Page 175 of 302
7
173
Safety
Front seat belt height adjustment
)To a djust the anchorage point, squeeze the control and slide it until you find a notch.
From approximatel
y 12 mph (20 km/h), the warning lamp(s) flash for two minutes accompanied
by an audible signal. Once these
two minutes have elapsed, the warning lamp(s)remain on until the driver or one or morepassengers fasten their seat belt.
Seat belt not fastened/unfastened warning lamps
1.Front and/or rear seat belts not fastened/unfastened warning lamp in the instrument
panel.
2. Front left seat belt warning lamp.3.
Front right seat belt warning lamp.4.
Rear right seat belt warning lamp.
5. Rear centre seat belt warning lamp. 6.
Rear left seat belt warning lamp.
Front and rear seat belt warning lamps
On switching on the ignition, warninglamp 1
comes on in the instrument panel and the corresponding warninglamp ( 2
to 6) comes on in red in the
passenger's seat belt and front airbag warninglamp display if the corresponding seat belt is
not fastened or is unfastened.
Page 177 of 302
7
175
i
!
Safety
Airbags
System designed to maximise the safety of the
occupants (with the exception of the rear centrepassenger) in the event of violent collisions.
It supplements the action of the force-limitingseat belts (with the exception of the rear centrepassenger).
If a collision occurs, the electronic detectors
record and analyse the front and side impacts sustained in the impact detection zones:
- in the case of a serious impact, the airbagsare deployed instantly and protect the
occupants of the vehicle (with the exception
of the rear centre passenger); immediatelyafter the impact, the airbags deflate rapidlyso that they do not hinder visibility or theexit of the occupants,
- in the case of a minor or rear impact or incer tain roll-over conditions, the airbags
will not be deployed; the seat belt alone is sufficient to provide optimum protection in
th
ese situations.
The airbags do not operate when the ignition is switched off.
This equipment will only deploy once.
If a second impact occurs (during thesame or a subsequent accident), the airbag will not be deployed again.
Deployment of the airbag(s) is accompanied by a slight emission of harmless smoke and a noise, due to theactivation of the pyrotechnic cartridgeincorporated in the system.This smoke is not harmful, but sensitiveindividuals may experience slight irritation.
The noise of the detonation may result in a slight loss of hearing for a shor t time.
Impact detection zones
A.
Front impact zone.B.
Side impact zone.
Front airbags
Deployment
The airbags are deployed simultaneously,
unless the passenger's front airbag is
deactivated, in the event of a serious front
impact to all or par t of the front impact zone
A,in the longitudinal centreline of the vehicle on a
horizontal plane and directed from the front to
th
e rear of the vehicle.
The front airbag inflates between the thorax
and head of the front occupant of the vehicle
and the steerin
g wheel, driver's side, and the
dashboard, passenger's side to cushion their forward movement.
System which protects the driver and front
passenger in the event of a serious front impact
in order to limit the risk of injury to the head and
thorax.
The driver's airbag is fitted in the centre of the steering wheel; the front passenger's airbag isfitted in the dashboard above the glove box.
Page 178 of 302
176
!
!
Safety
Deactivation
Only the passenger's front airbag can be deactivated: )with the ignition off, inser t the key in thefpassenger airbag deactivation switch, )turn it to the "OFF"position, )then, remove the key keeping the switch in
the new position.
Accordin
g to version, this warning lamp comes on either in the
instrument panel or in the seat belt
and passenger's front airbag warning lampdisplay when the ignition is on and until the airbag is reactivated.
To assure the safety of your child,the passenger's front airbag must be deactivated when you install a "rear facing" child seat on the front passenger seat. Other wise, the child would risk beingseriously injured or killed if the airbag were deployed.
If even one of the two airbag warning lamps comes on continuously, donot install a child seat on the frontpassenger seat.
Have it checked by a PEUGEOT dealer or qualified workshop.
Reactivation
When you remove the child seat, with the
ignitionoff , turn the switch to the f"ON"
position to reactivate the airbag and so assure
the safety of your front passenger in the event
of an impact.
With the ignition on, this warninglamp comes on in the seat belt andpassenger's front airbag warning
lamp display for approximately
one minute, if the passenger's front
airbag is activated.
Operating fault
If this warning lamp comes on in theinstrument panel, accompanied by an
audible warning and a message in the
instrument panel screen, contact a
PEUGEOT dealer or a qualified workshop to have
the system checked. The airbags may no longer
be deployed in the event of a serious impact.
If this warnin
g lamp flashes, contact
a PEUGEOT dealer or a qualified
workshop. The passenger's front
airbag may no longer be deployed in
the event of a serious impact.
Page 183 of 302
8
181
!i!
Practical information
Repair procedure
1. Sealing
)Switch off the ignition. )Turn the selector A
to the "sealant"position. )Check that the switch B
is in position "O".
)
Uncoil the white pipe G
fully. )
Unscrew the cap from the white pipe. )
Connect the white pipe to the valve of the
tyre to be repaired.
) Connect the compressor's electric plug to
the vehicle's 12 V socket. ) Star t the vehicle and leave the engine
running.
Take care, this product is harmful (e.g. ethylene-glycol, colophony...) if swallowed and causes irritation tothe eyes. Keep it out of reach of children.
Avoid removing any foreign bodieswhich have penetrated into the tyre.
Do not star t the compressor before connecting the white pipe to the tyre valve: the sealant product would beexpelled through the pipe.
Page 187 of 302
8
185
i !
Practical information
Changing a wheel
Procedure for changing a faulty wheel for the spare wheel using the tools provided with the vehicle.
The tools are located in the boot, behind the
r
ear seats.
Access to the tools
List of tools
All of these tools are specific to your vehicle andcan vary according to the level of equipment. Donot use them for other purposes.1.Wheelbrace. For removing the wheel trim and removing
the wheel bolts.
2. Jack with integral handle.
For raising the vehicle.
3."Bolt cover" tool.
For removing the bolt protectors
(covers)on alloy wheels.4.Socket for the security bolts (located in theglove box).
For adapting the wheelbrace to the special
"security" bolts.
5.One wheel chock for immobilising the
vehicle.
6. Towing eye.
See "Towing the vehicle".
Before doing any work on your vehicle,switch off the ignition (Ready
lamp off) to avoid any risk of injury resulting fromautomatic operation of the engine.
When using lifting equipment (a jackfor example), take care to use the
jacking points provided, so as to avoid damaging the high voltage cables.
Page 188 of 302
186
ii
Practical information
Wheel with trim
When refitting the wheel
, refit the trimstarting by placing its notch facing thevalve and press around its edge withthe palm of your hand.
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not block traffic: the ground must be level, stable and not slippery. Apply the parking brake unless it has
been programmed to automatic mode, switch off the ignition and put the gear lever in position A
, M
or Rto block the wheels.Check that the braking warning lampand the P
warning lamp in the parkingbrake control lever come on. The occupants must get out of thevehicle and wait where they are safe.Never go underneath a vehicle raisedusing a jack; use an axle stand.
List of operations
)Remove the bolt cover from each of
the bolts using the tool 3 (according to equipment). )Fit the security socket 4on the
wheelbrace 1to slacken the security bolt(if fitted). )Slacken the other bolts using the
wheelbrace 1only.
Page 192 of 302
190
i
!
Practical information
Changing a bulb
Front lamps
Model with xenon and directional headlamps
1.Direction indicators (light emitting diodes - LEDs).2.Directional dipped/main beam
headlamps (D1S-35W).3.Daytime running lamps/sidelamps (light
emitting diodes - LEDs).
Model with halogen headlamps
1.Dipped and main beam headlamps (H7-55W).2.Main beam headlamps (H7-55W).3.Daytime running lamps/sidelamps (light
emitting diodes - LEDs).4.Direction indicators (PY21-21W).
For H7 type bulbs with lugs... take care toobserve their correct installation so as to ensure the best lighting performance.
In some weather conditions (e.g. lowtemperature or humidity), the presenceof misting on the internal sur face of the
glass of the headlamps and rear lamps is normal; it disappears after the lampshave been on for a few minutes.
Before doing any work on your vehicle,switch off the ignition ( Ready
lamp off)to avoid any risk of injury resulting fromautomatic operation of the engine.
Page 203 of 302
8
201
i !
!
Practical information
12 V battery
Procedure for charging your battery when it is flat or for star ting the engine using another battery.
The presence of this label indicatesthe use of a 12 V lead-acid battery with special technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is required when replacing or disconnecting thebattery. Failure to observe this recommendationmay cause premature wear of thebattery.
After refitting the battery, the Stop &Start system will only be active after several hours depending on the climatic conditions and the state of charge of thebattery (up to about 8 hours).
The battery is located under the bonnet.
To gain access to it:
)
open the bonnet using the interior release
lever, then the exterior safety catch, ) remove the plastic cover to gain access to
the two terminals, ) unclip the fusebox to remove the battery, if necessary.
Access to the battery
Before doing any work on your vehicle, switch off the ignition (Ready
lamp off) to avoid any risk of injury resulting fromautomatic operation of the engine. Y
our vehicle is fitted with a conventional 12 Vbattery, located under the bonnet, in addition
to the high voltage battery used by the hybridsystem.
In cer tain conditions, if the 12 V battery is
too discharged to activate the hybrid system,
recharging from another conventional 12 V
battery is possible.
Do not carry out this recharge if the Readylamp is on.
