Page 90 of 168
Practical information
88
Ancillaries battery
(other than the electric motor, the heating and
the air conditioning) are powered by this 12 V
ancillaries battery.
It is located in the front compartment and isrecharged by the main battery, during phases
of operation ("Ready" lamp on in the instrument
panel) and charging.
If the ancillaries battery is discharged,it will not be possible to star t the motor and the main battery cannot becharged.
)Open the front bonnet using the interior release lever, then the exterior safety catch. )Secure the bonnet stay. )Slacken nut 1. )Remove the battery protective cover for access to the two terminals.
Access to the battery
Disconnecting the battery is not recommended.However, if the vehicle is not to be used for a prolonged period of more than a month, it may be necessary todisconnect and store it to avoid theelectrolyte freezing.
After prolonged disconnection of the battery, you must contact a PEUGEOTdealer or a qualified workshop to havethe electronic control unit reinitialised.
Page 102 of 168
Practical information
100
) Lift the cover B
, using a screwdriver
protected by a cloth. ) Slacken fixing screw C
until the head of the screw touches the trim.
)Remove the bumper retaining clips, using ascrewdriver. )Carefully lift the bumper. To replace a failed bulb,
you must first remove
the lamp. To remove the lamp: )Open the bonnet. )Press tab A to release the connector.
Access to bulbs
Page 113 of 168
8
Practical information
111
Access to the fuses
)Open the bonnet (refer to the "Checks" section), )Unclip the cover and remove it completely
by pulling towards you. )Change the fuse (refer to the corresponding paragraph). )When you have finished, close the cover carefully to ensure sealing of the fusebox.
Fuse N°RatingFunctions
1110 A On-board charger.
12 10 A
Dir
ection indicator.
1
310 A Horn.
1410 A Daytime running lamps.
1515 A
Battery fan.
1610 A
Air conditioning compressor.
1720 A Right hand dipped beam.
1820 A
Left hand dipped beam, headlamp adjusters.
1
910 A
Right hand main beam.
20 10 A
Left hand main beam.
Page 118 of 168
Checks
116
Bonnet Protects the components in the front compartment and provides access for checking levels, charging the 12 V ancillaries battery, changing fuses, ...
)Push the exterior safety catch Bto the left and raise the bonnet.
)
Open the bonnet fully and on the right,unclip the stay Cfrom its holder. )
Fit the stay Cin one of the two notches to
hold the bonnet open.
)Open the front right door. )Pull the interior release lever A , located at
the bottom of the door aper ture.
Opening
Closing
)Take the stay out of the support notch. )Clip the stay in its housing. )Lower the bonnet and release it at the end of its travel. )Pull on the bonnet to check that it is fully latched.
Do not press down on the middle of the bonnet if it does not fully close, as there is a risk of deforming it. Open the bonnet fully and close it again.
The location of the interior release lever prevents opening of the bonnet while the front right door is closed.
Page 157 of 168
.
Visual search
155
Electric windows 34
Dashboard fuses 108-109Ventilation 47 Heating 49-51 Air conditioning 49-51Demisting / defrosting 52
12 V accessory socket 45
Manual parking brake 54
Rear view mirror 43
Peugeot Connect USB 46
Opening the bonnet 116
Instruments and controls
Opening the charging flaps 37
Audio system 129-152
Drive selector 55-56
Page 159 of 168
.
Visual search
157
Technical data - Maintenance
Front compar tment 117 Checking levels 119-120
- ancillaries battery electrolyte
- brake fluid
- heating system fluid
- screenwash fluid Checks 121
Changing front bulbs 99 -104
Ancillaries battery 88-91
Opening the bonnet 116
Electric motor 122
Weights 123
Rear compar tment 118 Checking the coolant level 120
Front compartment fuses 110-111
Dimensions 124 Identification markings 125
