2012 RENAULT MEGANE RS tow

tool kit ................................................... (up to the end of the DU)
hubcap tool ........................................... (up to the end of the DU)
jack ....................................................... (up to the end of the DU)
puncture ................................................ (up to the end of the DU)
wheelbrace ........................................... (up to the end of the DU)
trims ...................................................... (up to the end of the DU)
emergency spare wheel ....................... (up to the end of the DU)
wheelbrace ............................................................ (current page)
5.6
ENG_UD18915_3
Bloc-outils (X95 - B95 - D95 - Renault)
ENG_NU_837-6_BDK95_Renault_5
Tool kit (jack, wheelbrace, etc.)
Hubcap
t OOl KIt/wheel trIm – wheel
The tool kit is located in the luggage
compartment: lift the carpet.
The tools included in the tool kit depend
on the vehicle.
wheelbrace 1
Jack 2
When replacing the jack, fold it cor -
rectly and position the wheelbrace cor-
rectly before replacing it in its position.
hubcap tool 3
This tool is used to remove the wheel
trims.
wheel bolt guide 4
To finish loosening or starting to tighten
the wheel bolts.
t owing hitch 5
Refer to the information on “Towing” in
Section 5.
Do not leave the tools unsecured inside the vehicle as they may come
loose under braking. After use, check that all the tools are correctly
clipped into the tool kit, then position it correctly in its housing: there is a
risk of injury.
If wheel bolts are supplied in the tool kit, only use these bolts for the emergency
spare wheel: refer to the label affixed to the emergency spare wheel.
The jack is designed for wheel changing purposes only. Under no circumstances
should it be used for carrying out repairs underneath the vehicle or to gain access
to the underside of the vehicle.
2
1
3
5
wheel trim
Remove it using the hubcap tool 3 by
connecting the hook in the recess pro-
vided next to the valve 6 (to attach the
metal clip).
To refit wheel trim, align it with valve 6.
Push the retaining hooks in fully, start-
ing with side B near the valve, followed
by C and D, finishing at E opposite the
valve.
n ote: if you are using anti-theft bolts,
refer to the information on “Changing a
wheel”.
6
B
cD
e
4

5.16
ENG_UD18877_3
Feux arrière et latéraux : remplacement des lampes (X95 - B95 - D\
95 - Renault)
ENG_NU_837-6_BDK95_Renault_5
Jaune NoirNoir texte
rear lIghts anD InDIcatOr lIghts: changing bulbs (2/6)
Five-door versions
(continued)
Fog lights/side lights and reversing
lights
– From the luggage compartment,
unclip flap 7 , then remove the
bolts 8.
– Lower the tailgate, then pull light 9
towards the rear to release it.
– Unscrew the bulb holder for the bulb
concerned.
7
9
10
8
11
reversing light 10
Bulb type: w16w .
Fog light/side light 11
Bulb type: P21/4w .

JauneNoirNoir texte
5.17
ENG_UD18877_3
Feux arrière et latéraux : remplacement des lampes (X95 - B95 - D\
95 - Renault)
ENG_NU_837-6_BDK95_Renault_5
three-door versions
– Unclip the access flap;
– unscrew nuts 12 and 13;
– from the outside, remove bolt 14 ,
then pull on the light;
– remove the bulb holder by releasing
the clips 15; 16
side light/stop light
Bulb type: P21/5w .
17 Direction indicator light
Bulb type: Py21w .
18 reversing light
Bulb type: P21w .
rear fog light
Undo bulb holder 19, turning it towards
the centre of the vehicle by accessing it
from underneath.
Bulb type: P21w .
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
rear lIghts anD InDIcatOr lIghts: changing bulbs (3/6)
18
16
1712
1314
15
19

5.18
ENG_UD18877_3
Feux arrière et latéraux : remplacement des lampes (X95 - B95 - D\
95 - Renault)
ENG_NU_837-6_BDK95_Renault_5
Jaune NoirNoir texte
rear lIghts anD InDIcatOr lIghts: changing bulbs (4/6)
sport tourer Versions
side lights/reversing lights and fog
lights
– From the luggage compartment,
unclip flap 20 (movement C ), then
remove the bolts .
– Lower the tailgate, then pull light 21
towards the rear to release it.
– Turn the bulb holder of the bulb con-
cerned a quarter of a turn.
20
side light 22
Bulb type: w5w .
reversing light 23
Bulb type: P21w .
Fog light 24
Bulb type: h21w .
refitting
To refit, proceed in the reverse order,
taking care not to damage the wiring.
c
21
23
24
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.
22

side indicator lightschanging bulbs ................................................. (current page)
lights: number plate lights .......................................... (current page)
5.20
ENG_UD18877_3
Feux arrière et latéraux : remplacement des lampes (X95 - B95 - D\
95 - Renault)
ENG_NU_837-6_BDK95_Renault_5
Rear lights (changing bulbs)
rear lIghts anD InDIcatOr lIghts: changing bulbs (6/6)
Indicator lights 33
– Unclip indicator light 33 (using a
flat-blade screwdriver type tool po -
sitioned at D to move the indicator
light towards the front of the vehicle);
– turn the bulb holder a quarter of a
turn and take out the bulb.
Bulb type: w5w .
number plate lights 32
– Unclip light 32 by pressing tab 31;
– remove the light cover to gain access
to the bulb.
Bulb type: w5w .
high level brake light 30
Consult an approved Dealer.
30
22
2333
D
32
31
The bulbs are under pres -
sure and can break when
replaced.
Risk of injury.

towingbreakdown ...................................... (up to the end of the DU)
towing hitch ........................................... (up to the end of the DU)
5.31
ENG_UD14787_2
Remorquage : dépannage (X95 - B95 - D95 - Renault)
ENG_NU_837-6_BDK95_Renault_5
Towing
tOwIng : breakdown (1/2)
Before towing, unlock the steering
column: with the clutch depressed,
engage first gear (lever in position n
or r for vehicles with automatic trans -
missions), insert the RENAULT card in
the card reader then press the engine
start button for two seconds.
Reposition the lever to neutral (posi -
tion N for vehicles fitted with an auto -
matic gearbox)
The steering column unlocks, the ve -
hicle’s accessory functions are pow -
ered, and you can use the vehicle lights
(brake lights, hazard warning lights,
etc.). At night, the vehicle must be lit.
Once you have finished towing, press
the engine start button twice (risk of
running down the battery). The speed specified by current legis
-
lation for towing must always be ob -
served. If your vehicle is the towing
vehicle, do not exceed the maximum
towing weight for your vehicle (refer to
the information on “Weights” in Section
6).
t owing a vehicle with an
automatic gearbox
With the engine switched off, the trans-
mission is no longer lubricated. It is
preferable to tow this type of vehicle on
a trailer or tow it with the front wheels
off the ground.
u nder exceptional circumstances,
you may tow the vehicle with all four
wheels on the ground, only going for -
ward, with the gear lever in the n posi-
tion, and for a distance not exceeding
50 miles (80 km).
If the lever is stuck in P,
even though you are de -
pressing the brake pedal,
the lever can be released
manually. To do this, insert a rigid
rod in the hole 2, press the rod and
unlocking button 1 located on the
lever simultaneously.
1
2
D o n o t r e m o v e t h e
RENAULT card from the
reader when the vehicle is
being towed.

5.32
ENG_UD14787_2
Remorquage : dépannage (X95 - B95 - D95 - Renault)
ENG_NU_837-6_BDK95_Renault_5
tOwIng : breakdown (2/2)
Only use:
– at the rear, towing point 5;
– a t the front, towing hitch 4 (lo -
cated in the tool kit).
These towing points may only be used
for pulling the vehicle, never for lifting it
either directly or indirectly.
access to towing points
Unclip cover 3 or 6 by sliding a flat tool
(or the key integrated in the RENAULT
card) under the cover.
s crew in towing hitch 7 fully: as
much as possible by hand at first, then
finish by tightening it using the wheel -
brace.
Use only towing hitch 7 and the wheel -
brace located under the luggage com -
partment carpet in the tool kit (refer
to the information on the “Tool kit” in
Section 5).
W h e n t h e e n g i n e i s
stopped, steering and brak-
ing assistance are not op -
erational.Do not leave the tools unse-
cured inside the vehicle as
they may come loose under
braking.
4
5
36
7
7
– Use a rigid towing bar.
If a rope or cable is used
(where the law allows this),
the vehicle being towed
must be able to brake.
– A vehicle must not be towed if it is
not fit to be driven.
– Avoid accelerating or braking
suddenly when towing, as this
may result in damage being
caused to the vehicle.
– When towing a vehicle, it is ad -
visable not to exceed 30 mph
(50 km/h).

6.1
ENG_UD19032_7
Sommaire 6 (X95 - B95 - D95 - Renault)
ENG_NU_837-6_BDK95_Renault_6
Section 6: Technical specifications
Vehicle identification plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.2
Engine identification plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.3
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5
Engine specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.8
Weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.9
Towing weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.9
Replacement parts and repairs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.10
Service sheets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.11
Anticorrosion check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.17