Page 21 of 304
.
19
Familiarisation
Driving safely
Before starting
- Place the gear lever in position N.
- Inser t the key in the ignition switch or keep
the electronic key in the vehicle.
Starting at temperatures above
zero
- Press the brake pedal.
- Make a single shor t press (about one second) on the STA R T/STOP
button or
turn the key fully towards the dashboard to
position 3(Start).
When the temperature is below zero
, you must initiate pre-heating of theDiesel engine:
- Without
putting your foot on the brake pedal, make an initial first press on the START/STOP button.
- Wait until the pre-heater warning lamp goes off.
-With
your foot on the brake pedal,make a second short press on the STA R T/STOP button. 25
- The instrument panel and the Read
ylampcome on, confirmed by an audible signal.
- The dial in the centre console is in AUTOmode.
Page 27 of 304

.
25
Hybrid system
Starting - stopping the engine
Before starting Starting at temperatures
above zero
Startin
g at temperatures
below zero
- Press the brake pedal.
- Make a single shor t press (about one second) on the STA R T/STOP
button or
turn the key fully towards the dashboard to
position 3(Starting).
- The steering column unlocks (noise and
noticeable movement).
- Keep your foot on the brake pedal until theHYbrid4 system starts up (the instrument
panel and the Readylamp come on, confirmed by an audible signal).
The hybrid system determines whether it is
necessary to star t the Diesel engine.
- Place the gear selector in position N.
- If the vehicle has Keyless Entry and Starting, simply having the key inside the
vehicle is sufficient.
- Other wise, it is necessary to place the key
in the i
gnition switch.
When the temperature is below zero, you must
initiate pre-heating of the Diesel engine:-Without putting your foot on the brakepedal , make an initial shor t press (about
one second) on the STA R T/STOP button or
turn the key fully towards the dashboard to position 3 (Starting).
- The steering column unlocks (noise and noticeable movement).
- Wait until the pre-heater warning lampgoes off.-With your foot on the brake pedal
, make
a second shor t press on the STA R T/STOP button or leave the key in position 3(Starting).
- Keep your foot on the brake pedal until the HYbrid4 system starts up (the Ready
lampcomes on, confirmed by an audible signal)and the Diesel engine starts.
Page 29 of 304

.
27
Hybrid system
the engine
(accessory position)
Anti-theft protection
Electronic engine immobiliser
The keys contain an electronic chip which hasa secret code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible.
This electronic engine immobiliser locks the
en
gine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
In the event of a malfunction, you are informed by a message in the instrument panel screen.In this case, your vehicle does not start; contacta PEUGEOT dealer as soon as possible.
Turn the key towards the dashboard to the
intermediate position or with the Keyless Entry
and
Starting key inside the vehicle, press the
"START/STOP" button, with no action on the pedal. This switches on the ignition and so
activates the ancillary equipment.
)Press the "STA R T/STOP" button,
the instrument panel comes on
but the en
gine does not star t. )Press the button again to switch
off the ignition and so allow the
vehicle to be locked.
If you use the accessories positionfor too long, the system automaticallychanges to economy mode to avoid discharging the battery.
Page 52 of 304

50
Instruments and controls
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.This is may be accompanied by an audible signal and a message in the instrument panel screen.
Warning / indicator lampStateCauseAction / Observations
Passenger's airbag systemfixed in the instrumentpanel and/or seat beltand front passenger's airbag warning lamps
display.
The control switch, located in the glove box, is set to the OFF
position.
The passenger's front airbag is deactivated.
Set the control to the "ON"
position to activate the passenger's front airbag.
In this case, do not fit a child seat in the rear-facing position.
DSC/ASR(ESP)fixed. The button (located on the foldingpanel at the bottom right of the
dashboard) has been pressed. Its
indicator lamp is on.
The DSC/ASR is deactivated.
DSC: d
ynamic stability control.
ASR: anti-slip regulation.Pr
ess the button to activate the DSC/ASR. Its indicator
lamp goes off.
The DSC/ASR system is activated automatically when
the vehicle is started.
After deactivation, the system is reactivated
automatically from approximately 30 mph (50 km/h).
Page 109 of 304