2012 RENAULT FLUENCE Z.E. language

1.64
ENG_UD25303_2
Ordinateur de bord : paramètres de voyage (L38 électrique - Renau\
lt)
ENG_NU_914-4_L38e_Renault_1
triP cOmPUter AND WArNiNg SYStem: journey parameters (4/4)
the display of information shown below DePeNDS ON the vehicle eqUiPmeNt AND cOUNtr Y.
examples of selectionsinterpreting the display selected
d) vehicle settings customisation menu.
Enables certain vehicle functions to be set (instrument panel language,
parking distance control, etc.). Refer to the information on “Vehicle set-
tings customisation menu” in Section 1.
SETTINGS MENU
press and hold
Speed limiter
e) cruise control/speed limiter programmed speed. Refer to the information on the “Speed limiter” and “Cruise control” in
Section 2.
90 km/h
Cruise control 90 km/h
No message available
f) t rip log.
Successive display:
– information messages (passenger airbag OFF etc);
– operating fault messages.

menu for customising the vehicle settings
(up to the end of the DU)
customising the vehicle settings ........... (up to the end of the DU)
customised vehicle settings .................. (up to the end of the DU)
1.68
ENG_UD21535_3
Menu de personnalisation des réglages du véhicule (L38 - X38 - Re\
nault)
ENG_NU_914-4_L38e_Renault_1
Vehicle settings customisation menu.
vehicle SettiNgS cUSt OmiSAtiON meNU
Adjusting the settingsPress button 2 or 3 to select a function
to change:
a) Auto door locking while driving ;
b) Auto dipped-beam headlights ;
c) Rear parking sensor ;
d) Parking sensor volume ;
e) LANGUAGE.
= function activated
< function deactivated
On equipped vehicles, this function,
which is integrated in the trip compu
-
ter 1, allows you to activate/deactivate
some of the vehicle’s functions.
Accessing the settings
customisation menu
With the vehicle stopped, press
button 2 or 3 several times until the
message “ Settings menu: press and
hold ” is shown on display 1 . Press
either button 2 or 3 for longer than 2
seconds to enter the menu.
Once a line has been selected, keep
pressing button 2 or 3 to change the
function: If you select either “ Parking
sensor volume ” or “LANGUAGE ”, you
will have to make a further selection
(sound volume of the parking distance
control or instrument panel language).
In this case, make your selection and
confirm it by holding either button 2
or 3, the value selected is shown by a
~ in front of the line.
To exit the menu, select “ EXIT” or
“BACK” then confirm by keeping either
button 2 or 3 pressed. It may be nec -
essary to carry out this operation more
than once.
2
3
1
The vehicle settings personalisation
menu cannot be used when driving.
The display automatically switches
back to trip computer mode.