2012 RENAULT KANGOO ZERO EMISSION lights

brake lightschanging bulbs ................................................. (current page)
JauneNoirNoir texte
5.19
ENG_UD25344_3
Feux arrière : remplacement des lampes (X61 - F61 - K61 - Renault)
ENG_NU_911-4_F61e_Renault_5
rear lIghts: changing bulbs (2/3)
high-level brake light
– Version with tailgate: it is located
above the rear screen, in the centre.
– Version with hinged doors: it is lo-
cated above the rear screen, on the
left-hand door. Remove the two plastic blanking
covers
7 from the inside. Unclip the
light using a screwdriver, by pressing in
the metal clip housings.
Remove light 8 from the outside.
Replace the bulb without disconnecting
the wiring.
Bulb type: w16w
For refitting, proceed in the reverse
order to removal.
Check the tabs are correctly locked in
position.
78

lights:number plate lights .......................................... (current page)
5.20
ENG_UD25344_3
Feux arrière : remplacement des lampes (X61 - F61 - K61 - Renault)
ENG_NU_911-4_F61e_Renault_5
rear lIghts: changing bulbs (3/3)
Release the light 10 to access bulbs.
Bulb type: w5w .
Replace the bulbs, then fit the light in
position.number plate light
Undo two bolts 9 using a Torx tool.
9
10

bulbschanging ......................................... (up to the end of the DU)
changing a bulb .................................... (up to the end of the DU)
indicators .............................................. (up to the end of the DU)
indicators: direction indicators .......................... (up to the end of the DU)
bulbs changing ......................................... (up to the end of the DU)
side indicator lights changing bulbs ................................ (up to the end of the DU)
5.21
ENG_UD19133_1
Répétiteurs latéraux : remplacement des lampes (X61 - F61 - Renault)
ENG_NU_911-4_F61e_Renault_5
Indicator lights: changing bulbs
Turn the bulb holder 2 a quarter of a
turn and take out the bulb.
Bulb type: wy5w .
Replace the bulb and refit the indicator
light.
Unclip indicator light
1 on the door side,
using a flat-blade screwdriver type tool.
InDIcat Or lIghts: changing bulbs
1
2

bulbschanging ......................................... (up to the end of the DU)
changing a bulb .................................... (up to the end of the DU)
interior lighting: changing bulbs ................................ (up to the end of the DU)
bulbs changing ......................................... (up to the end of the DU)
5.22
ENG_UD25345_2
Eclairage intérieur : remplacement des lampes (X61 - F61 - Renault)
ENG_NU_911-4_F61e_Renault_5
Jaune NoirNoir texte
Interior lighting: changing bulbs
Passenger compartment
lights
Remove the lens 1 using a tool such as
a flat-blade screwdriver.
InterIOr lIghts: changing bulbs (1/2)
1
Pull the bulb 2 to remove it from its
housing.
Bulb type 2: w6w
rear courtesy light bulb type: w6w
Replace the bulbs and replace the lens.
2

JauneNoirNoir texte
5.23
ENG_UD25345_2
Eclairage intérieur : remplacement des lampes (X61 - F61 - Renault)
ENG_NU_911-4_F61e_Renault_5
InterIOr lIghts: changing bulbs (2/2)
light A
Remove the lens using a tool such as a
flat-blade screwdriver.
Pull the bulb to remove it from its hous-
ing.
Bulb type a: w5w
Replace the bulb and refit the lens.
light B or C
Remove the lens using a tool such as a
flat-blade screwdriver.
Pull the bulb to remove it from its hous-
ing.
Bulb type B or C : w6w
Replace the bulb and refit the lens.
a
B
c

batterytroubleshooting ............................... (up to the end of the DU)
12 volt battery ....................................... (up to the end of the DU)
12 volt battery breakdown recovery ....................... (up to the end of the DU)
5.24
ENG_UD26209_3
Batterie : dépannage (X61 - F61 - Renault)
ENG_NU_911-4_F61e_Renault_5
Jaune NoirNoir texte
12 volt battery: breakdown
12 VOlt Battery: breakdown recovery (1/2)
to avoid all risk of sparks:
– Switch off the vehicle ignition.
– Ensure that any electrical consumers
(courtesy lights, etc.) are switched
off before disconnecting or recon -
necting the battery.
– When charging, stop the charger
before connecting or disconnecting
the battery.
– Do not place metal objects on the
battery to avoid creating a short cir-
cuit between the terminals.
– Make sure that you reconnect the
battery terminals after refitting.
connecting a battery charger
the battery charger must be com -
patible with a battery with nominal
voltage of 12 volts.
Before disconnecting the battery, check
that:
– the ignition is switched off;
– the gear control is in position P
(please see the information on “Gear
control”;
– the charging cable is disconnected.
Special procedures may be
required to charge some
batteries. Contact your ap -
proved dealer.
Avoid all risk of sparks which may
cause an immediate explosion, and
charge the battery in a well-venti -
lated area. Risk of serious injury.
Handle the battery with care
as it contains sulphuric acid,
which must not come into
contact with eyes or skin. If
it does, wash the affected area with
plenty of cold water. If necessary,
consult a doctor.
Ensure that naked flames, red hot
objects and sparks do not come into
contact with the battery as there is a
risk of explosion.
The engine may be hot when car -
rying out operations in close prox -
imity. In addition, the engine cooling
fan can come on at any moment.
Risk of injury.
Disconnect the leads connected to both
battery terminals, starting with the
negative terminal.
Follow the instructions given by the
manufacturer of the battery charger
you are using.
Do not work on the 12 volt
battery (charging, replac -
ing, etc.):
– without switching off the
ignition;
– if your traction battery is charg -
ing.
Please refer to the information
on “Electric vehicle: charging” in
Section 1.
Risk of serious injury.

JauneNoirNoir texte
5.27
ENG_UD23043_4
Fusibles (X61 - F61 - K61 - Renault)
ENG_NU_911-4_F61e_Renault_5
Fuses (2/2)
Some functions are protected by fuses
located in the engine compartment.
However, because of their reduced ac-
cessibility, you are advised to have
these fuses replaced by an approved
Dealer.symbol allocation symbolallocation
Z
Interior lighting, electric
door mirrors, rain/light sen-
sors, heating and air con -
ditioning system.
î
Radio, display, heating and
air conditioning system,
heated seat
ÌHornInstrument panel
DRear fog lights, warningëAccessories socket, cigar
lighter
Electric windowsö
Consumer cut-out (radio,
navigation system, display,
alarm)
ñHeated seatsgHeated door mirrors
fRear screen wiperHFront/rear windscreen wash-
ers
xPassenger compartment
heating systemNCentral door locking
aDaPt Location reserved for addi
-
tional equipment.
nABS
ßBrake lights
allocation of fuses (the presence of fuses DePenDs On the eQuIPment leVel
OF the VehIcle)

towing hitch............................................................ (current page)
JauneNoirNoir texte
5.31
ENG_UD28666_1
Remorquage (X61 électrique - Renault)
ENG_NU_911-4_F61e_Renault_5
Bring lever to position n.
tOwIng, BreaKDOwn (2/3)
In the event of an energy
fault: towing
In the event of a fully discharged trac-
tion battery:
– the warning light
Ṏ flashes;
– needle 1 is in the lower section of the
reserve zone.
It is possible to recover on a flatbed
truck or tow the vehicle using the tow
eye, following the instructions below.
W h e n t h e e n g i n e i s
stopped, steering and brak-
ing assistance are not op -
erational.
Before towing, insert the key in the
switch to unlock the steering column.
Turn it to position m.
The column is unlocked, the acces -
sory functions are supplied: the vehi -
cle lights can be used (hazard warn -
ing lights, brake lights etc.). The towed
vehicle’s lights must be switched on at
night.
The speed specified by current legis -
lation for towing must always be ob -
served.
4
1
2
If the lever is stuck in P,
even though you are de -
pressing the brake pedal,
the lever can be released
manually.
To do this, unclip the cover at the
base of the lever.
Press simultaneously on mark 2 and
on the unlocking button on the lever.