2012 Peugeot iOn change wheel

7
Safety
71











Direction
indicators
Selection of the left or right direction indicators
to signal a change of direction of the vehicle. FLeft: lower the lighting stalk beyond the point of resistance.FRight: raise the lighting stalk beyond thepoint of resistance.








Hazard warning lamps

A visual warning by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.F
Press this button, the direction indicators flash.
They can operate with the ignition off.





Horn
Audible warning system to aler t other road
users to an imminent danger. F Press the central part of the steeringwheel.

Use the horn moderately and only in thefollowing circumstances:


- immediate danger,

- approaching a location lackingvisibility.

Practical information
96











Changing a wheel


To o l s r equired



- A jack: for lifting the vehicle.

- A wheelbrace: for removin
g and refitting
the wheel bolts.

- A handle: for operating the jack.
These tools are not supplied with your vehicle.
Parking the vehicle

Immobilise the vehicle where it does notblock traffic: the ground must be level,stable and not slippery. Apply the parking brake, switch off the ignition and put the drive selector
in position Pto lock the wheels.
If necessary, place a chock under thewheel diagonally opposite the wheel to be changed.
You must ensure that the occupants get out of the vehicle and wait where they are safe. Never go underneath a vehicle raised using a jack; use an axle stand.

Wheel with wheel trim
When removing the wheel , firstremove the wheel trim using the wheelbrace, by pulling at the valve hole.When fitting the wheel, refit the wheeltrim star ting by aligning the valve hole
with the valve, and then press on theedge of the trim with the palm of your hand.

8
Practical information
97
FSlacken the bolts using the wheelbrace.FPlace the jack in contact with one of the
two front A or rear B
locations provided on
the underbody, whichever is closest to the
wheel to be changed.

Removing the wheel
F
Using the handle, extend the jack until its base plate is in contact with the ground.
Ensure that the centreline of the jack base
plate is directly below the location A or Bused.F
Raise the vehicle until there is sufficientspace between the wheel and the ground.
F
Remove the bolts and store them in a clean place. F
Remove the wheel.

8
Practical information
103
Changing dipped beam headlamp bulbs
FTurn the bulb holder to the left and pull it out. FRemove the bulb by pressing on the
tongue.FChange the bulb.
To r efit, carry out these operations in reverse order.
Changing front foglamp bulbs / daytime running lamp bulbs
F Put the front wheels onto full lock, to facilitate access.F
Remove the clips securing the protective covers on the bulb holders.F
Move the cover aside.
F
Turn the bulb holder ( Afor the front fog
lamp, B for the daytime running lamp) to
the left and pull it out.
F Pull the bulb out and change it.
To reassemble, carry out these operations in
reverse order.