3.44
ENG_UD20394_1
Appuis-tête convertible enfant (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_3
CHILD’S CONVERTIBLE HEADREST (continued)
For child use
Lift latch 2, disengage strap 3, and then
lower latch 2 again. Lower cushion B
completely.
Place the child on the seat. The two
side supports 4 must be positioned on
either side of the neck. Then adjust the
height of the headrest: the base of side
supports 4 must be approximately two
centimetres above the shoulders.
To improve comfort for the child, adjust
the seat belt in retainer 5 . Label C re -
minds you of the procedure to follow. To refit the headrest
Lift latch
2 again, refit cushion B ,
engage strap 3, and then lower latch 2
to lock the headrest in place. Check
that it is correctly locked in position. Child headrest storage position
Press tab 1 on the headrest guide and
lower the headrest completely.
When the headrest is set at the
lowest position, this is for storage
only.
It should not be in this position
when a seat is occupied.
2
B
3
4
5
C
1
The child headrest can be used only with an approved booster seat for
categories 2 (15 to 25 kg) and 3 (22 to 36 kg). Refer to the information on
“Child safety: fitting a child seat” in Section 1.
In any other case, cushion B must always be kept in the raised and
locked position,
changing a wheel................................................... (current page)
practical advice ...................................................... (current page)
tyres ....................................................................... (current page)
wheels (safety) ...................................................... (current page)
lifting the vehicle changing a wheel ............................ (up to the end of the DU)
5.9
ENG_UD20419_1
Changement de roue (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_5
Changing a wheel
cHAnGInG A WHeeL (1/2)
Switch on the hazard warn-
ing lights.
Keep the vehicle away from
traffic and on a level sur -
face where it will not slip (if neces -
sary, place a solid support under the
jack base).
Apply the parking brake and engage
a gear (first or reverse, or P for auto-
matic transmissions).
Ask all the passengers to leave the
vehicle and keep them away from
traffic.Vehicles equipped with a jack
and wheelbrace
Put together wheelbrace 1 using the
tools stored in the tool kit: refer to the
information on the “Tool kit” on the pre-
vious pages.
Use wheelbrace 1 to loosen the wheel
bolts. Fit it so that you press down -
wards rather than pulling upwards.
1
2
3
1
To prevent any risk of injury
or damage to the vehicle,
only crank the jack until the
wheel you are replacing is
a maximum of 3 centimetres off the
ground.
Position the jack horizontally, with the
jack head positioned at the same height
as support 2 provided in the lower sec-
tion of the bodywork, closest to the
wheel concerned.
Start cranking up jack 3 by hand to
align the base plate (which should be
pushed slightly under the vehicle).
Place a plank of wood under the base
plate if on soft ground.
Turn the wheelbrace to lift the wheel off
the ground.
If the vehicle is not equipped with a
jack or wheelbrace, you can obtain
these from your approved dealer.
