequential gearbox display
3
This indicates the gear engaged (de -
pending on the vehicle). Refer to the in-
formation on the “Quickshift gearbox” in
Section 2.
Fuel gauge 4
Low fuel level warning light
If it flashes and a beep sounds, this in-
dicates that the minimum fuel level has
been reached. Fill up with fuel as soon
as soon as possible.
Each time the ignition is switched on
when the minimum fuel level has been
reached, a beep sounds to warn you.Information display 5
Depending on the vehicle, it includes:
– the time;
– the exterior temperature;
– radio information.
123
4
5

trip computer and warning system........(up to the end of the DU)
instrument panel ................................... (up to the end of the DU)
display .................................................. (up to the end of the DU)
1.49
ENG_UD24927_5
Ordinateur de bord (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Trip computer
TRIp COMpUTER (1/5)
Display 1
General reset and trip
mileage recorder reset key 2
Press and hold button 2 to reset the trip
mileage recorder. The display must be
set to “Trip mileage recorder”.
Display selection key 1
Press button 2 multiple times to scroll
through the following information (de -
pending on the vehicle):
– total mileage recorder;
– trip mileage recorder;
– fuel consumed;
– average fuel consumption;
– current fuel consumption;
– estimated range;
– distance travelled;
– average speed;
– programmed speed (speed limiter/
cruise control);
– clock;
– temperature;
– mileage before service.
Refer to the tables on the following
pages for display examples.
Note: resetting is automatic when
the maximum capacity of any of the
memories is exceeded.
Instrument panel in miles
It is possible to switch to km/h.
Press button 2 and switch on the igni -
tion.
The speed measurement unit indica -
tor flashes for approximately three sec-
onds, then the new unit flashes on the
display and is then lit up continuously:
release button 2.
To return to miles, proceed in the same
manner.
Note: once the battery is disconnected,
the trip computer and warning system
automatically returns to the original unit
of measurement.1
2

mileage before service .......................................... (current page)
JauneNoirNoir texte
1.53
ENG_UD24927_5
Ordinateur de bord (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
TRIp COMpUTER (5/5)
Examples of display selections
by repeatedly pressing button 2Interpreting the display selected
Mileage before service
Distance remaining until the next oil change.
There are several scenarios:
– distance less than 900 miles (1,500 km). It appears on the display for approxi -
mately 8 seconds when the ignition is switched on as soon as the distance is
less than or equal to 900 miles (1,500 km).
– distance less than 0 miles/km. The
© indicator light will light up on the
instrument panel.
The vehicle requires an oil change as soon as possible.
NB: depending on the vehicle, the mileage before an oil change varies according to the driving style (frequent driving at low
speed, door-to-door journeys, extensive use at idle speed, towing a trailer etc.). The distance remaining until the next oil change
can therefore decrease more quickly in some cases than the actual distan\
ce travelled.
The oil change intervals are independent of the vehicle’s maintenance schedule: please refer to your vehicle’s Maintenance
Document.
Resetting: to reset the mileage before an oil change, press and hold one of the display reset buttons for approximately 10 sec-
onds until the display shows the mileage permanently.
The display of information shown below DEpENDs ON ThE VEhICLE EQUIpMENT AND COUNTRY.

lighting:exterior ............................................ (up to the end of the DU)
signals and lights .................................. (up to the end of the DU)
lights: side lights ......................................................... (current page)
1.58
ENG_UD26567_5
Éclairages et signalisations extérieures (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
Jaune NoirNoir texte
Exterior lighting and signals
EXTERIOR LIGhTING AND sIGNALs (1/3)
uswitching on the side
lights
Turn the end of stalk 1 until the symbol
is opposite mark 2.
The instrument panel lights up, the
brightness can be adjusted by rotating
control 3.
Adjusting the brightness of
the instrument panel lighting
Turn control 3 downwards to reduce the
brightness and upwards to increase it.Before driving at night,
check that the electrical
equipment is operating cor-
rectly and adjust the head -
light beams (if your vehicle is not
carrying its normal load). As a gen-
eral precaution, check that the lights
are not obscured (by dirt, mud, snow
or objects which could cover them).
12
1
3

lights:main beam headlights ...................................... (current page)
lights-on warning buzzer ........................................ (current page)
lights: dipped beam headlights ................................... (current page)
JauneNoirNoir texte
1.59
ENG_UD26567_5
Éclairages et signalisations extérieures (X44 - Renault)
ENG_NU_952-4_X44_Renault_1
kDipped beam
headlights
Manual operation
Turn the end of stalk 1 until the symbol
is opposite mark 2.
An indicator light on the instrument
panel comes on
EXTERIOR LIGhTING AND sIGNALs (2/3)
áMain beam headlights
When the dipped beam head-
lights are lit, pull stalk 1 towards you
(an indicator light on the instrument
panel lights up).
To return to the dipped beam headlight
position, pull the stalk towards you.
eswitching off the lights
Return the stalk to its original
position.
Lights-on warning buzzer
A warning buzzer will sound when the
driver’s door is opened and the lights
are left on after the ignition has been
switched off (to prevent the battery run-
ning down, etc.).
Before driving at night,
check that the electrical
equipment is in good con -
dition and adjust the head -
light beams (if your vehicle is not
carrying its normal load). Check that
the lights are not obscured (by dirt,
mud, snow or objects which could
cover them).
12
If driving on the left in a left-hand
drive vehicle (or vice versa), drivers
must have the lights adjusted by an
authorised dealer for the duration of
the trip.

special features of diesel versions........(up to the end of the DU)
driving ................................................... (up to the end of the DU)
2.5
ENG_UD18926_2
Particularités versions diesel (X44 - Renault)
ENG_NU_952-4_X44_Renault_2
Special features of diesel versions
SPecIAl FeAtUReS oF DIeSel veRSIoNS
Diesel engine speed
Diesel engines are fitted with injection
equipment which prevents the engine
speed being exceeded irrespective of
the gear selected.
If the message “ Check antipollution
system” is displayed on the instrument
panel accompanied by the
Ä and
© warning lights; consult an ap -
proved dealer straight away.
v ehicle with particle filter
When driving, depending on the fuel
grade used, it is possible that white
smoke may be emitted.
This is due to the exhaust particle filter
being cleaned automatically, and does
not affect the way the vehicle runs.
Running out of fuel
If the tank has been completely
drained, the system must be reprimed
after the tank is refilled: see information
on the “fuel tank” in Section 1 before re-
starting the engine.
Precautions to be taken in
winter
To avoid faults in icy weather:
– Ensure that the battery is always
fully charged;
– always keep the diesel tank rela -
tively full to avoid water vapour con-
densing in it and accumulating at the
bottom of the tank.
Do not park the vehicle or
run the engine in locations
where combustible sub -
stances or materials such
as grass or leaves can come into
contact with the hot exhaust system.

handbrake............................................. (up to the end of the DU)
2.7
ENG_UD24714_4
Frein à main (X44 - Renault)
ENG_NU_952-4_X44_Renault_2
Handbrake
hANDBRAKe
t o release:
Pull the lever up slightly, press button 1
and then lower the lever to the floor.
The red warning light on the instrument
panel will come on if you are driving
with an incorrectly released handbrake.
to apply:
Pull upwards, check that the vehicle is
properly immobilised.
1
Depending on the slope
and/or vehicle load, it may
be necessary to apply the
brake by an additional two
notches and to engage a gear (1st
or reverse) for manual vehicles.
Make sure that the hand -
brake is properly released
when driving (red indicator
light off), otherwise over -
heating, or even damage, may
occur.

ABS ...................................................... (up to the end of the DU)
anti-lock braking system: ABS ..............(up to the end of the DU)
ESP: Electronic Stability Program ........ (up to the end of the DU)
ASR (traction control) ........................... (up to the end of the DU)
traction control: ASR .............................(up to the end of the DU)
Electronic Stability Program: ESP ........ (up to the end of the DU)
emergency brake assist ........................(up to the end of the DU)
emergency braking ............................... (up to the end of the DU)
traction control: ASR .............................................. (current page)
driving ................................................... (up to the end of the DU)
2.12
ENG_UD25058_2
Dispositifs de correction de conduite (X44 - Renault)
ENG_NU_952-4_X44_Renault_2
Jaune NoirNoir texte
Driving correction devices
DRIvING coRRectIoN DevIce
Depending on the vehicle, this is com-
posed of:
– ABS (anti-lock braking system);
– electronic stability program (eSP)
with understeer control and trac -
tion control (ASR);
– emergency brake assist.
In an emergency, apply firm and
continuous pressure to the brake
pedal. There is no need to pump
it repeatedly. The ABS will modu -
late the force applied in the braking
system.
These functions are an ad-
ditional aid in the event of
critical driving conditions,
enabling the vehicle behav -
iour to be adapted to suit the driving
conditions.
However, the functions do not take
the place of the driver. they do
not increase the vehicle’s limits
and should not encourage you
to drive more quickly. Therefore,
they can under no circumstances
replace the vigilance or responsibil -
ity of the driver when manoeuvring
the vehicle (the driver must always
be ready for sudden incidents which
may occur when driving).
Yo u r b r a k i n g s y s t e m s
are partially operational.
However, it is dangerous
to brake suddenly and
it is essential to stop immediately,
as soon as traffic conditions allow.
Contact an approved dealer.
operating faults:
– If indicator lights
x and © light up on the instrument panel,
braking is still operational but
without ABS;
– If indicator lights
x, û,
© and D are displayed on
the instrument panel when driving,
this indicates there is a fault with
the braking system and ABS.
In both cases, consult an approved
Dealer.
ABS (Anti-lock Braking
System)
Under heavy braking, the ABS prevents
the wheels from locking, allowing the
stopping distance to be managed and
keeping control of the vehicle.
Under these circumstances, the vehi -
cle can be steered to avoid an obstacle
whilst braking. In addition, this system
can increase stopping distances, par -
ticularly on roads with low surface grip
(wet ground, etc.).
You will feel a pulsation through the
brake pedal each time the system is
activated. The ABS does not in any way
improve the vehicle’s physical perform-
ance relating to the road surface and
roadholding. It is still essential to follow
the rules of good driving practice (such
as driving at a safe distance from the
vehicle in front).