Page 66 of 340
64
Comfort
Front seats
1.Adjustments to the height and angle of
t
he head restraint
To raise it, pull upwards.
To lower it, hold the button in and press on
the head restraint
(pushing to go past the
stiff point of the button
).
2.Adjustment of the backrest angle
Operate the control lever and adjust the
position of the backrest to the front or to
th
e rear.
3.Adjustment of the seat height
Raise or lower the control lever the number
of times required to obtain the desired
position.
4.Adjustment of the lumbar support
This system allows the height and depth
o
f the lumbar suppor t to be adjusted
separatel
y.
)Forwards or backwards to increase or
decrease the lumbar support.
)Upwards or downwards to raise or lower
th
e lumbar contact zone.
5.Forwards-backwards adjustment of the
seat
position
Lift th
e control bar and slide the seat
forwards or backwards.
6. Ad
justing the cushion
Pull the handle to adjust the length of
th
e cushion.
Page 82 of 340

80
!
i
Comfort
Warning triangle (stowing)
Before leaving your vehicle to set upand install the triangle, put on your high visibility vest.
The dimensions o
f the triangle (once folded) or its storage box must be:- A: length = 438mm,-
B: height = 56
mm,
- C: width = 38mm.
To use the triangle, refer to the manufacturer's
instructions.
Saloon
)
Press the lug 1
and pull the assembly
towards you.
SW
)
Turn the knob 2to remove the cover. )
Hold the cover and the triangle so that they do not fall.
The location for a folded trian
gle is in the inner
trim panel of the boot lid. Placing the triangle in
t
he road
Distance from your vehicle (in metres)
Road
Motorway
DayNight
50 m 80 m
150 m
These are the internationally recognisedvalues.
Use the triangle in line with local driving regulations.
The trian
gle is available as an accessory, contact a PEUGEOT dealer or a qualified
workshop.
)Place the triangle at a distance behind
t
he vehicle, as shown in the table below, according to the type of road and the level
of ambient light.
Page 83 of 340
3
81
i
Comfort
High load retaining net
Hooked onto the special upper and lower fixings, this allows the use of the entire loading
volume up to the roof:
- behind the front seats (row 1) when the rear seats are folded.
- behind the rear seats (row 2).
Never reposition the rear seats if thenet's roller is attached to the backs of the folded seats. )
position the net's roller above the two rails (located on the back of the folded rear seats), )
the two grooves Amust be placed above
the two rails B
. Slide the two rails B
in thegrooves Aand push the roller (lengthwise)from right to left to secure it,
)
check that the net is hooked and tightened correctly,
)
fold the rear seats, )
unroll the high load retaining net without stretching it, )
position one of the ends of the net's metal
bar in the corresponding upper fixing 1, ) pull the net's metal bar to position the other end in the other upper fixing 1.
Row 1
(SW)
Page 133 of 340