2012 Peugeot 508 RXH open bonnet

.
.
Contents
Child seats 157
ISOFIX child seats 163
Child lock 166
Child safety
Direction indicators 167
Emergency or assistance call 168
Horn 168
ESP system 169
Seat belts 172
Airbags 175
Safety
Te m p o r a ry puncture repair kit 179
Changing a wheel 185
Changing a bulb 190
Changing a fuse 197
12 V battery 201
Energy economy mode 204
Changing a wiper blade 205
Recovering the vehicle 206
Vehicle recovery 208
To w i ng a trailer 209
Fitting roof bars 211
Accessories 212
Practical information
Opening the bonnet 215
Running out of fuel (Diesel) 216
Diesel engine 217
Checking levels 218
Checks 221
Checks
Electric motor 224
Diesel engine 225
Diesel weights 226
Dimensions 227
Identifi cation markings 228
Technical data
Emergency or assistance 229
JBL equipment 231
Peugeot Connect Navigation (RT6) 233
Audio equipment and telematics
Alphabetical index
Visual search

.
43
!
Hybrid system





Underbonnet precautions/warnings

Always ensure that
the ignition is switched
off (Ready lamp off)
before opening thebonnet.
The alternator-star ter motor of your hybrid
vehicle is also supplied at high voltage. If the
vehicle ignition has not been switched off, there
is a risk of the engine restar ting at any time.
Also ensure that the ignition is switched off when refuelling to avoid the enginerestarting.

74
!
Access
System which protects and provides a deterrentagainst theft and break-ins. It provides the
following types of monitoring:






Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...


- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.

- Tilt

The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.


Self-protection function
The system checks for the putting out of ser vice of its components. The alarm is triggered if the battery,the central control unit or the wires of the siren are put out of ser vice or damaged.
For all work on the alarm system,contact a PEUGEOT dealer or aqualified workshop.


Locking the vehicle with full
alarm system


Activation
)Switch off the ignition and get out of the vehicle.
)
Press the locking button on theremote control or lock the vehicle
using the Keyless Entry and Starting system. The monitorin
g system is active: the indicator
lamp on the button flashes once per second.

After the locking button on the remote controlis pressed or the vehicle locked using the
Ke
yless Entry and Starting system, the exterior perimeter monitoring is activated after a delay
of 5 seconds, the interior volumetric monitoring
after 45 seconds and anti-tilt monitoring after 90 seconds.
If an opening (door, boot...) is not closed
fully, the vehicle is not locked but the exterior perimeter monitoring will be activated after a
delay of 45 seconds.
) Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entryand Star ting system.

Deactivation of the volumetric monitoring

The volumetric protection system is
deactivated: the indicator lamp in the
button
goes off.

8
201
i !
!
Practical information








12 V battery
Procedure for charging your battery when it is flat or for star ting the engine using another battery.
The presence of this label indicatesthe use of a 12 V lead-acid battery with special technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is required when replacing or disconnecting thebattery. Failure to observe this recommendationmay cause premature wear of thebattery.


After refitting the battery, the Stop &Start system will only be active after several hours depending on the climatic conditions and the state of charge of thebattery (up to about 8 hours).
The battery is located under the bonnet.
To gain access to it:
)
open the bonnet using the interior release
lever, then the exterior safety catch, ) remove the plastic cover to gain access to
the two terminals,) unclip the fusebox to remove the battery, if necessary.



Access to the battery


Before doing any work on your vehicle, switch off the ignition (Ready
lamp off) to avoid any risk of injury resulting fromautomatic operation of the engine. Y
our vehicle is fitted with a conventional 12 Vbattery, located under the bonnet, in addition
to the high voltage battery used by the hybridsystem.
In cer tain conditions, if the 12 V battery is
too discharged to activate the hybrid system,
recharging from another conventional 12 V
battery is possible.
Do not carry out this recharge if the Readylamp is on.

9
215
!
!
Checks
Opening the bonnet
Opening
)From inside
: pull the release lever, locatedon the left below the dashboard, towards you.
Before doing anything under the bonnet,switch off the ignition (Ready
lamp off) to avoid any risk of injury resulting fromautomatic operation of the engine.


Closing
)
Lower the bonnet and release it at the endof its travel. )
Check that it is latched correctly.


)From the outside: lift the safety catch and
raise the bonnet.
A bonnet strut opens the bonnet and holds itopen.


Never touch, handle or remove the orange "high voltage" cables.

216
i
!
!
Checks
On vehicle fitted with HDi engines, the fuelsystem must be primed if you run out of fuel; refer to the engine compar tment view on the
"Diesel engine" page.










Running out of fuel (Diesel)

If the tank on your vehicle is fitted witha misfuel prevention device, refer to the section "Access - § Misfuel prevention(Diesel)".
)
Fill the fuel tank with at least five litres of
Diesel.) Open the bonnet.)
If necessary, unclip the style cover for
access to the priming pump. ) Slacken the bleed screw. )
Squeeze and release the priming pump
repeatedly until fuel appears in the
transparent pipe.) Tighten the bleed screw.)
Operate the star ter until the engine starts(if the engine fails to star t at the first
attempt, wait around 15 seconds before
tr
ying again). ) If the engine fails to star t after a few
attempts, operate the priming pump again,
then the starter.) Put the style cover back in position and clip it in place, ensuring that it has clipped correctly. )
Close the bonnet.

2 litre HDi engine


If the engine does not star t first time, don't keep trying. Start the procedureagain from the beginning.







Before doing anything under the bonnet,switch off the ignition (Readylamp off) to avoid any risk of injury resulting from automatic operation of the engine.

.
293
Visual search
Instruments and controls
Cour tesy lamps 155 Seat belt/passenger's front airbagwarning lamps display 173, 176 Rear view mirror 94 Panoramic sunroof 82
Door mirrors 92-93Electric windows, deactivating 76 -77
Heating, ventilation 10 4 -105 Manual air conditioning 10 6 -107 Dual-zone air conditioning 108-11 0 Quad-zone air conditioning 111 -115 Demisting/defrosting 11 6

Peugeot Connect USB 97
Electric parking brake 118 -124Dashboard fuses 197-198
Electronic gear control gearbox 125 -128 Hill star t assist, creep func tion 123, 128, 129
Fuses behind the glove box 19 9

Quad-zone rear air conditioning 111 -115
Peugeot Connect Navigation(RT6) 233-286 Setting the date/time 277
Opening the bonnet 215

.
295
Visual search
Maintenance - Technical data
Identification markings 228 Dimensions 227

Running out of fuel, Diesel 216
Checking levels 218-220- oil - brake fluid - power steering fluid - coolant- screenwash/headlamp wash fluid Checking components 221-223- 12 V battery - air filter - passenger compartment filter - oil filter - electric parking brake- brake pads/discs

Changing bulbs 190 -196- front- rear


Opening the bonnet 215 Under the bonnet, Diesel 217 Electric motor, Battery 224 Diesel engine 225


12V bat tery 201-203
Load reduction, economy mode 203, 204
Engine compar tment fuses 197, 200
Diesel weights 226
High voltage cables 41, 43