Page 39 of 208

   
 
Instruments and controls  
 
37
READY TO SET OFF
22
 
SERVICE INDICATOR
 
This programmes service intervals 
according to the use of the vehicle.     
More than 1 000 miles/km before the 
next service is due 
   
Example: 
 4 800 miles/km remain 
before the next service is due. When 
the ignition is switched on and for a 
few seconds, the screen shows: 
  A few seconds after the ignition is 
switched on, the oil level is displayed, 
then the total distance recorder 
resumes normal operation showing the 
total and trip distances.  
   
Less than 1 000 miles/km before the 
next service is due 
  Each time the ignition is switched on 
and for a few seconds, the spanner 
fl ashes and the number of miles/
kilometres remaining is displayed:   A few seconds after the ignition is 
switched on, the oil level is displayed, 
then the total distance recorder 
resumes normal operation and the 
spanner remains on. This indicates that 
a service should be carried out shortly.  
   
Service overdue 
  First of the two terms reached: the 
spanner also comes on if the two-year 
interval has elapsed.  
     
Operation 
  A few moments after the ignition 
has been switched on, the spanner 
indicating a service operation comes 
on; the display for the total distance 
recorder gives (in round fi gures) the 
distance remaining before the next 
service. 
  The points at which a service is due 
are calculated from the last indicator 
zero reset. 
  The point at which a service is due is 
determined by two parameters: 
   
 
-   the distance travelled, 
   
-   the time which has elapsed since 
the last service.  
  The distance remaining before the 
next service may be weighted by 
the time factor, depending on the 
type of driving.    With the engine running the 
spanner remains on until the 
service has been carried out.   Each time the ignition is 
switched on and for a few 
seconds, the spanner 
fl ashes and the excess 
distance is displayed.  
     
        
        Page 110 of 208

   
 
Levels  
 
108
 
 
Cooling system 
 
Only use the fl uid recommended by the 
manufacturer. 
  Otherwise, you risk seriously damaging 
your engine. 
  When the engine is warm, the 
temperature of the coolant is controlled 
by the engine fan. As this fan can 
operate with the ignition key removed 
and because the cooling system is 
pressurised, wait for at least one hour 
after the engine has stopped before 
carrying out any work. 
  Slacken the cap by 1/4 of a turn to 
release the pressure to prevent any 
risk of scalding. When the pressure 
has dropped, remove the cap and top 
up the level with coolant. 
  If fl uid has to be added frequently, 
this indicates a fault which must be 
checked by a PEUGEOT dealer as 
soon as possible. 
   
Power steering fluid level 
 
The vehicle must be parked on level 
ground with the engine cold. Unscrew 
the cap integrated with the gauge and 
check the level which must be between 
the MIN and MAX marks.    In order to regenerate the fi lter, you 
are advised to drive at a speed higher 
than 40 mph (60 km/h) for at least fi ve 
minutes as soon as possible, when 
traffi c conditions permit (until the 
message disappears and the service 
warning lamp goes off). 
  During regeneration of the particle 
emission fi lter, the noise of a relay 
operating may be heard under the 
dashboard. 
  If the message is still displayed and 
if the service warning lamp remains 
on, consult a PEUGEOT dealer or a 
qualifi ed workshop. 
   
Topping up 
  The level must be between the MIN 
and MAX marks on the expansion 
bottle. If more than 1 litre of fl uid is 
required to top up the level, have 
the system checked by a PEUGEOT 
dealer or a qualifi ed workshop.  
 
 
 
Screenwash and headlamp 
wash level 
  For best quality cleaning and for your 
safety, we would advise that you use 
products of the PEUGEOT range. 
  For optimum cleaning and to avoid 
freezing, this fl uid must not be topped 
up or replaced with plain water. 
  Capacity of the screenwash reservoir: 
approximately 3 litres. 
  If your vehicle is fi tted with headlamp 
washers, the capacity of the reservoir 
is 6 litres.  
 
 
Diesel additive level 
(Diesel with particle 
emission filter) 
   
Topping up 
  This additive must be topped up by 
a PEUGEOT dealer or a qualifi ed 
workshop without delay.  
 
 
 
Waste products 
 
Avoid prolonged contact of used oil 
with the skin. 
  Brake fl uid is harmful to health and 
very corrosive. 
  Do not dispose of used oil, brake fl uid 
or coolant into drains or into the ground 
but into the containers dedicated to this 
use at PEUGEOT dealer (France) or 
an authorised waste disposal site.     The minimum level of this additive 
is indicated by lighting of the service 
warning lamp, accompanied by an 
audible signal and a message in the 
screen. 
  When this occurs with the engine 
running it is due to the start of 
saturation of the particle emission fi lter 
(exceptionally prolonged urban type 
driving conditions: low speed, long 
traffi c jams, ...).  
     
        
        Page 114 of 208

DIESEL
   
 
Fuel  
 
11 2
FUEL CUT-OFF
 
In a serious collision, a mechanism 
automatically prevents fuel from 
reaching the engine. 
  The fl ashing of this warning 
lamp is accompanied by a 
message in the screen. 
  Check that there is no odour or 
leakage of fuel outside the vehicle and 
re-establish the fuel supply: 
   
 
-   switch off the ignition (STOP 
position), 
   
-   remove the key, 
   
-   put the key back in the ignition, 
   
-   switch on the ignition and start.  
 
DIESEL PRIMING PUMP 
 
If you should run out of fuel, it is 
necessary to prime the fuel circuit: 
   
 
-  fi ll the fuel tank with at least 
fi ve litres of Diesel, 
   
-   squeeze and release the manual 
priming pump, under the bonnet 
under the protective cover, 
   
-   operate the starter until the engine 
starts.  
  Refer to the "Under the bonnet" 
section of chapter 6. 
   
 
 
 
 
 
 
 
 
 
 
 
Quality of the fuel used for 
Diesel engines 
   
The Diesel engines are perfectly 
compatible with biofuels which conform 
to current and future European 
standards (Diesel fuel which complies 
with standard EN 590 mixed with a 
biofuel which complies with standard 
EN 14214) available at the pumps 
(containing up to 7 % Fatty Acid Methyl 
Ester). 
  The B30 biofuel can be used in certain 
Diesel engines; however, this use 
is subject to strict application of the 
special servicing conditions. Contact 
a PEUGEOT dealer or a qualifi ed 
workshop. 
  The use of any other type of (bio)fuel 
(vegetable or animal oils, pure or 
diluted, domestic fuel...) is strictly 
prohibited (risk of damage to the 
engine and fuel system).