JauneNoirNoir texte
1.37
ENG_UD23633_2
Sécurité enfants: installation du siège enfant (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_1
cHILd sAfETY : fitting a child seat (3/3)
Type of child seat Weight of
the child seat size
IsOfIX front passenger
seat (1) (5) Rear side seats Rear centre
seat
carrycot fitted across the ve-
hicle
Group 0 < 10 kg
F, GXU - IL (2) X
shell seat/rear-facing seat
Group 0, 0+ and 1 < 13
kg and 9 to
18 kg C, D, E
UU - IL (3) X
forward-facing seat
Group 1 9 to 18 kg
A, B, B1XU - IUF - IL (4) X
Booster seat
Group 2 and 3 15 to 25
kg and
22 to 36 kg X
U (4) X
X = Seat not suitable for fitting child seats.
U = Seat which allows a child seat with “Universal” approval to be installed using a seat belt; check that it can be fitted.
IUf/IL = On equipped vehicles, seat which allows an approved “Universal”/“semi-universal” or “vehicle specific” child seat to be
attached using the ISOFIX system; check that it can be fitted.
(1) Only a rear-facing child seat can be fitted in this seat: raise the seat to the maximum and position it as far back as possible,
tilting the seatback slightly (approximately 25°).
(2) A carrycot can be installed across the vehicle and will take up two seats. Position the child with his or her feet nearest the door.
(3) Move the front seat as far forward as possible to install a rear-facing child seat, then move back the seat in front as far as it will
go, although without allowing it to come into contact with the child seat.
(4) Forward-facing child seat; position the seatback of the child seat in contact with the seatback of the vehicle seat. Adjust the
height of the headrest or remove it if necessary; do not push the seat in front of the child more than halfway back on its runners
and do not recline the seatback more than 25°.
(5) RIsK Of dEATH OR sERIOUs INJURY: before installing a rear-facing child seat in the front passenger seat,
make sure the air bag has been deactivated (refer to the “Child safety: front passenger air bag deactivation/activation”
paragraph in Section 1).
The table below summarises the information already shown on the diagram on the previous page, to ensure the regula-
tions in force are respected.
filterparticle filter ..................................................... (current page)
heated seats .......................................................... (current page)
ABS ....................................................................... (current page)
JauneNoirNoir texte
1.49
ENG_UD27624_4
Témoins lumineux (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_1
The presence and operation of the warning lights dEpENd ON THE EQUIpmENT ANd cOUNTRY.
W ARNINg LIgHTs (4/4)
driving correction device
warning light
Refer to the information on “Driving cor-
rection devices” in Section 2.
ÄToxic fume filter system
Warning Light
This lights up when the ignition is
switched on and goes out when the
engine is started.
– If it lights up continuously, consult
your approved Dealer as soon as
possible;
– if it flashes, reduce the engine speed
until the light stops flashing. Contact
your approved Dealer as soon as
possible.
R e f e r t o t h e i n f o r m a t i o n o n
“Antipollution, fuel economy and driv -
ing” in Section 2.
ðHeated seats operating indi -
cator
This indicates that one of the heated
seats is in operation.
ÜNot used
A
Ép reheating warning light
(diesel version)
This should come on when the igni -
tion is switched on. It indicates that the
heater plugs are in operation. This goes
out as soon as the engine starts.
xAnti-lock braking warning
light
This lights up when the ignition is
switched on and goes out after a few
seconds.
If it does not go out after the ignition is
switched on, or lights up when driving,
there is a fault with the ABS. Braking
will then be as normal, without the ABS
system.
Contact an approved Dealer as soon as
possible.
electric windows ................................... (up to the end of the DU)
child safety ............................................................. (current page)
children (safety) ..................................................... (current page)
sunroof .................................................. (up to the end of the DU)
3.11
ENG_UD23646_7
Lève-vitres électriques (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_3
Electric windows, electric sunroof
ElEcTRIc WINDoWS, ElEcTRIc SuNRooF (1/3)
These systems operate with the igni -
tion on or off, until the driver’s door is
opened (limited to about 5 minutes).
1
2
34
5
6
Electric windowsPress or pull the switch to raise or lower
a window to the desired height (the rear
windows do not open fully); Operate the
switches as follows:
1 for the driver’s window;
2 for the front passenger window;
3 and 5 for the rear windows.
From the passenger seats, use
switch 6. one-touch mode
Depending on the vehicle, this mode is
additional to the operation of the elec
-
tric windows. It may be fitted to the driv-
er’s window only, or to all the windows.
Briefly press or pull (fully) the window
switch: the window is fully lowered or
raised. Pressing the switch again stops
the window moving.
Note: if the window detects resistance
when closing (e.g. fingers, branch of
a tree, etc.) it stops and then lowers
again by a few centimetres.
Avoid resting any objects against a
half-open window: there is a risk that
the electric window winder could be
damaged.
Safety of rear occupants
Depending on the vehicle,
the driver can disable op -
eration of the electric win -
dows and the rear doors by press -
ing switch 4 . The indicator light
integrated in the switch lights up to
confirm that the locks have been ac-
tivated.
Driver’s responsibility
Never leave your vehicle with the
RENAULT card inside and never
leave a child (or a pet) unsuper -
vised, even for a short while. The
reason for this is that the child may
endanger himself or others by start-
ing the engine, activating equipment
such as the electric window, or lock-
ing the doors. If any part of the body
becomes trapped, reverse the di -
rection of the window immediately
by pressing the relevant switch.
Risk of serious injury.
rear bench seat..................................... (up to the end of the DU)
rear seats functions .......................................................... (current page)
3.23
ENG_UD13354_2
Banquette arrière (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_3
The seatbacks can be folded down in
order to transport large objects.
In all situations, lower the rear head -
rests (refer to the information on the
“Rear headrests” in Section 3).
Saloon version
Press button 1 and lower seatback A.
Rear bench seat
REAR BENch SEAT
Sport tourer versions
Press button 2 or pull handle 3 : the
seatback will fold down by itself.
Note: when you are folding a seatback
back up, check that it is correctly locked
(button 2 is flush).
When refitting the seat -
back , make sure it is cor -
rectly locked in place.
If seat covers are fitted ,
make sure these do not prevent the
seatback latch from locking in.
Make sure that the seat belts are
positioned correctly.
Reposition the headrests.
When moving the rear seats, ensure
that nothing obstructs the anchor -
age points (passenger’s arm or leg,
a pet, gravel, cloth, toys, etc.).
1
A
2
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
3
Check that no-one, includ -
ing animals, is in the vicin -
ity of the rear bench seat
before pulling handle 3.
Risk of injury.
transporting objectsin the luggage compartment ........... (up to the end of the DU)
towing rings .......................................... (up to the end of the DU)
towing towing equipment ............................ (up to the end of the DU)
towing equipment fitting ............................................... (up to the end of the DU)
towing a caravan .................................. (up to the end of the DU)
3.30
ENG_UD29077_2
Transport d’objets : dans le coffre / attelage (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_3
Jaune NoirNoir texte
Transporting objects:
in the boot
Always position the heavi -
est items directly on the
floor. Use the lashing points
on the floor of the luggage
compartment, if these are fitted to
the vehicle. The luggage should be
loaded in such a way that no items
will be thrown forward and strike the
occupants if the driver has to brake
suddenly. Fasten the rear seat belts,
even if the seats are not occupied.
Always place the objects to be trans -
ported so that their largest side rests
against the back of the rear bench seat
for normal loads (e.g.: A), or against the
back of the front seats when the rear
bench seatbacks are folded down.
If you have to place objects on the
folded seat back, it is vital that you
remove the headrests before folding
the seat back so that it can be folded as
flat as possible against the seat.
A
TRANSPoRTINg oBjEcTS IN ThE BooT (1/2)
transporting objectsluggage net ..................................... (up to the end of the DU)
luggage retaining net ............................ (up to the end of the DU)
3.32
ENG_UD20953_5
Filet de séparation (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_3
Jaune NoirNoir texte
Depending on the vehicle, this may be
used when transporting animals or lug-
gage to isolate them from the passen-
ger section.
It can be positioned:
– behind the rear seats A, rear bench
seat in raised position or rear bench
seat folded;
– behind the front seats B.
Luggage net
Refitting the luggage net
With the rear bench seatbacks 1 com -
pletely folded down, find the roller.
From the right-hand rear door, slide
roller 2 on the rails 3 located on the
back of the large section of the rear
bench seatback: ensure it is correctly
locked by moving it back and forth
gently, then lock the rear bench seat -
backs back into place.
luggAgE NET (1/3)
3
21
The luggage net is de -
signed to retain a maximum
weight of 10 kg.
Risk of injury.
A
B
Removing/refitting the
luggage net
Removing the luggage net
With the rear bench seatbacks 1 com -
pletely folded down, from the right-hand
rear door side, pull roller 2 towards you
until it unclips. Then, lift it so it can be
recovered.
towing rings ........................................................... (current page)
JauneNoirNoir texte
3.33
ENG_UD20953_5
Filet de séparation (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_3
luggAgE NET (2/3)
Remove rod 5 from its housing
and insert it into the anchorage points 6
(it must be inserted in ring 7).
Fold up the seatbacks and lock them.
Check that they are correctly locked by
moving them back and forth gently.
To remove the net, proceed in the re -
verse order.
5
6
7
5
Positioning the luggage net
Behind the rear seats
From the rear seats, lift covers 4 to
access the anchorage points used as
upper attachments for the net.
To help the net unwind, fold down the
small section of the seatback whilst
holding the large section of the seat -
back in the slightly folded down posi -
tion.
4
During installation, do not
place your fingers under the
roller.
Risk of injury.
57
5
6
3.34
ENG_UD20953_5
Filet de séparation (X91 - B91 - K91 - Renault)
ENG_NU_936-5_BK91_Renault_3
NB: when the luggage net roller is in -
stalled on the back of the large section
of the seatback, a system ensures the
seatback does not fold down uninten -
tionally. It is therefore necessary, after
unlocking the seatback, to tilt it by pull -
ing from the top beyond the point of re-
sistance, from the right-hand rear door
side.
5
When driving, it is forbid -
den to sit in the small sec -
tion of the rear bench seat
if the large section is folded
down, with the net in position.
9
Behind the front seats
With the rear bench seatbacks folded
down, lift cover 8 on each side to
access the anchorage points used as
upper attachments for the net.
Remove rod 5 from its housing and
insert it into the anchorage points 9 (it
must be inserted in ring 7).
To remove the net, proceed in the re -
verse order.
8
7
5
luggAgE NET (3/3)
During installation, do not
place your fingers under the
roller.
Risk of injury.