2012 Peugeot Partner mirror

refrigerant type differential tire pressure check engine lock coolant level

Page 82 of 208

Peugeot Partner 2012 Owners Manual

Mirrors and windows

80
ELECTRIC WINDOWS

1.
Drivers electric window control

2.
Passenger electric window control
There are two operating modes:

Safety anti-pinch

Mirrors and windows

80
ELECTRIC WINDOWS

1.
Driver's electric window control

2.
Passenger electric window control
There are two operating modes:

Safety anti-pinch

When the window rises and meets an
obstacle, it stops and partially lowers.

One-touch mode

Press or pull the control, beyond the
point of resistance. The window opens
or closes fully when the control is
released. Pressing the control again
stops the movement of the window.
The electrical functions of the electric
windows are deactivated:

- approximately 45 seconds after the
ignition is switched off,

- after one of the front doors is
opened, if the ignition is off.

Manual mode

Press or pull the control, without
passing the point of resistance.
The window stops when you release
the control.

Reinitialisation

Following reconnection of the battery,
or in the event of a malfunction, the
safety anti-pinch function must be
reinitialised.

Good practice

If the electric windows meet an
obstacle during operation, you must
reverse the movement of the window.
To do this, press the control concerned.
When the driver operates the
passenger electric window controls,
they must ensure that no one is
preventing correct closing of the
windows.
The driver must ensure that the
passengers use the electric windows
correctly.
Be aware of children when operating
the windows.
Following several consecutive
closing/opening operations of the
electric window control, a protection
system is triggered which only
authorises closing of the window. After
closing, wait approximately 40 minutes.
Once this time has elapsed, the control
becomes operational again. Lower the window fully, then raise it, it
will rise in steps of a few centimetres
each time the control is pressed.
Repeat the operation until the window
is fully closed.
Continue to press the control for at
least one second after the window
closed position has been reached.
The safety anti-pinch does not operate
during these operations.