2012 Peugeot iOn key

Access
34
1. Driver's electric window.2.
Passenger's electric window.3.
Rear right electric window. 4.
Rear left electric window. 5.
Deactivating the passenger and rear electric window switches.










Electric windows


Operation

Deactivating the passenger and
rear electric window switches
)For the safety of your children, pressswitch 5
to prevent operation of the passenger and rear electric windows
irrespective of their position.
When the button is pressed down, the switches are deactivated.
When the button is raised, the switches are activated.
System which opens or closes a window manually or automatically. It is fitted with a deactivation system to prevent misuse of the rear controls.
The electric window switches remainoperational for approximately30 seconds after the ignition is switchedoff. The windows can no longer be opened or closed after the driver's door is closed. With the i
gnition on: )
Press the switch gently to open or pull it gently to close. The window stops as soonas the switch is released.


Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operationof the windows, you must reverse the movement of the window. To do this,press the switch concerned.
When the driver operates the passenger electric window switches, they mustensure that no one is preventing correct closing of the windows.
The driver must ensure that passengersuse the electric windows correctly.
Be aware of children when operating the windows.
Automatic one-touch mode
(driver's side)) Press the switch fully to open. The driver's
window opens completely when the switch is released. ) Pressing the switch again stops the
movement of the window.

2
Access
35





Doors
)After unlocking the vehicle using theremote control or the key, pull the door handle.
From inside
)
Pull the front or rear door control to open
the door.
If the doors are locked:
- opening the driver's door unlocks the other
doors,
- the front passenger or rear doors must
then be unlocked manually using the frontlocking control before they can be opened.
I
f a door or the boot is not closedcorrectly, this warning lamp comes
on in the instrument panel until the
door in question or the boot is closed.

Opening
Closin
g
Locking/ unlocking from the
inside
) Press the button on the driver's door
towards the front to lock and towards therear to unlock the vehicle completely.
The buttons on the front and rear passenger doors only lock / unlock thedoor in question.

Access
36








Boot
Opening
)After unlocking the vehicle using theremote control or the key, press the handleA
and open the tailgate.
)
Pull the handle B
downwards to guide the
tailgate down,) release the handle and press the exterior surface of the tailgate gently to close it.


Closing

4
Driving
53








Starting - stopping the vehicle
- Position 1: LOCK
The steering is locked.

- Position 2: ACC The ancillaries (radio, 12 V socket...) can be used.

- Position 3: ON Ignition on.

- Position 4: STA RT "Ready" lamp on.
Motor ready to drive the vehicle.
Ignition switch
)
Inser t the key in the ignition switch.
)
Turn the key to position 4 (START).
Starting
Stopping
)
Immobilise the vehicle.
)
Place the drive selector in position P.P)
Turn the key to position 1 (LOCK).)
Remove the key from the ignition switch. )Hold it in this position for a few seconds until the " READY"
lampcomes on accompanied by anaudible signal.
)
Release the key.
The key returns automatically to position 3 (ON).

Do not attach any heavy objects to thekey as this could weigh down on it whenin the ignition switch and cause a fault.


If you use the ancillaries for a prolongedperiod (with the key in the ACCposition), you risk discharging the ancillaries battery. Star ting your vehicle will then no longer be possible. Be aware.

Driving
56
To tow your vehicle, the drive selector must be in position N
, refer to "Practical Information".

Parking the vehicle
To stop the motor, you must select position P
. PYou must apply the parking brake to immobilise
the vehicle.
To remove the key from the ignition switch, thedrive selector must be in position P.P

5
Visibility
59
Daytime running lamps
Special daytime lighting so that the vehicle can
be seen more easily.
The daytime running lamps come on
automatically when starting the motor, if no
other lighting is on.
They cannot be deactivated.With the main li
ghting control ring in the AUTOposition, the sidelamps and dipped beamheadlamps come on automatically, without anyaction by the driver, when a low level of ambientlight is detected.
When the light returns to a sufficient level or the wipers are switched off, the lighting is switched
off automatically.The sensor is located at the base of the windscreen.
Automatic illumination of headlamps
Automatic lighting off
When the lighting stalk is in the "AUTO"position, if the ignition switch is in the "LOCK"
or "ACC" position or if the key has beenremoved, the lighting switches off automaticallywhen the driver's door is opened.
The initial setting is position "0".









Headlamp
adjustment

To avoid causing a nuisance to other road
users, the height of the halogen headlamps should be adjusted according to the load in the
vehicle.
0. Driver only or driver + 1 front passenger.
1 or 2. 4 people (including the driver).3.
4 people (including the driver) + maximumauthorised load.4.Driver + maximum authorised load.

Although these lamps are located in the same unit as the front foglamp, theyoperate with a specific bulb.
Their use is covered by road vehiclelighting regulations.

In foggy weather or in snow, thesunshine sensor may detect sufficient light. The lighting will not come onautomatically. Do not cover the sunshine sensor, the associated functions will no longer be controlled.

Child safety
70
The incorrect installation of a child seat in a vehicle compromises the child's protectionin the event of an accident. When installing a child seat using the seat belt, check that the seat belt is tightenedcorrectly on the child seat and that it secures the child seat firmly on the seat of your vehicle.
Remember to fasten the seat belts or the child seat harnesses keeping the slackinrelation to the child's body to a minimum, even for short journeys.
For optimum installation of the "for wards-facing" child seat, ensure that the back of the child seat is in contact with the backof the vehicle's seat and that the head restraint does not cause any discomfort.
If the head restraint has to be removed,ensure that it is stored or attached securelyto prevent it from being thrown around the vehicle in the event of sharp braking.
Children under the age of 10 must not travel in the "forwards-facing" position on the frontpassenger seat, unless the rear seats arealready occupied by other children, cannot be used or are absent.
Deactivate the passenger airbag *
when a"rearwards-facing" child seat is installed onthe front seat. Other wise, the child would risk being seriously injured or killed if the airbag were to inflate.

Advice on child seats
Installing a booster seat
The chest par t of the seat belt must bepositioned on the child's shoulder without
touching the neck.Ensure that the lap part of the seat beltpasses correctly over the child's thighs.PEUGEOT recommends the use of abooster seat which has a back, fitted with aseat belt guide at shoulder level.
As a safety precaution, do not leave: - one or more children alone andunsuper vised in a vehicle, - a child or an animal in a vehicle whichis exposed to the sun, with the windows closed, - the keys within reach of children inside the vehicle. To prevent accidental opening of the doors, use the "Child lock". Take care not to open the rear windows bymore than one third.To protect young children from the rays of the sun, fit side blinds on the rear windows.








Child lock

Mechanical system to prevent opening of the
rear doors using their interior controls.
The control is located on the edge of each rear door.


Child lock on
)Lower the control Ato position 1.


Child lock off
)Raise the control Ato position 2.
*
According to country and current locallegislation.

7
Safety
79

Deactivation
Only the front passenger's airbag can be deactivated:)with the ignition off, inser t the key in thefpassenger airbag deactivation switch A , )turn it to the "OFF"position, )remove the key.
This warning lamp comes on in the centreconsole when the ignition is on and until theairbag is reactivated.
To ensure the safety of your child, thepassenger airbag must be deactivatedwhen you install a "rear facing" childseat on the front passenger seat. Other wise, the child would risk beingseriously injured or killed if the airbag were deployed.


Reactivation

When you remove the child seat, turn switch Ato the "ON"position to reactivate the
airbag and so ensure the safety of your front
passenger in the event of an impact.
The associated warning lamp goes off.


Operating fault
If this warning lamp comes on in the
instrument panel, contact a PEUGEOT
dealer or a qualified workshop to have
t
he system checked. The airbags mayno longer be deployed in the event of a
serious impact.